Synthesis and Characterization of ZnO Nanoflowers Grown on AlN Films by Solution Deposition

ZnO nanoflowers are synthesized on AlN films by solution method. The synthesized nanoflowers are composed of nanorods, which are pyramidal and grow from a central point, thus forming structures that are flower-shaped as a whole. The nanoflowers have two typical morphologies： plate-like and bush-like. The XRD spectrum corresponds to the side planes of the ZnO nanorods made up of the nanoflowers. The micro-Raman spectrum of the ZnO nanoflowers exhibits the E2 （high） mode and the second order multiple-phonon mode. The photoluminescence spectrum of the ZnO nanoflowers exhibits ultraviolet emission centred at 375nm and a broad green emission centred at 526 nm.     

Efficient Laser-Diode End-Pumped Passively Q-Switched Mode-Locked Yb：LYSO Laser Based on SESAM

We report an efficient Q-switched laser action based on a semiconductor saturable absorber mirrors （SESAMs） as passively Q-switched laser starter and a Yb：LYSO alloyed crystal as gain material pumped directly by 974nm InGaAs laser diodes. The output pulse duration is measured to be about 7μs, while the average power and the repetition rate of the pulse chain are about 0.92 W and 6.2 kHz, respectively, under 12.5 W absorbed pumping power. The Q-switched mode-locked pulse train is also observed in this setup. The laser performance shows that Yb：LYSO is a promising laser gain medium for laser-diode pumped compact solid-state lasers.     

B→K Transition Form Factor with Tensor Current within the kT Factorization Approach

We apply the kT factorization approach to deal with the B→K transition form factor with tensor current in the large recoil regions. Main uncertainties for the estimation are discussed and we obtain FT^B→K （0） = 0.25±0.01±0.02, where the first error is caused by the uncertainties from the pionic wavefunctions and the second is from that of the B-meson wavefunctions. This result is consistent with the light-cone sum rule results obtained in the literature.     

An Accurate Image Simulation Method for High-Order Laue Zone Effects

A completely different formulation for simulation of the high order Laue zone （HOLZ） diffractions is derived. It refers to the new method, i.e. the Taylor series （TS） method. To check the validity and accuracy of the TS method, we take polyvinglidene fluoride （PVDF） crystal as an example to calculate the exit wavefunction by the conventional multi-slice （CMS） method and the TS method. The calculated results show that the TS method is much more accurate than the CMS method and is independent of the slice thicknesses. Moreover, the pure first order Lane zone wavefunction by the TS method can reflect the major potential distribution of the first reciprocal plane.     

激光点火系统温度效应及其控制技术的研究

激光点火系统应用于武器系统必须符合高低温性能的要求。研究了激光点火系统的高低温特性,得到了激光二极管阈值电流和输出光功率随温度变化的规律。基于对规律的分析,研制了带温控技术的激光点火系统。该系统以单片机为控制部件,以TEC为温控部件,以负温度系数热敏电阻为测温元件。     

激光二极管点火系统研究进展

综述了激光点火方式、激光二极管点火系统的组成及最新发展。提出了一种激光二极管点火系统结构,描述了各部分的关键技术。介绍了国外在光回路检测、保险与解保险及多路点火方面的研究成果,以及国内在温度控制、光纤芯径对点火阈值功率的影响和激光点火器设计的研究成果。指出了当前激光点火技术在武器装备中的应用和现阶段激光点火遇到的技术难点。     

10μm级聚酯薄膜介质电临界击穿场强初步研究(英文)

分析了聚酯薄膜电击穿可能的模型,如本征击穿模型和电一机械击穿模型,估算了两种模型下常用聚合物介质的临界击穿场强。实验研究了平板电极结构下10μm级聚酯薄膜的自击穿电压,得出了聚酯薄膜的临界击穿场强450-500kV／mm。实验结果与理论计算值比较表明：本征击穿模型下的聚酯薄膜临界击穿场强都远小于实验结果,电～机械击穿模型下聚酯薄膜临界击穿场强大于实验结果。     

壳聚糖与甲基橙探针试剂的相互作用

以吸收光谱法研究了在pH=2.0.壳聚糖(CTS)与甲基橙(MO)的相互作用机理.结果表明,CTS与光谱探针MO主要是通过静电作用形成CTS-MO复合物,考察了MO/CTS摩尔比对反应体系的影响,实验测得CTS与MO的最大结合数NE为6.17×103,理论模型预测最大结合数Nc为6.13×103,实验值与理论值一致,验证了壳聚糖与光谱探针试剂相互作用的理论模型的合理性.     

Study on the Interaction and Properties of Cucurbit[8]uril with Oroxin B

The interaction between cucurbit[8]uril(Q[8]) and oroxin B(ORB) was investigated by UV-visible(UV-Vis) spectroscopy, isothermal titration calorimetry(ITC), mass spectrum(MS) and nuclear magnetic resonance(NMR) spectroscopy. The results showed that ORB formed a 2:1 inclusion complex with Q[8] with a binding constant of 8.266×10⁵ L²·mol^-2. ORB had good scavenging ability for 2,2'-azinobis-(3-ethylbenzthiazoline-6-sulphonate)(ABTS) free radicals(IC₅₀=5.74 μmol/L) and the addition of Q[8] did not significantly affect the antioxidant activity of ORB(IC₅₀=5.76 μmol/L). A phase solubility experiment revealed a 1.86-fold increase in the solubility of ORB when c(Q[8])=100 μmol/L. In vitro drug release experiments showed that the release rate for ORB@Q[8] complex was lower than that of ORB in artificial intestinal juice, and higher than that of ORB in artificial gastric juice.     

一种基于LTCC基板的数字光收发模块设计

首先介绍低温共烧陶瓷(LTCC)技术和数字光收发模块,阐述LTCC的技术特点、工艺流程以及它相较于传统PCB电路基板的优势,解释了数字光收发模块的通信原理和工作方式;其次,提出了一种基于LTCC电路基板的数字光收发模块的设计方案,详细介绍了该光模块的主要构成和实现方法,包括电路设计和关键器件的比较和选取;最后,通过对该方案所述的数字光收发模块的样件进行关键指标和性能测试,验证了该设计方案的可行性。