“阳”加速器钼丝X-pinch初步实验研究

 在“阳”加速器上进行了直径分别为10, 15, 20 μm, 交叉角为32°,45°,60°的钼（Mo）丝X-pinch实验。“阳”加速器产生的电流峰值约520 kA，上升时间80 ns。实验中通过X射线功率谱仪和纳秒分幅相机等仪器对Mo丝X-pinch辐射特性进行了诊断。实验表明：Mo丝X-pinch过程中会出现多次X射线爆发，箍缩过程中产生的热点辐射出能量超过3 keV的X射线，探测到的最小热点直径小于30 μm。     

不同方法制备的CO2-3替换磷灰石固溶体晶体化学的FTIR研究

采用不同方法制备了CO2-3替换的磷灰石固溶体,利用FTIR结合XRD对其进行了晶体化学研究,结果表明均相沉淀法制备的碳羟磷灰石(CHAP)属B型替换且替换方式是[CO3·OH]四面体替换[PO4]四面体;固相离子交换法制备的CHAP属A型替换且替换方式是[CO3]三角形配位体替换通道位置的OH-;固相反应法制备的碳氟磷灰石(CFAP)属B型替换,其替换方式是[CO3·F]四面体替换[PO4]四面体;sol-gel法制备的CHAP属AB混合型替换,其Ψ3分裂为Ψ3-1,Ψ3F,Ψ3-4.高斯函数法拟合表明Ψ3F峰是A型替换的Ψ3-2与B型替换的Ψ3-3的叠合.当WCO2-3＜3.34%时,随CO2-3含量增加,A型替换量增大,且当WCO2-3=3.34%时达最大值,当3.34%＜WCO2-3＜7.52%时,随CO2-3含量增加,B型替换量增大,且当WCO2-3= 7.52%时亦到饱和.     

金刚石窗口冷却Yb3+∶YAG DPSSL设计

针对高功率二极管重复率抽运的V型非稳腔Yb3+∶YAG激光头，提出了利用金刚石窗口冷却和直接水冷相结合的复合冷却设计.在YAG片的抽运面进行直接水冷，同时在激光提取面利用金刚石窗口冷却介质.金刚石优异的导热性能不仅能够有效地冷却激光介质，还能消除横向的温度梯度，解决了高功率激光器冷却和高功率抽运的矛盾.模拟结果表明对掺杂10 at %厚度为1.6 mm的Yb3+∶YAG片在抽运功率密度为20 kW/cm2，重复频率为10 Hz的条件下，要将最高温度控制在可接受的范围内（比如320 K），周围冷却水的对流换热系数约为4000 W/m2K.     

无催化纳米氧化锌的制备及其光学性质研究

本文采用无催化剂直接蒸发高纯Zn粉,在800℃氧气氛条件下,在Si(111)衬底上生长得到以四角状为主的纳米ZnO(T-ZnO)。T-ZnO纳米线每个角约互成110°,长度约为1.5μm,直径100nm左右;Raman分析表明E2(H)普遍存在于各形态的ZnO;光致发光光谱表明,T-ZnO纳米线的光致发光除了与材料性质有关,还与杂质缺陷有关,蓝绿光带是ZnO的缺陷产生的。     

输入输出共轴的三弯曲型TM01-TE11模式转换器

 通过采用相位重匹配技术，设计了一种输入输出共轴的三弯曲型TM₀₁-TE₁₁模式转换器，该转换器由三段常曲率弯曲波导和两段直波导组成。用模式耦合理论建立了该类模式转换器的数值计算和优化设计方法，并设计了一个中心频率为7.0 GHz的模式转换器。该转换器的TM₀₁-TE₁₁转换效率在中心频率上大于99％，在6.5~7.5 GHz的频率范围内大于90％。应用时域有限差分法和有限元方法对所设计的模式转换器进行了仿真，仿真结果验证了设计理论和设计结果。     

Electrophysical properties of nanocomposites based on poly(p-xylylene) and copper nanoparticles

Poly(p-xylylene)-based nanocomposites containing various amounts of copper have been prepared by vacuum codeposition on a cooled substrate. On the basis of the relationship between the electrical conductivity of composites and the volume content of copper, the percolation threshold has been estimated as 10%. This value coincides with the corresponding parameter derived from the concentration dependence of the electrical resistance temperature coefficient. It has been shown that the conductivity of the nanocomposites increases with the moisture content and their moisture sensitivity decreases with an increase in the content of copper from a concentration of 4%. An analysis of the kinetics of the sensor response measured for various moisture contents has shown that the capacity structure of the samples rearranges during adsorption of water. According to the advanced model, the value of the sensor response is determined by a reduction in the height of the potential barrier between nanoparticles and a change in the fractal characteristics of nanocomposites that results from the adsorption of water molecules.     

On-line learning delivery decision support system for highlyproduct mixed semiconductor foundry

A production learning system (PLS) based on the tool model was constructed as a decision support and real-time information update system to forecast the cycle time. A tool model includes a waiting model and a processing model. Each of the waiting and processing models uses a backpropagation neural network to establish the relationship between the input and output (time) of the model. Hence, cycle time estimation, tool group move and confirm line item performance (CLIP) value can be obtained based on the memory stored in the neural network. The result shows that the forecasting ability of the PLS has an error rate below 8% on average     

Monitoring the Aggregation of Dansyl Chloride in Acetone through Fluorescence Measurements

The aggregation of dansyl chloride (DNS-Cl) in acetone has been studied in detail by steady-state fluorescence techniques.It has been demonstrated that DNS-Cl is stable in acetone during purification and aggregation study processes.The aggregates are not solvolyzed in acetone,and do not take part n any chemical reactions either.It has been found that DNS-Cl tends to aggregate even when its concentration is much lower than its solubility in acetone.The aggregation is reversible,and both the aggregation and the deaggregation are very slow processes.Introduction of SDS has a positive effect upon the formation and stabilization of the aggregates.     

Polarization experiments with the SPIN setup at the ITEP synchrotron

New experimental data on the spin-rotation parameters A and R measured for elastic π ^± p scattering in the resonance region and on the asymmetry in pC scattering at primary momenta in the range 1.35–2.02 GeV/c, as well as in quasielastic proton scattering on nuclei in the same momentum range, are summarized. All these data were recently obtained by using the proton synchrotron installed at the Institute of Theoretical and Experimental Physics (ITEP, Moscow). The spectrum and features of seven isospin-3/2 baryon resonances that form a peak in the total cross section at a c.m. energy of 1.9 GeV are analyzed on the basis of new data on the parameters A and R, and the results of this analysis are presented. The experiments surveyed in this article were performed by a collaboration of researchers from ITEP and the Petersburg Nuclear Physics Institute (PNPI, Gatchina), the ITEP-PNPI collaboration.