低掺杂浓度Nd:YVO4激光器的输出特性研究

在对Nd:YVO_4晶体的掺杂浓度和晶体长度对激光器性能的影响进行了分析后,报道了利用掺杂浓度为0.3at％,通光长度为10mm的Nd:YVO_4晶体作为增益介质,带光纤耦合的激光二极管端面抽运的Nd:YVO_4激光器。在抽运功率为27.365W时,获得了14.85W的TEM_(00)模输出,光一光转换效率为60.49％,斜效率达64.5％。     

High‐Performance,Monolithic Polyaniline Electrochemical Actuators

New polyaniline (PANI) asymmetric membranes were fabricated using a phase‐inversion technique with hexane as the coagulation bath. These membranes exhibit a dense structure with macrovoids distributed asymmetrically throughout the cross‐section. A stress–strain study demonstrated that the Young's modulus (1.421 GPa) and strain at break (7.6 %) of the new PANI asymmetric membranes prepared from hexane are approximately 12 and 4 times higher, respectively, than the values reported previously for the PANI integrally skinned asymmetric membranes (ISAMs) (123 MPa Young's modulus and 1.8 % strain at break). Furthermore, monolithic electrochemical actuators based on a single PANI asymmetric membrane were constructed, and a bending movement of up to 20 Hz was experimentally recorded in a hydrochloric acid aqueous solution. A lifetime of over 329 500 cycles was determined for these actuators at a ± 2° angular displacement (5 Hz). The lifetime is limited by a bending fatigue that creates a transversal crack on the PANI membrane at the air–water interface. Control over the actuator movement is also manifested by the linear dependences of the bending angle on the charge and of the angular velocity on the current. These relationships are independent of both the kind of applied electric signal and the frequency used.     

单片InGaAs／InP PIN PD阵列

文章简要地介绍了ＩｎＧａＡｓ／ＩｎＰ ＰＩＮ ＰＤ阵列的制作现状及其应用和发展趋势。     

Complexes in polymers IV. FTIR microscopic characterization of thin organic polymer films containing embedded transition-metal carbonyl complexes

Thin films of polystyrene (PS), poly(methyl methacrylate) (PMMA) and polystyrene-polyacrylonitrile copolymer (PS-AN), containing various embedded transition-metal complexes, have been studied by FTIR microscopy. The spatial distributions of the transition-metal carbonyl complexes throughout the thin organic polymer films have been determined by a two-dimensional IR mapping procedure. The spectral variations observed in the distribution of the metal carbonyls throughout the different polymer films are discussed. The IR data show that the technique used to prepare the organometallic-embedded thin films (viz. freeze-drying of solutions followed by hot mechanical pressing of the residues) does in general lead to homogeneous films which may eventually find industrial application, e.g. as membrane sensors for small molecules.     

一类二维非线性Schrodinger方程的吸引子及其维数

本文研究了一类二维非线性Ｓｃｈｒｏｄｉｎｇｅｒ方程解的有限维行为，我们得到了此方程存在吸引子，并得到了此吸引子维数的上界估计     

Simulation study of peak junction temperature and power limitationof AlGaAs/GaAs HBTs under pulsed and CW operation

The authors have used a 3-D transmission-line matrix (TLM) modeling method to study the junction temperature distribution and power limitation of device geometries with multiple embedded heat sources. Peak values of the junction temperature against the dissipated power density under both pulsed and CW operation are presented for a typical power AlGaAs/GaAs HBT structure. These data should facilitate the rapid determination of junction temperature for a given output power, which is of paramount importance in power device design     

Determination of the liquidus lines and isotherms of the Hg-Zn-Te system by a modified direct observation method

The modified direct observation method is employed for the determination of the liquidus lines in the (Hg_{1_x}Zn_x)_{1_y}Te_y, ternary system. The liquidus temperatures of the ternary samples of various compositions withx from 0.05 to 0.30 andy from 0.5 to 0.9 are measured. The temperature-composition phase diagrams and some liquidus isotherms are established for this system.     

Efficient algorithms for SS/TDMA scheduling

Efficient scheduling algorithms for the slot assignment problem in a satellite-switched time-division multiple-access (SS/TDMA) system are presented. This problem is translated into a modified open-shop scheduling problem, allowing the use of known optimal algorithms. Their complexity is expressed as a function of the following parameters: the number of nonzero entries in the demand matrix, the number of uplinks, and the number of downlinks. According to the values of these parameters, the algorithm with the lowest computational complexity can be adopted. Although the computational complexity of previously published algorithms is drastically reduced, simulation results show that the results are close to previously presented solutions in terms of the assignment duration and the number of switching matrices     

Poly(phenylene vinylene)‐based copolymers containing 3,7‐phenothiazylene and 2,6‐pyridylene chromophores: Fluorescence sensors for acids,metal ions,and oxidation

A novel copolymer, poly(N‐hexyl‐3,7‐phenothiazylene‐1,2‐ethenylene‐2,6‐pyridylene‐1,2‐ethenylene) ( P3 ), containing N‐hexyl‐3,7‐phenothiazylene and 2,6‐pyridylene chromophores was synthesized to investigate the effect of protonation, metal complexation, and chemical oxidation on its absorption and photoluminescence (PL). Poly(N‐hexyl‐3,8‐iminodibenzyl‐1,2‐ethenylene‐1,3‐phenylene‐1,2‐ethenylene) and poly(N‐hexyl‐3,7‐phenothiazylene‐1,2‐ethenylene‐1,3‐phenylene‐1,2‐ethenylene) ( P2 ), consisting of 1,3‐divinylbenzene alternated with N‐hexyl‐3,8‐iminodibenzyl and N‐hexyl‐3,7‐phenothiazylene, respectively, were also prepared for comparison. Electrochemical investigations revealed that P3 exhibited lower band gaps (2.34 eV) due to alternating donor and acceptor conjugated units (push–pull structure). The absorption and PL spectral variations of P3 were easily manipulated by protonation, metal chelation, and chemical oxidation. P3 displayed significant bathochromic shifts when protonated with trifluoroacetic acid in chloroform. The complexation of P3 with Fe³⁺ led to a significant absorption change and fluorescence quenching, and this implied the coordination of ferric ions with the 2,6‐pyridylene groups in the backbone. Moreover, both phenothiazylene‐containing P2 and P3 showed conspicuous PL quenching with a slight redshift when oxidized with NOBF₄. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 1272–1284, 2004     

VO2-Based Infrared Microbolometer Array

V0₂-based thin film materials on silicon substrates are fabricated by ion beam sputtering and a post-annealing which is different from the conventional fabricating method. An infrared linear microbolometer array with 128 pixels is prepared using as-deposited vanadium dioxide thin films. Optical and electrical properties for V0₂-based microbolometer array are tested.