Using buried capacitor in LTCC-MLC balun

A novel chip-type ceramic balun designed in the 2.4 GHz ISM band frequency is presented. A buried capacitor is included in the balun, so that the length of the coupled transmission lines can be reduced and can be designed very easily. A meander or spiral broadside coupled-line is adopted to realise the proposed LTCC multi-layer balun. The measured performances of phase and amplitude balance for this LTCC-MLC balun show a good match with computer simulation     

基于EDGE系统信道估计实现方案的研究

研究了基于ＥＤＧＥ系统接收机中信道估计的实现方案，并对算法的各项性能做出评估。首先论述了算法的采用及其理论依据。接着，说明了信道预估计的原理及方法。最后，针对ＭＡＴ－ＬＡＢ及 ＤＳＰ上的仿真结果，比较了各项系数对于系统性能改善所具有的影响和作用，对系统特性作了较为详细的分析总结。     

氢化丁苯共聚物结构的核磁共振波谱表征Ⅱ.微观结构的定量计算

在氢化丁苯共聚物¹³C-NMR谱脂肪碳部分谱带归属的基础上,根据各谱带的主要来源,推导出六个二单元浓度的计算公式。计算出二单元、一单元的相对含量,各结构单元的数均序列长度、嵌段含量和其它结构参数。加氢前后的¹H-和¹³C-NMR谱的组成计算结果基本一致。初步探讨了作为粘度指数改进剂的氢化丁苯共聚物微观结构与性能的关系,为合成提供了依据。     

A medium-access control protocol for a cellular packet CDMAcarrying multirate traffic

We propose and evaluate a medium-access control (MAC) protocol for synchronous cellular packet direct-sequence code-division multiple-access (DS/CDMA). The protocol is designed for handling a variety of multimedia traffic types in an integrated wireless-access network (IWAN). For instance, the protocol is suited for carrying multiple traffic types of different priorities. An analytical model for the equilibrium state has been developed for the proposed protocol. A comparative evaluation of the protocol is done for three different radio frequency bandwidths currently under consideration for personal communication services (PCS), i.e., 1.25 MHz, 5 MHz, and 10 MHz. Our results demonstrate that the proposed protocol is both robust and flexible for the intended IWAN applications. It offers a significant multiplexing gain as the bandwidth increases     

Fabrication of 1.55 μm VCSELs on Si using metallic bonding

Using AuGeNiCr multilayered metals as the wafer bonding medium, long-wavelength GaInAsP/InP vertical cavity surface emitting lasers employing Al-oxide/Si as the upper and lower distributed Bragg reflectors were fabricated on Si substrate with the bonding interface formed outside the vertical cavity surface emitting laser cavity. Laser emission at 1.545 μm was measured under pulsed operations near room temperature. The low-temperature metallic bonding process demonstrates a great potential in device fabrication     

Retrievals of column water vapor using millimeter-wave radiometric measurements

The airborne Millimeter-wave Imaging Radiometer (MIR) measurements conducted over the Midwest region of the continental United States during January/February 1997 and over the Alaska-Arctic region during May 1998 are used to estimate column water vapor W<0.8 g/cm/sup 2/ under a clear sky. On board the same aircraft are two other instruments, the Cloud Lidar System (CLS) and MODerate-resolution Imaging Spectrometer (MODIS) Airborne Simulator (MAS), which provide cloud cover information and independent measurements of W, respectively. The MIR-estimated W values are compared and found to be in very good agreement with those measured by rawinsondes at near concurrence. A close correlation is found between the MIR-estimated W and that estimated from the MAS near-IR reflectance ratios. Water surface emissivities at several MIR frequencies are obtained in the process of the W retrieval from several flights over the Midwest lakes. These estimated emissivities compared favorably with values calculated for a calm water surface, which are based on a di-electric permittivity model and MAS-measured surface temperatures. The results from all comparisons strongly demonstrate the soundness of the technique for estimating W.     

HIRFL–CSR加速器中束流与真空中剩余气体的碰撞损失

研究了重离子加速器中束流与真空中剩余气体的碰撞损失过程和碰撞截面,在依据大量实验数据的基础上,提出了一组计算离子一原子的电荷交换截面的经验公式.以兰州重离子加速器HDRFL及冷却储存环CSR为例,给出了依据碰撞截面的公式计算束流在加速器真空中的传输效率的方法,并计算了在不同真空度下HIRFL的ECR源轴向注入束运线、注入器SFC、前束运线、主加速器SSC和后束运线等不同加速阶段及CSR的传输效率,并提出合理的真空度要求.HIRFL的真空分布测量和束流的损失测量证明了该计算方法的可靠性.     

荧光显示管直丝氧化物阴极有效逸出功的计算

阴极的逸出功是表征阴极发射能力的物理量，求定荧光显示管直丝氧化物阴极有效逸出功时，因其零场发射电流密度难于准确取值，温度无法直接测量，显得困难，须予解决，为此提出了一种计算阴极有产逸出功的办法，对某显示管的发射欠佳和“低温高效”的两种氧化物阴极的有效逸出功进行计算，有效逸出功率是靠测量相关物理量再同计算得出，精度不很高，文中所用办法也不例外，但所得结果能反映阴极发射能力，所需仪器少，是实用方法。     

Influence of quantum capture and tunneling mechanisms on the dark current of bound-to-continuum quantum-well infrared photodetectors

We present a theoretical model for the dark current of bound-to-continuum quantum-well infrared photodetectors (QWIPs), by considering the field-induced mixing effect, tunneling rate and phonon scattering rate between bound and continuum states. Using this model, we can see clearly how these mechanisms significantly influence the Fermi levels of bound and continuum electrons, and thus, the dark current. Nonlinear temperature dependence of the dark current at low temperature is predicted and discussed in detail. The simulated dark currents exhibit good agreement with the experimental results, without use of parameter fitting techniques.