A Generalized Technique for Register Counting and its Application to Cost-Optimal DSP Architecture Synthesis

In this paper we propose a generalized technique to count the required number of registers in a schedule which supports overlapped scheduling and can be applied to the case where a general digit-serial data format is used. This technique is integrated into an integer linear programming (ILP) model for time-constrained scheduling. In the ILP model, appropriate processors of certain data formats are chosen from a library of processors and data format converters are automatically inserted between processors of different data formats if necessary. Then the required number of registers for each data format is evaluated correctly by the proposed technique. Hence an optimal architecture for a given digital signal processing algorithm is synthesized where the cost of registers as well as the cost of processors and data format converters are minimized. It is shown that by including the cost of registers in the synthesis task as proposed in this paper leads to up to 12.8% savings in the total cost of the synthesized architecture when compared with synthesis performed without including the register cost in the total cost.     

Study on the dispersion characteristic of the plasma-loaded relativistic BWO

The dispersion characteristic of the plasma-loaded relativistic backward wave oscillator has been analyzed. The theoretical model has been established and the numerical calculations accord with the experimental results, which provides some useful suggestions on the designing of slow-wave structure of BWO.     

PINNING EFFECT OF LEAD LANTHANUM TITANATE THIN FILMS DEPOSITED ON DIFFERENT SUBSTRATES

Pinning effect of lead lanthanum titanate (PLT) ferroelectric thin films with excess PbO of 20 mol% has been studied for deposition on diffe rent substrates. Silicon, sapphire and quartz were used as substrates on which P t/Ti or LaNiO₃ thin films were deposited as bottom electrodes. Electron probe analysis results showed that there was still a certain amount of excess Pb in PLT films after annealing at 550 ℃ for 1 h, and the amount of it was dependent on the substrate used. The distribution of excess Pb in the films was investig ated by Auger electron spectroscopy depth profile. It was shown that the substrates and the bottom electrodes had significant effects on the content and distrib ution of excess Pb in PLT films. The excess Pb and its accumulation at the inter face between the film and bottom electrode may act as pinning centers and have a pinning effect on domains, which can be observed by abnormal P-E hysteresis loops and abnormal C-V curves. The excess Pb content in the films and the accumulation of Pb at the interface were high in PLT films deposited on Pt/Ti/S i, and considerable pinning effect was observed. As LaNiO₃ would absorb most part of the excess Pb in PLT films, the content of excess Pb in the films deposited on LaNiO₃/Si was very low and the pinning effect was hardly observed.     

锡(Ⅳ)-偶氮邻苯二酚苯基荧光酮-吐温-80体系分光光度法测定岩石中微量锡

pH值在7.0-8.5的范围内，锡与偶氮邻苯二酚苯基荧光酮、吐温－80形成络合物，其最大吸收峰556nm，摩尔吸光系数2.9×10^5L·mol^-1·cm^-1，锡的含量在0－6μg/25mL范围内遵守比耳定律，本方法对干扰离子的影响和消除进行了研究，本方法已被用于岩石样中锡的测定，结果满意。     

A Study on the Model of Forecasting System about the Actual Telephone Occupation in the Lead Development

ＡＳｔｕｄｙｏｎｔｈｅＭｏｄｅｌｏｆＦｏｒｅｃａｓｔｉｎｇＳｙｓｔｅｍａｂｏｕｔｔｈｅＡｃｔｕａｌＴｅｌｅｐｈｏｎｅＯｃｃｕｐａｔｉｏｎｉｎｔｈｅＬｅａｄＤｅｖｅｌｏｐｍｅｎｔ￥ＸｉｅＳｈｉｃｈａｎｇ；ａｎｄＸｉｅＸｕｅｍｅｉ（Ｄｅｐａｒｔｍｅｎｔｏ...     

提高E^2PROM中NMOS管源漏穿通电压的实验研究

为了提高Ｅ＾２ＰＲＯＭ中Ｎ管源漏穿通电压，用实验的方法对制造工艺进行了研究。结果表明，高能量注入是提高ＶＰＴ的有效手段，但受到ｐｎ结击穿的限制，只适用于低区短沟Ｎ管；ＤＤＤ工艺大幅度高ＶＰＴ，但ｐｎ结击穿电压低于２０Ｖ，不能应用于高压ＭＯＳ管；采用适量的防穿通注入和适当增大沟道长度为最理想的工艺途径。     

Applications of Soliton Transmission Control in Optimal Design of Long－Haul Soliton Communication System

ＡｐｐｌｉｃａｔｉｏｎｓｏｆｃｈａｏｓｉｎｓｐｒｅａｄｓｐｅｃｔｒｕｍｃｏｍｍｕｎｉｃａｔｉｏｎｓＡｐｐｌｉｃａｔｉｏｎｓｏｆＳｏｌｉｔｏｎＴｒａｎｓｍｉｓｓｉｏｎＣｏｎｔｒｏｌｉｎＯｐｔｉｍａｌＤｅｓｉｇｎｏｆＬｏｎｇ－ＨａｕｌＳｏｌｉｔｏｎＣｏｍ...