3mm波段极近距离雷达

提出一种极近距离雷达概念，并导出其作用距离公式，在此基础上研制出一台３ｍｍ波段极近距离多普勒雷达样机．试验结果表明该雷达结构简单，成本低廉，在作用距离为零点几米至几米范围内可获得较高的定距精度．     

中波同步广播的回顾及同步技术的探讨

本文回顾了实施中波同步广播的经历，分析了目前运行中的同步网所存在的问题。笔者根据１０余年参与同步广播运行管理，科研的体会，论述了实施良好同步广播的措施。就同步广播的发展：标频传送，同步激励的性及同步网的管理三个关键方面的，提出了探讨性的建议和意见。     

CVD金刚石工具膜生长特征SEM观察

本文用不热形变栅状直丝化学气相沉积（ＣＶＤ）法生长金刚石膜，在Ｓｉ及ＷＣ－Ｃｏ硬质合金衬底上金刚石膜晶面显露规律随衬底温度和甲烷浓度而异，经适当表面处理及选择合适的工艺条件，当生长初期衬底上就呈现出良好晶形的沉积膜，衬底与膜之间的粘结力能得到提高。Ｒａｍａｎ谱分析表明此膜仅具有特征金刚石１３３２ｃｍ￣（－１）峰，通过ＳＥＭ观察揭示出盒刚石膜可在表面、侧面及棱上生长，并与衬底有良好的联结。     

Mechanism analysis of gate-induced drain leakage in off-state n-MOSFET

An analytical expression for both band-to-band and band-trap-band indirect tunnelings is used to study the gate-induced drain leakage (GIDL) current of MOSFETs measured before and after hot-carrier stress. The voltage and temperature dependence of GIDL are characterized. Both results show that interface traps situated near the midgap participate in the conduction of GIDL, and band-trap-band indirect tunneling could be the major mechanism. This is further supported by the fact that the percentage increase in GIDL induced by hot-carrier stress is about the same as the corresponding increase in interface-trap density. On the other hand, under low-field conditions, trap-assisted Poole–Frenkle emission dominates over tunneling for temperatures even well below room temperature.     

低相噪,低杂波数字锁相环路滤波器的设计

较详细地分析数字锁相频率合成器的相位噪声，着重用控制论方法对低相噪、低杂波锁相环的环路滤波器进行设计，并用某Ｓ波段频率合成器的实验结果进行了验证。     

全20CrMnTi表面激光重熔的组织与性能研究

本文对激光重熔20CrMnTi材料表明改性层显微组织分布特征、表面硬度分布规律以及残余应力状态作了研究,结果表明,表面改性层由熔融层、相变硬化层及过渡层组成,且材料表面显微硬度得到大幅度提高,表面硬度达到HV841,约提高4倍。硬化层深度约1mm。残余应力测试得出最大残余应力出现在熔凝带中心,表现为压应力。随着离中心距离的增大,残余应力逐步降低,到熔化带边缘,表现为低幅值压应力;而熔池的外边缘应力在热影响区则转变为拉应力状态。     

两种自主开发的图形外延SiGe工艺

使用清华大学微电子学研究所研发的UHV/CVD系统深入研究了图形外延SiGe工艺,分别选用单一的SiO2介质层和SiO2/P0ly-Si复合介质层,作为图形外延SiGe单晶材料的窗口屏蔽介质,开发出了不同的实用化图形外延SiGe工艺.     

Effect of the polymer matrices on the dielectric behavior of a percolative high-k polymer composite for embedded capacitor applications

High dielectric constant (high-k) polymer composites are of great interest for embedded capacitor applications. Previously, we demonstrated that epoxy—aluminum composites are promising for embedded capacitor applications, because they have a high dielectric constant and a low dielectric loss due to the core—shell structure of the self-passivated aluminum particles. In this work, to further understand the dielectric behavior of aluminum composites, lower-loss polymers such as silicone, polyimide, polynorbornene, and benzocyclobutene were explored as matrices for the aluminum composites. It is found that the polymer matrices can significantly change the dielectric properties of the aluminum composites. A polymer matrix with a lower dielectric constant generally results in a lower dielectric constant of its aluminum composites. In this regard, polymer—aluminum composites have a similar dielectric characteristic as polymer—ceramic composites. Thermomechanical properties of aluminum composites were characterized by a thermomechanical analyzer.     

Time-Space Label Switching Protocol (TSL-SP)—A New Paradigm of Network Resource Assignment

In this paper we propose a new protocol called time-space label switching protocol (TSL-SP) in optical burst switching (OBS), and define the terms time-space label (TSL) and time-space routing (TSR). An important concept of response time is introduced in the time label mechanism. The TSL-SP is a new technology that can quickly and efficiently forward data with a label on the optical networks. A two-dimension label switched path (TD-LSP) can be set up, that is maintained and deleted by the TSL-SP. For clearly illuminating the operation principles of the TSL-SP, we propose a new approach of orthogonal time-space coordinates in which the vertical coordinate is the space label and the horizontal coordinate is the time label. The proposed TD-LSP can dramatically reduce the routing failure probability and greatly improve the link network efficiency compared with other signaling protocols. Moreover, we define the time-space label control plane that can achieve the higher efficiency. When the TSL-SP is applied to networks, switching performance can be improved by two orders compared to the switching performance with the conventional OBS signaling protocols. The fundamental goal of TSL-SP is to band the signaling and routing functions together closely. Also, the TSL-SP can reduce the complexity of the network, support automatic service offering, and provide traffic engineering.     

移动IP的关键技术

本详细描述了移动IP的工作过程，并介绍了移动IP的隧道技术和IPSec，最后对移动IP技术中存在几个热点问题进行了讨论。