Degradation Behaviors of Metal-Induced Laterally Crystallized n-Type Polycrystalline Silicon Thin-Film Transistors Under DC Bias Stresses

Device degradation behaviors of typical-sized n-type metal-induced laterally crystallized polycrystalline silicon thin-film transistors were investigated in detail under two kinds of dc bias stresses: hot-carrier (HC) stress and self-heating (SH) stress. Under HC stress, device degradation is the consequence of HC induced defect generation locally at the drain side. Under a unified model that postulates, the establishment of a potential barrier at the drain side due to carrier transport near trap states, device degradation behavior such as asymmetric on current recovery and threshold voltage degradation can be understood. Under SH stress, a general degradation in subthreshold characteristic was observed. Device degradation is the consequence of deep state generation along the entire channel. Device degradation behaviors were compared in low V_d-stress and in high V_d-stress condition. Defect generation distribution along the channel appears to be different in two cases. In both cases of SH degradation, asymmetric on current recovery was observed. This observation, when in low V_d-stress condition, is tentatively explained by dehydrogenation (hydrogenation) effect at the drain (source) side during stress     

长脉冲激光沉积原位生成YBaCuO超导膜

用长脉冲激光(脉冲宽度150μs,波长1.06μm)辐照高温烧结的YBa_2Cu_3O_(7-x)靶,在6Pa的氧气压强下,巳在(100)YSZ单晶衬底上原位生成YBa_2Cu_(?)O_(7-x)超导膜。衬底置于750℃的加热器上,衬底与靶之间的距离5cm,用该法制得的薄膜光亮坚实,正常态呈金属性,零电阻温度为84.7K。用XRD和SEM对薄膜进行了分析研究。     

50W CO_2激光雕刻机控制系统

介绍非金属材料表面加工的CO2激光雕刻机的基本原理其控制系统。     

3mm波段极近距离雷达

提出一种极近距离雷达概念，并导出其作用距离公式，在此基础上研制出一台３ｍｍ波段极近距离多普勒雷达样机．试验结果表明该雷达结构简单，成本低廉，在作用距离为零点几米至几米范围内可获得较高的定距精度．     

Development of Bi(Pb)-2223/Ag pancake-shaped and solenoidal coils

High temperature superconducting (HTSC) multifilamentary (MT) Bi(Pb)-2223/Ag tapes with reproducible critical current density of between 15000 and 20000 A/cm² at 77 K in self field have been achieved using the standard flat-rolling method as the intermediate deformation between sintering periods. Long lengths of Bi(Pb)-2223/Ag MT tapes up to 43 m prepared by the conventional method of powder-in-tube (PIT) have been successfully produced on a laboratory scale. Several coils have been fabricated from sections of the long length tape, using the co-wound wind-and-react (W&R) procedure for the pancake-shaped and the singly-wound W&R as well as R&W procedure for the solenoidal coils. A novel W&R solenoidal coil (reaching ~973 ampere-turns) wound on an alumina ceramic tube generates a DC field of ~19 mT at 77 K and has been fabricated together with five pancake-shaped coils, each generating an average of ~5 mT at 77 K. These are destined for magnet construction with a possible combined calculated field of ~0.04 T at 77 K (with liquid nitrogen as a coolant)     

Surface-enhanced Raman scattering study of polymer on metals. III. Chemisorbed polybenzimidazole and its corrosion-inhibiting properties at high temperature

Chemisorption of polybenzimidazole on silver and copper etched with nitric acid has been observed by surface-enhanced Raman scattering (SERS). The polymer is found to react chemically with silver, forming a complexed film on the surface. The SERS spectra show that polybenzimidazole film inhibits oxidation of the metal at high temperature, unlike chemisorbed benzimidazole, benzotriazole, and poly(4-vinyl pyridine). © 1992 John Wiley & Sons, Inc.     

机载扫描成象系统的技术发展

叙述了机载扫描成象系统的发展,基本结构,特点及其应用.     

A global optimization design for quasi-optics power combiner of 3mm wave solid-state sources

This paper describes a global optimization design for quasi-optics power combiner of solid-state millimeter-wave sources. The operating frequency is about 100 GHz and the oscillating sources are GaAs Gunn diodes. The source-array plane is a matrix consisting of NxN (N=3,5, ..., 2k+1, where k is positive integer) diodes. The radio frequency power of the combiner is from threefold to sevenfold larger than the sum total of the single diodes power. The global optimums of the array and the location in the cuvity of the suorce-array plane will be given by a global optimizition method.     

Least‐squares finite element method on adaptive grid for PDEs with shocks

We apply the least‐squares finite element method with adaptive grid to nonlinear time‐dependent PDEs with shocks. The least‐squares finite element method is also used in applying the deformation method to generate the adaptive moving grids. The effectiveness of this method is demonstrated by solving a Burgers' equation with shocks. Computational results on uniform grids and adaptive grids are compared for the purpose of evaluation. The results show that the adaptive grids can capture the shock more sharply with significantly less computational time. For moving shock, the adaptive grid moves correctly with the shock. © 2005 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq, 2006