The effect of ITO films thickness on the properties of flexible organic light emitting diode

Indium tin oxide (ITO) thin films were deposited on cyclic olefin copolymer substrate at room temperature by an inverse target sputtering system. The crystal structure and the surface morphology of the deposited ITO films were examined by X-ray diffraction and atomic force microscopy, separately. The electrical properties of the conductive films were explored by four-point probing. Visible spectrometer was used to measure the optical properties of ITO-coated films. The performance of the flexible organic light emitting diode device with different thickness anode was investigated in this study.     

宽带抽运情况下乙醇、丙酮溶液中受激拉曼散射光谱的实验研究

研究了乙醇、丙酮两种拉曼介质在宽带抽运情况下啁啾激光脉冲的受激拉曼散射频谱特性 ,得到的一级Stokes光频谱宽度与抽运光基本相当 ,且具有较高的转换效率 ,从而表明了利用“展宽—受激拉曼散射—压缩”的办法获得波长近 1μm的飞秒级超短脉冲激光信号源的实验方案具有可行性     

不同方法制备的CO2-3替换磷灰石固溶体晶体化学的FTIR研究

采用不同方法制备了CO2-3替换的磷灰石固溶体,利用FTIR结合XRD对其进行了晶体化学研究,结果表明均相沉淀法制备的碳羟磷灰石(CHAP)属B型替换且替换方式是[CO3·OH]四面体替换[PO4]四面体;固相离子交换法制备的CHAP属A型替换且替换方式是[CO3]三角形配位体替换通道位置的OH-;固相反应法制备的碳氟磷灰石(CFAP)属B型替换,其替换方式是[CO3·F]四面体替换[PO4]四面体;sol-gel法制备的CHAP属AB混合型替换,其Ψ3分裂为Ψ3-1,Ψ3F,Ψ3-4.高斯函数法拟合表明Ψ3F峰是A型替换的Ψ3-2与B型替换的Ψ3-3的叠合.当WCO2-3＜3.34%时,随CO2-3含量增加,A型替换量增大,且当WCO2-3=3.34%时达最大值,当3.34%＜WCO2-3＜7.52%时,随CO2-3含量增加,B型替换量增大,且当WCO2-3= 7.52%时亦到饱和.     

金刚石窗口冷却Yb3+∶YAG DPSSL设计

针对高功率二极管重复率抽运的V型非稳腔Yb3+∶YAG激光头，提出了利用金刚石窗口冷却和直接水冷相结合的复合冷却设计.在YAG片的抽运面进行直接水冷，同时在激光提取面利用金刚石窗口冷却介质.金刚石优异的导热性能不仅能够有效地冷却激光介质，还能消除横向的温度梯度，解决了高功率激光器冷却和高功率抽运的矛盾.模拟结果表明对掺杂10 at %厚度为1.6 mm的Yb3+∶YAG片在抽运功率密度为20 kW/cm2，重复频率为10 Hz的条件下，要将最高温度控制在可接受的范围内（比如320 K），周围冷却水的对流换热系数约为4000 W/m2K.     

微型热驱动热声热机热端换热器的优化设计

该文基于热声环境,采用厘米级扁管和deltaE数值计算对微型热声换热器进行了优化设计。     

Electrophysical properties of nanocomposites based on poly(p-xylylene) and copper nanoparticles

Poly(p-xylylene)-based nanocomposites containing various amounts of copper have been prepared by vacuum codeposition on a cooled substrate. On the basis of the relationship between the electrical conductivity of composites and the volume content of copper, the percolation threshold has been estimated as 10%. This value coincides with the corresponding parameter derived from the concentration dependence of the electrical resistance temperature coefficient. It has been shown that the conductivity of the nanocomposites increases with the moisture content and their moisture sensitivity decreases with an increase in the content of copper from a concentration of 4%. An analysis of the kinetics of the sensor response measured for various moisture contents has shown that the capacity structure of the samples rearranges during adsorption of water. According to the advanced model, the value of the sensor response is determined by a reduction in the height of the potential barrier between nanoparticles and a change in the fractal characteristics of nanocomposites that results from the adsorption of water molecules.     

On-line learning delivery decision support system for highlyproduct mixed semiconductor foundry

A production learning system (PLS) based on the tool model was constructed as a decision support and real-time information update system to forecast the cycle time. A tool model includes a waiting model and a processing model. Each of the waiting and processing models uses a backpropagation neural network to establish the relationship between the input and output (time) of the model. Hence, cycle time estimation, tool group move and confirm line item performance (CLIP) value can be obtained based on the memory stored in the neural network. The result shows that the forecasting ability of the PLS has an error rate below 8% on average     

Monitoring the Aggregation of Dansyl Chloride in Acetone through Fluorescence Measurements

The aggregation of dansyl chloride (DNS-Cl) in acetone has been studied in detail by steady-state fluorescence techniques.It has been demonstrated that DNS-Cl is stable in acetone during purification and aggregation study processes.The aggregates are not solvolyzed in acetone,and do not take part n any chemical reactions either.It has been found that DNS-Cl tends to aggregate even when its concentration is much lower than its solubility in acetone.The aggregation is reversible,and both the aggregation and the deaggregation are very slow processes.Introduction of SDS has a positive effect upon the formation and stabilization of the aggregates.