单小区模型的掉话率分析

掉话率是无线通信网络中最重要的关键性能指标(KPI)之一,本文分析了中国移动在讨论网络性能评估方法时提出的3个不同的掉话率计算公式,通过建立一个单小区的模型,使用一些合理的假设和分析,从理论上确定了一个最为准确的计算公式.     

A time-based energy-efficient analog-to-digital converter

Dual-slope converters use time to perform analog-to-digital conversion but require 2/sup N+1/ clock cycles to achieve N bits of precision. We describe a novel current-mode algorithm that also uses time to perform analog-to-digital conversion but requires 5N clock cycles to achieve N bits of precision via a successive subranging technique. The algorithm requires one asynchronous comparator, two capacitors, one current source, and a state machine. Amplification of two is achieved without the use of an explicit amplifier by simply doing things twice in time. The use of alternating voltage-to-time and time-to-voltage conversions provides natural error cancellation of comparator offset and delay, 1/f noise, and switching charge-injection. The use of few components and an efficient mechanism for amplification and error cancellation allow for energy-efficient operation: in a 0.35-/spl mu/m implementation, we were able to achieve 12 bit of DNL limited precision or 11 bit of thermal noise-limited precision at a sampling frequency of 31.25 kHz with 75 /spl mu/W of total analog and digital power consumption. These numbers yield a thermal noise-limited energy efficiency of 1.17 pJ per quantization level, making it one of the most energy-efficient converters to date in the 10-12 bit precision range.     

A four-channel 3.125-Gb/s/ch CMOS serial-link transceiver with a mixed-mode adaptive equalizer

This work presents a quad-channel serial-link transceiver providing a maximum full duplex raw data rate of 12.5Gb/s for a single 10-Gbit eXtended Attachment Unit Interface (XAUI) in a standard 0.18-/spl mu/m CMOS technology. To achieve low bit-error rate (BER) and high-speed operation, a mixed-mode least-mean-square (LMS) adaptive equalizer and a low-jitter delay-immune clock data recovery (CDR) circuit are used. The transceiver achieves BER lower than <4.5/spl times/10/sup -15/ while its transmitted data and recovered clock have a low jitter of 46 and 64 ps in peak-to-peak, respectively. The chip consumes 178 mW per each channel at 3.125-Gb/s/ch full duplex (TX/RX simultaneous) data rate from 1.8-V power supply.     

Bio-Plasmonics: Nano/micro Structure of Surface Plasmon Resonance Devices for Biomedicine

We have reported a novel design of surface plasmon resonance (SPR) device, which uses alternating dielectric layers to enhance the SPR signal quality and modulate its resonant position. Admittance loci method of thin film design has been used in the design of such a device. The use of biomolecular thin film, such as DNAs or Porteins, in this design can result in resonant condition of wavelength changes as well. Bio-plasmonics is proposed for the research and development of novel devices, which use biomolecules as a part of the plasmon oscillation system to actively interact with nano/micro structure.     

BRD96N光调制吸收增强现象的实验研究

通过光谱响应特性实验和记录／读出图像实验，研究了基因变异型细菌视紫红质（BR_D96N）分子膜对单色光的光调制特性.发现BR_D96N分子膜在550nm—600nm范围内对调制光有吸收增强的现象，且对此范围内不同波长的单色光其调制程度有差异.利用曲线拟和方法发现550nm—600nm吸收增强的变化过程分为快过程和慢过程，其对应的时间常数分别为30s和5min.利用强度调制器的吸收强度与图像灰度之间的关系，分析了560nm—600nm范围内出现图像反转的实验现象. 关键词： 细菌视紫红质D96N分子膜 光谱响应 吸收增强现象 图像反转现象     

涡旋柔性弹簧及组件性能实验研究

本文利用TSL系列弹簧刚度实验仪对用于斯特林制冷机中的单片柔性弹簧及柔性弹簧组件进行了实验研究。测试了四种不同尺寸弹簧刚度的动态特性,研究了单片弹簧的轴向刚度、径向刚度以及力矩特性,然后对柔性弹簧组件进行了实验研究,指出了不同组合方法下的刚度及弯矩特性,得到的数据可以作为斯特林制冷机设计的参考。     

A complete boundary integral formulation for compressible Navier–Stokes equations

A complete boundary integral formulation for compressible Navier–Stokes equations with time discretization by operator splitting is developed using the fundamental solutions of the Helmholtz operator equation with different order. The numerical results for wall pressure and wall skin friction of two‐dimensional compressible laminar viscous flow around airfoils are in good agreement with field numerical methods. Copyright © 2004 John Wiley & Sons, Ltd.     

Coordinating Agents in Shop Floor Environments From a Dynamic Systems Perspective

In this paper, we address agent coordination from a dynamic systems perspective and propose a dynamic coordination model, which is inspired by biological metabolic systems. A new coordination mechanism through dynamic local adjustment (CDLA) is presented, and coordination is achieved when every agent utilizes explicitly the global system dynamics and performs iteratively a dynamic local adjustment procedure. The CDLA mechanism is investigated in an example multiagent shop floor system. The results show that the example manufacturing process is well-coordinated and the coordination approach is practically applicable and effective     

3D FDTD Implementation for Scattering of Electric Anisotropic Dispersive Medium Using Recursive Convolution Method

The finite-difference time-domain method based on recursive convoltion method (RC-FDTD) for the electric anisotropic dispersive medium is discussed in detail. To exemplify the availability of the three-dimensional RC-FDTD algorithm, the backscattering Radar-Cross-Section(RCS) of a non-magnetized plasma sphere is computed, and the numerical results are the same as the one of the Shift Operater-FDTD method, and show that the RC-FDTD method is correct and efficient. In addition, the co-polarized and cross-polarized backscattering time-domain of a magnetized plasma sphere are obtained by the RC-FDTD algorithm. The results show that when the external magnetic field is implemented, the cross-polarized component appear, evidently.