原子吸收光谱法测定裂解汽油中铅

报道了用火焰原子吸收光谱法测定裂解汽油中铅的方法。用碘 二甲苯溶液对汽油进行氧化处理,用稀硝酸进行萃取,萃取后浓缩液用原子吸收光谱法进行测定。铅含量在0～7.0μg·ml-1范围内符合比耳定律。对汽油样品进行分析时,相对标准偏差小于3.95%,对样品进行加标回收试验,回收率为97.7%～101.7%,方法的精密度和准确度良好。     

微波辐射下4-(4-羟基-3-甲氧基)苯基-3,3,6,6-四甲基-1,8-二氧代1,2,3,4,5,6,7,8,9,10-十氢吖啶的合成和晶体结构

标题化合物C24H29NO4?1/2C2H5OH稨2O)由香兰素、5,5-二甲基-1,3-环己二酮、醋酸铵在微波辐射下干反应并经95%乙醇重结晶而得C24H29NO4穀2(C2H5OH稨2O)晶体。结构通过单晶X-射线衍射法确定,其晶体属单斜晶系,空间群P21/n, a = 9.810(2), b = 14.516(3), c = 17.008(3) ? b = 101.03(2), V = 2377.2(8) ?, Z = 4, Mr = 427.52, Dc = 1.195 g/cm3 , m(MoKa) = 0.082 mm-1, F(000) = 920。晶体结构用直接法解出,经全矩阵最小二乘法对原子参数进行修正,最终的偏离因子为R = 0.0406, wR = 0.0892。X-射线衍射分析结果表明,吡啶环和与之稠合的2个六员环均为信封式构象。     

示差脉冲伏安法测定乳酸脱氢酶活性及纳米微粒生物毒性检测新方法研究

采用示差脉冲伏安法，在乳酸脱氢酶(LDH)酶促体系“丙酮酸盐 + NADH +H⁺ (?) 乳酸盐 + NAD⁺”中，通过检测NAD⁺还原峰电流的变化，测定了不同条件下(不同酶用量、缓冲液pH值以及温度)LDH的活性、酶促体系的米氏常数K_m^NADH以及最大反应速率v_max。并且在最佳实验条件下，通过检测LDH活性的改变，实验考察了3种纳米物质(ZnS，TiO₂(R)和TiO₂(A))对乳酸脱氢酶酶促体系的影响。     

桑蚕丝素蛋白初始结构对其矿化作用的影响

以碱金属离子诱导桑蚕丝素蛋白溶液发生构象转变, 研究了蛋白质初始结构对其矿化作用的影响. FT-IR, XRD和SEM等测试结果显示, 未经任何处理的桑蚕丝素蛋白溶液矿化后形成片状复合物, 其无机相以二水磷酸氢钙(DCPD)为主; 而经过K^＋和Na^＋金属离子处理后, 桑蚕丝素溶液的结构由无规线团/螺旋构象向β-折叠发生转变, 矿化后成纤维状, 并相互结合呈现纳米级的三维多孔结构, 其无机相以热力学稳定的羟基磷灰石(HA)为主. 可以认为, 丝素蛋白结构转化为较伸展的β-折叠后, 使得更多的亲水基团暴露在外面, 在丝素蛋白分子不断凝聚成纤过程中, HA结晶快速生长并附着在这些微纤上, 最终形成纤维状的丝素蛋白/HA复合物. 该结果为阐明蛋白质的生物矿化过程及其调控机理提供了理论依据, 同时可以从矿化复合物的形成来反映这些微量元素可能对骨组织形成的影响, 为临床骨组织的修复提供一定的参考.     

Vapor‐Phase Reaction of Citronellal over Mesoporous Molecular Sieves MCM‐41 and Zeolites

The vapor‐phase reaction of citronellal (CTN) at 220 °C and atmospheric pressure has been studied using mesoporous molecular sieves and zeolites in a fixed‐bed reactor. The primary products included isopulegol (IPG), menthone, and pulegol with subsequent reactions to form cyclic hydrocarbons. The CTN conversion and the product selectivity depend on the acidity and the textural property of catalysts. Lewis and/or Brönsted acid sites are essential for catalyzing this reaction. An increase of SiO₂/Al₂O₃ mol ratio diminishes the acid amount of all catalysts and enhances both the surface area and the structural order of MCM‐41. The catalytic activity follows the order of MCM‐41 > HZSM‐5 > Hβ > USY, in accordance with the relative total acid amount except that of MCM‐41. Despite its low acidity, Si‐MCM‐41 exhibits the best catalytic performance due to its uniform mesopores, large surface area and good stability; the CTN conversion and the IPG yield attain 91.9% and 58.6%, respectively, after at least 25 h time‐on‐stream.     

Determination of medecamycin by adsorptive stripping voltammetry with an activated electrode

The adsorptive and electrochemical behaviors of medecamycin were investigated on a glassy carbon electrode (GCE) pretreated by anodic oxidation at +1.8 V for 5 min in 0.025 mol l^–1 NH₃-NH₄Cl (pH 8.6) solution. An adsorptive stripping voltammetric method for the determination of medecamycin at the pretreated glassy carbon electrode has been developed. Medecamycin was accumulated in NH₃-NH₄Cl buffer (pH 9.0) at a potential of –0.7 V (vs. saturated calomel electrode (SCE)) for a certain time, and then determined by second-order differential anodic stripping voltammetry. The second-order differential anodic stripping peak current at +0.72 V was proportional to the concentration of medecamycin in the range 2.0 g ml^–1 to 50.0 g ml^–1. The detection limit (three times the signal-to-noise) was 1.0 g ml^–1 and the relative standard deviation of the results was 3.28% for eight successive determinations of 10.0 g ml^–1 medecamycin. This method has been applied to the direct determination of medecamycin in commercial tablets and spiked urine samples with satisfactory results.     

利用生物发光技术检测微量焦磷酸

利用生物发光技术建立了一种高灵敏度的检测微量焦磷酸 ( PPi)的新方法。其原理是首先利用 ATP硫酰化酶 ( ATP sulfurylase)将焦磷酸 ( PPi)定量转化成ATP,然后利用虫荧光素酶 ( Luciferase)系统发光检测 ATP的量 ,从而确定样品中PPi的含量。本法快速、灵敏 ,线性范围为 1× 1 0 - 9～ 5× 1 0 - 7mol/ L。方法用于 PCR扩增样品中 PPi的检测 ,获得满意结果     

用FTIR定量测定聚对苯二甲酸乙二酯晶区和非晶区反式构象含量

用傅里叶变换红外分光光度计测定不同条件下退火处理的聚对苯二甲酸乙二酯膜的谱图, 用谱带分离技术对归属于反式构象的1340cm^-^1谱带进行阻尼最小两乘分峰处理, 结合属左右式构象贡献的1454cm^-^1谱带, 用线性回归分析的方法获得晶区反式构象、非晶区反式构象、非晶区左右式构象的百分含量。     

A Novel Oxidative N-Demethylation of 12-Membered Macrolide with Lead Tetraacetate

Erythromycin has been extensively used in the treatment of bacterial infections for over 50 years1. In addition to the antimicrobial effect, the quite unique antiinflammatory activity of the erythromycin derivatives has attracted much attention as new the…     

STUDY ON AB-CROSSLINKED POLYMERS Ⅰ. THE SYNTHESIS AND MECHANICAL PROPERTIES OF AB-CROSSLINKED POLYMERS BASED. ON PU/PS

The AB-crosslinked polymers (i.e. ABCP) with polystyrene as chain A and vinyl group blocked prepolymers of polyurethanes (PU) as chain B were synthesized and studied. The results of dynamic mechanical spectrometry (DMS) show that the compatibility between the components A and B can be improved greatly through chemical crosslinking during the formation of ABCPs. This effect is especially pronounced when short chain prepolymers is chosen as one of the components. It is apparent that the degree of crosslinking between the two components plays a major role in determining their compatibility. Copolymerizafion of styrene with maleic anhydride in chain A can improve the compatibility and broaden the damping temperature range. Mechanical properties of the sythesized ABCPs were also studied.