Dynamic Survivability in WDM Mesh Networks Under Dynamic Traffic

Network survivability is a crucial requirement in WDM mesh networks. In this paper, we systematically consider the problem of dynamic survivability with dynamic single link failure in WDM networks under dynamic traffic demands. Specifically, we investigate various protection schemes, such as dedicated path protection (DPP), shared path protection (SPP), dedicated link protection (DLP), shared link protection (SLP), and two restoration schemes, path restoration (PR) and link restoration (LR). Moreover, two new shared protection methods are proposed, i.e., SRLG-based shared link protection (SRLG-SLP) and SRLG-based shared path protection (SRLG-SPP). The SRLG (shared risk link group) constraint defines the availability of protection resources to a working path, which requires that any two working paths sharing the same risk of failure (or in the same SRLG) cannot share the same protection resources. Furthermore, in our study, we consider a more practical dynamic single-link failure model, in which the link-failure-interarrival time and link-failure-holding time are considered as two independent parameters. Based on this link-failure model, extensive simulations are done to analyze and compare the dynamic survivable performance of various protection and restoration schemes. Resource utilization, protection efficiency, restoration efficiency, and service disruption ratio are employed as survivable performance metrics versus traffic load, link-failure frequency, and link-failure reparation time to evaluate the survivable performance. Many meaningful results are given. In addition, we show that the developed SRLG-SLP and SRLG-SPP protection schemes perform very well in terms of protection efficiency and service disruption ratio, while sacrificing some performance in terms of resource utilization.     

One convenient synthesis route to boron nitride nanotube

We describe one convenient synthesis route to boron nitride (BN) nanotube by the reaction of boron powder, iron oxide, and ammonium chloride at 600 °C for 12 h. Characterized by XRD, FTIR, XPS, TEM and SAED, the composition and morphology of the products are confirmed. The possible reaction mechanism is also discussed.     

带相变的铸坯热弹塑性应力分析基本方程

本文讨论了温度、相变、应力间的耦合关系，给出了铸坯在考虑相变时的热弹塑性蠕变的本构关系，以及计算铸坯内应力的有限元迭代公式。     

综合布线系统的设计、施工及测试

针对综合布线系统工程设计与施工中存在的问题作一简单的归纳，并提出相应的解决办法。其中解决的办法包括几点重要的内容：设计时注意用户的需求和系统的可扩展性，施工时严格按照规范施工，工程结束后要做出详细的测试方案。接地问题和线缆敷设管路的弯曲问题是在施工时很重要的。测试时应测试的内容有：远端串扰、近端串扰、综合近端串扰、结构回波损耗等。     

Analysis of Paeoniae Radix by high-performance liquid chromatography-electrospray ionization-mass spectrometry.

A method has been developed for the qualitative analysis of paeonol, paeoniflorin and their derivatives in Paeoniae Radix by high-performance liquid chromatography-electrospray ionization-mass spectrometry (HPLC-ESI-MS). Gradient elution with acetonitrile-water solvent system was employed in an HPLC-ESI-MS study. The negative-ion ESI mode was suitable for these compounds. The peaks were identified by their mass spectra, UV spectra and fragments of their MS2 spectra. The structures of three unknown compounds are inferred in this paper.     

Influence of Turbid Medium Parameters on Back Scattered Intensity and Pulsewidth of Picosecond Pulse

In this paper, we simulate a practical in vivo technique in which is produced influence of turbid medium parameters on backscattered intensity and pulsewidth of picosecond for turbid tissue surface of a semiinfinite medium by a small narrow linewidth laser beams. It is shown that the interaction of the ultra short pulse and the turbid tissue is very used as researching the optical parameters of the turbid medium.     

Formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber blends: Effects of preparation method,composition, and thermal condition

The effects of preparation method, composition, and thermal condition on formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber (iPP/EPR) blends were studied using modulated differential scanning calorimeter (MDSC), wide angle X‐ray diffraction (WAXD), and phase contrast microscopy (PCM). It was found that the α‐iPP and β‐iPP can simultaneity form in the melt‐blended samples, whereas only α‐iPP exists in the solution‐blended samples. The results show that the formation of β‐iPP in the melt‐blended samples is related to the crystallization temperature and the β‐iPP generally diminishes and finally vanishes when the crystallization temperature moves far from 125 °C. The phenomena that the lower critical temperature of β‐iPP in iPP/EPR obviously increases to 114 °C and the upper critical temperature decreases to 134 °C indicate the narrowing of temperature interval, facilitating the formation of β‐iPP in iPP/EPR. Furthermore, it was found that the amount of β‐iPP in melt‐blended iPP/EPR samples is dependent on the composition and the maximum amount of β‐iPP formed when the composition of iPP/EPR blends is 85:15 in weight. The results through examining the effect of annealing for iPP/EPR samples at melt state indicate that this annealing may eliminate the susceptibility to β‐crystallization of iPP. However, only α‐iPP can be observed in solution‐blended samples subjected to annealing for different time. The PCM images demonstrate that an obvious phase‐separation happens in both melt‐blended and solution‐blended iPP/EPR samples, implying that compared with the disperse degree of EPR in iPP, the preparation method plays a dominant role in formation of β‐iPP. It is suggested that the origin of formation of β‐iPP results from the thermomechanical history of the EPR component in iPP/EPR. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1704–1712, 2007     

Dual band-notched ultra-wideband microstrip antenna using asymmetrical spurlines

A simple and novel ultra-wideband microstrip-fed antenna with dual band-notched characteristic is presented. By etching a pair of asymmetrical spurlines on the feedline, two notched bands of 600 MHz (3.95? 4.55 GHz) and 650 MHz (5.35?6.0 GHz) are achieved. Measured results show that this antenna operates from 2.5 to 12.0 GHz for voltage standing wave ratio less than 2, except two frequency notched bands of 3.95?4.55 GHz and 5.35?6.0 GHz. Moreover, this antenna has good omnidirectional radiation patterns in the H-plane.     

Noncollinear optical parametric amplification in lithium triborate seeded by a cw Ti:sapphire laser

Experimental investigations of a type-I noncollinear phase-matched optical parametric amplification based on lithium triborate, which was pumped by a 5-ns second-harmonic pulses from a Q-switched Nd:YAG, seeded by a cw Ti:sapphire laser at 800 nm, was presented. The experiments generated 2-ns signal output pulses at 800 nm, the maximum signal output pulse energy reached 19 μJ, the corresponding parametric gain was 44 dB. Furthermore, the experiments demonstrate that the 65 nm-FWHM parametric fluorescence gain spectrum could also be observed. A quantitative account of the ultrabroadband parametric fluorescence gain spectrum was given with our theory. The experimental measurements are in agreement with theoretical calculations.     

Simulation of polarization effects in AlGaN/GaN heterojunction

Because of their large band-gap, large high-field electron velocity, large breakdownfield, and large thermal conductivity, GaN and its heterojunction with AlGaN and InGaNhave foreseeable potential in the applications of high-power/temperature electronics, andoptoelectronic devices operative in UV and visible wavelength. Polarization inducedelectric field can reach the magnitude of ~MV/cm[1,2]. For AlGaN/GaN based FETs theconcentration of sheet carrier induced by polarization in the cha…