Penalty interference of nonlinear intra-channel effects and PMD inultra high-speed TDM systems

Penalty interference of nonlinear propagation impairments and polarisation mode dispersion (PMD) caused signal distortions is experimentally investigated     

T-violation neutron experiment and polarized3He

An experimental scheme of the spin detailed balance in polarized neutron transmission through a polarized nuclear target is discussed for the T-violation test. The value of the spin detailed balance is estimated by using the data of the scattering amplitudes. The nuclear polarizations of proton,³He and¹³⁹La are discussed for the T-violation experiment.     

CO-laser photoacoustic detection of phosgene (COCl2)

Detection of COCl₂, a highly toxic gas in chemical industry, using laser photoacoustic spectroscopy is presented. The spectrophone system used has a broad band LN₂ cooled CW CO laser as a source of radiation, which operates from 4.8–8.4 um in the mid-infrared. Using an extracavity open longitudinal resonant cell, absorption signals to about 30 CO laser lines in the 5.45 um region could be observed. detection sensitivity has been estimated to be ppb order.This work has been supported by the NSFC     

I-slot characteristics

I-shaped slots will fit entirely on the rectangular waveguide narrow wall without wrapping onto the broad wall. This slot type is suitable for single plane scan-phased arrays where element spacing, in the scan plane, is equal to or less than one-half wavelength. The method of moments solution for the I-slot is presented. Comparison of computed results with measured data illustrates the validity of this solution. To facilitate future designs, the waveguide scattering parameters and the radiation characteristics of I-slots are included     

Proton-exchange optical waveguides in Z-cut LiNbO/sub 3/ using toluic acid

Proton-exchanged planar waveguides were demonstrated in Z-cut LiNBO/sub 3/ using toluic acid as a new organic proton source. These waveguides exhibit a propagation loss of around 1 dB/cm, and a step refractive index profile with an index increase of 0.124 measured at 0.663 mu m. The diffusion rate was found to be lower than those obtained using the popular benzoic and phosphoric acids.<>     

Forming mental models in learning operating procedures for terminalequipment

People faced with an unfamiliar product or service tend to fall back on mental models based on analogical relationships with familiar products or services. Two experiments on the analogical relationships or metaphors that people might use when operating a communications terminal are described. In the first experiment, the role previously acquired operating knowledge has in determining the mental models people use when directory dialing with novel equipment is examined. In a second experiment, it is shown that an explicit appeal to an analogy between conventional mail and electronic mail can help users learn to use an electronic mail system, and make it easier for them to remember how to use the system as long as 90 days after initial exposure. It is concluded that the mental model is constructed only from the user's operating knowledge acquired as a result of past experiences, and the metaphor method is effective when the instructions are metaphorically taught     

Transport of gases in aromatic polyesters: Correlation with WAXD studies

Polymer packing density can be conveniently measured by either density-based measurements (direct or estimated free volume) or wide-angle X-ray diffraction (WAXD) spectra. Previously reported diffusivity and permeability values for various polyarylates and polyimides are examined on the basis of the packing density measured by these different techniques. It is shown that in these rigid glassy polymers, the mean intersegmental distance, the d-spacing, obtained from WAXD provides a better measure of the effect of polymer packing on diffusivity than either direct density measurements or estimated free volumes. It has been possible to correlate previously reported diffusivity and sorption data for various polyarylates and polycarbonate on the basis of the WAXD investigation, using the d-spacing and the amorphous peak width, respectively. The effect of polyarylate structure on d-spacing has been studied. A series of polyarylates have been synthesized with different substituents on the bridge carbon. In this series the d-spacing remains constant while the carbonyl group density and the glass transition temperatures are varied. However, small substituents on the aromatic ring cause significant changes in the d-spacing. These results can be used to tailor polyarylates with desired intersegmental distances and chain flexibility.     

Study of the reciprocal space image of the biaxial nematic phase in the plane of the amphiphilic bilayer

High resolution synchrotron X-ray measurements have been performed on the uniaxial and biaxial phases of the lyotropic mixture potassuim laurate, decanol and water. An elegant magnetic orientational procedure allows us to obtain the cut of the reciprocal space image of the biaxial phase at the plane perpendicular to the amphiphilic bilayer. The analysis of densitometric profiles of the diffracted bands indicate an anisotropic micellar correlation in the plane of the amphiphilic bilayer. It is suggested that an anisotropic distribution of decanol and potassium laurate in this plane could be responsible for this effect.     

High-reliability GaAs-AlGaAs HBTs by MBE with Be base doping andInGaAs emitter contacts

The authors have developed a modified MBE growth process to produce high-gain n-p-n GaAs-AlGaAs heterojunction bipolar transistors (HBTs) with a mean time to failure (MTTF) of 1.5×10⁸ h at 125°C. Beryllium incorporation and diffusion are controlled through a combination of reduced substrate temperature and increased As/Ga flux ratio during MBE growth, resulting in extremely stable HBT profiles. The authors also demonstrate graded InGaAs surface layers with nonalloyed refractory metal contacts that significantly improve ohmic reliability compared to alloyed AuGe contacts. The ability to produce robust HBTs by MBE is critically important to this technology