基于CB的串行口和接口板端口程序应用

串行口及接口板端口是计算机通信的主要途径 ,也是目前计算机工程测控中通用的基本方法。C Builder (简称CB)编程语言以其功能完备、开发效率高的特点而成为目前流行的程序开发工具 ,介绍了利用CB语言编写串行口和端口通信的程序的方法 ,并对具体的各方法编写了相应的示例。     

目标被动式跟踪评述

首先介绍了目标被动跟踪的发展状况，然后按照不同的量测源分别对现有的被动跟踪方法进行讨论，并给出了各种方法的适用范围和各自的优缺点。最后试探性地给出目标被动跟踪的发展趋势，及其需要解决的重点、难点问题。     

Blind feedforward cyclostationarity-based timing estimation for linear modulations

By exploiting a general cyclostationary (CS) statistics-based framework, this letter develops a rigorous and unified asymptotic (large sample) performance analysis setup for a class of blind feedforward timing epoch estimators for linear modulations transmitted through time nonselective flat-fading channels. Within the proposed CS framework, it is shown that several estimators proposed in the literature can be asymptotically interpreted as maximum likelihood (ML) estimators applied on a (sub)set of the second- (and/or higher) order statistics of the received signal. The asymptotic variance of these ML estimators is established in closed-form expression and compared with the modified Crame/spl acute/r-Rao bound. It is shown that the timing estimator proposed by Oerder and Meyr achieves asymptotically the best performance in the class of estimators which exploit all the second-order statistics of the received signal, and its performance is insensitive to oversampling rates P as long as P/spl ges/3. Further, an asymptotically best consistent estimator, which achieves the lowest asymptotic variance among all the possible estimators that can be derived by exploiting jointly the second- and fourth-order statistics of the received signal, is also proposed.     

移动通信系统"单通"故障浅析

重点分析了移动通信系统中,无线及交换系统内语音单通故障的成因；并以朗讯 CDMA 交换系统为例,提出语音系统优化建议；最后结合运维工作,阐述单通故障的处理流程与几种有效处理思路及工具。     

可信计算与可信网络

论文对主流的可信计算技术——TCPA和NGSCB进行了分析,并对可信计算平台(TCP)进行了研究,对基于可信计算的可信网络的三个基本属性进行了分析和研究,最后介绍了可信网络的发展现状。     

5Gb/s 0.25μm CMOS限幅放大器

采用TSMC 0.25μm CMOS技术设计实现了高速低功耗光纤通信用限幅放大器.该放大器采用有源电感负载技术和放大器直接耦合技术以提高增益,拓展带宽,降低功耗并保持了良好的噪声性能.电路采用3.3V单电源供电,电路增益可达50dB,输入动态范围小于5mVpp,最高工作速率可达7Gb/s,均方根抖动小于0.03UI.此外核心电路功耗小于40mW,芯片面积仅为0.70mm×0.70mm.可满足2.5,3.125和5Gb/s三个速率级的光纤通信系统的要求.     

Whispering-gallery-like modes in square resonators

The mode frequencies and field distributions of whispering-gallery (WG)-like modes of square resonators are obtained analytically, which agree very well with the numerical results calculated by the FDTD technique and Pade approximation method. In the analysis, a perfect electric wall for the transverse magnetic mode or perfect magnetic wall for the transverse electric mode is assumed at the diagonals of the square resonators, which not only provides the transverse mode confinement, but also requires the longitudinal mode number to be an even integer. The WG-like modes of square resonators are nondegenerate modes with high-quality factors, which make them suitable for fabricating single-mode low-threshold semiconductor microcavity lasers.     

MAX3100在80C196串口扩展中的应用

介绍采用新型的UART器件MAX3100为Intel单片机80C196扩展串口，给出了硬件设计和软件编程，并对关键技术进行了说明。     

完全非相干白光一维光生伏打暗空间孤子

使用白炽灯作光源在LiNbO₃∶Fe晶体内实验观察到一维白光光生伏打暗空间孤 子. 由奇数 和偶数初始条件分别产生了灰孤子和灰孤子对，它们所感应的波导能导向白光和相干光. 用 相干光清楚地探测到它们内部的多模结构. 该实验证明了白光光生伏打暗空间孤子的存在， 并指出了用完全非相干的白光暗孤子控制和导向相干光的可能性. 关键词： 光生伏打效应 自陷 完全非相干孤子 波导     

引入激光回馈的双光束干涉效应的研究

提出了一种引入He-Ne激光回馈的双光束干涉系统,并在理论和实验两方面进行了研究。实验中对系统中的干涉信号及激光器尾光功率变化同时进行探测。发现当干涉仪的主回馈镜移动时,激光器尾光信号是正弦形波形,而干涉仪输出的是以双峰为一个周期的信号,双峰中一峰总是高于另一峰,并且当主回馈镜移动方向改变时,同一周期中两峰出现的顺序也随之改变。对实验现象进行了理论分析,并模拟出干涉信号及激光自身功率的变化曲线。理论分析及模拟结果与实验结果完全吻合。讨论了利用发现的现象进行测量的可行性,所提出的测量方法易于实现。