CONTINUOUS DEPENDENCE ON DATA UNDER THE LIPSCHITZ METRIC FOR THE ROTATION-CAMASSA-HOLM EQUATION

In this article,we consider the Lipschitz metric of conservative weak solutions for the rotation-Camassa-Holm equation.Based on defining a Finsler-type norm on the tangent space for solutions,we first establish the Lipschitz metric for smooth solutions,then by proving the generic regularity result,we extend this metric to general weak solutions.     

一种高输入电压高PSRR的带隙基准电路设计

在高压宽输入范围的芯片中,高压电源一般不直接作为带隙基准电路的电源。传统方案采用齐纳二极管加源随器将高压输入转换为低压电源,为带隙基准供电,然而低压电源波动过大,降低了带隙基准的PSRR。电源由反馈环路产生,可以提供高PSRR性能。文章提出了一种输入电压范围为5～65 V,通过闭环负反馈产生低压电源和1.2 V基准电压的带隙基准电路,适用于宽输入电压芯片,如Buck、电机驱动或模拟ASIC芯片。该带隙基准电路的电源是将自身产生的电流流经PMOS,由PMOS的V_GS确定。因此低压电源不随输入电压变化,线性调整率极低。该电路由预处理电路、启动电路和带隙基准电路组成,采用负反馈稳压设计,不使用齐纳二极管,不引入额外的掩膜层,降低了电路成本。在CSMC 0.25μm BCD工艺下,基准电压线性调整率低至0.000 091%,输入电压在5～65 V范围内基准变化小于1μV,低频PSRR为-160 dB@100 Hz,温度系数为2.8×10^-5/℃。     

Comparison Studies on Several Ligands Used in Determination of Cd(II) in Rice by Flame Atomic Absorption Spectrometry after Ultrasound-Assisted Dispersive Liquid–Liquid Microextraction

Ligands plays an important role in the extraction procedures for the determination of cadmium in rice samples by using flame atomic absorption spectrometry (FAAS). In the present study, comparative evaluation of 10 commercially available ligands for formation of Cd(II)-ligand complex and determination of cadmium in rice samples by ultrasound-assisted dispersive liquid–liquid microextraction (UADLLME) combined with FAAS was developed. Sodium diethyldithiocarbamate (DDTC) provided a high distribution coefficient as well as a good absorbance signal, therefore DDTC was used as a ligand in UADLLME. A low density and less toxic solvent, 1-heptanol, was used as the extraction solvent and ethanol was used as the disperser solvent. In addition, the experimental conditions of UADLLME were optimized in standard solution first and then applied in rice, such as the type and volume of extractant and dispersant, pH, extraction time, and temperature. Under the optimal experimental conditions, the detection limit (3σ) was 0.69 μg/L for Cd(II). The proposed method was applied for the determination of Cd(II) in three different rice samples (polished rice, brown rice, and glutinous rice), the recovery test was carried out, and the results ranged between 96.7 to 113.6%. The proposed method has the advantages of simplicity, low cost, and accurate and was successfully applied to analyze Cd(II) in rice.     

毛细管电泳法快速测定保健食品中免疫球蛋白G

建立了毛细管电泳法快速测定保健食品中免疫球蛋白G(IgG)含量的方法,成功测定了不同剂型(片剂、粉剂及胶囊)牛初乳保健品中IgG的含量。以37 cm×50μm(i.d.)未涂敷熔融石英毛细管为色谱分离柱,50 mmol/L四硼酸钾 65 g/L聚乙二醇20 000(1 mol/L氢氧化铯调pH 10.0)为运行缓冲液,于214 nm波长处检测。详细研究了影响实际样品中IgG分离及准确定量的关键因素,如添加剂的种类、浓度;运行及样品缓冲液的浓度及pH等。采用峰面积外标法定量。方法的精密度为2.1%(n=7);检出限为6.25 mg/L(S/N=3);线性范围为50~2000 mg/L;400 mg/L IgG迁移时间的相对标准偏差(RSD)为0.14%;峰面积的RSD为2.9%(n=7)。6 m in内即可实现保健食品中IgG的分离与测定,结果与产品标示值基本吻合。     

室温离子液体法合成新型三维共价有机骨架材料

采用室温离子热法合成了一种氟取代的具有五重贯穿金刚石拓扑结构的三维共价有机骨架材料(COFs), 记为JUC-515. 与高温溶剂热法不同的是, 室温离子液体法具有反应温度和压力低、 反应时间短、 操作简单、 无需催化剂和不产生有机蒸汽污染等优势. 制备的材料具有高度结晶性、 较大的孔隙率和良好的CO₂选择性吸附性能.     

植物油中脂肪酸不同定量方法的比较分析

比较峰面积归一化法与标准曲线法两种方法分析植物油中脂肪酸百分比含量的差异.利用气相色谱-质谱联用仪(GC-MS)检测10种市售食用植物油中的8种主要脂肪酸,峰面积归一化法和标准曲线法计算脂肪酸的百分比含量.结果表明,标准曲线法与峰面积归一化法相比,肉豆蔻酸、棕榈酸、十七烷酸、硬脂酸和棕榈油酸所占的百分比升高,而油酸、亚...     

基于甲基苯丙胺和吗啡的胶体金免疫层析试剂盒检测法的可靠性评价

通过固相萃取-液相色谱-多级质谱(SPE-LC-MS/MS)联用技术和毒品胶体金免疫层析试剂盒检测法对13种中药及调味品样品中甲基苯丙胺及吗啡分别进行定量分析,依据LC-MS/MS检测结果,对毒品胶体金免疫层析试剂盒检测法进行可靠性评价。实验结果表明:型号1试剂盒对甲基苯丙胺和吗啡的特异性均不高,检测准确率分别为57.7%与78.8%;型号2试剂盒对甲基苯丙胺的特异性不足,准确率为73.1%,但对吗啡的检测准确率达到100%。在利用毒品胶体金免疫层析试剂盒进行毒品快速筛查时,应注重排除干扰因素以提高免疫胶体金层析试剂盒的检测准确度。     

Superhydrophobic surface based on micro/nano structured ZnO nanosheets for high-efficiency anticorrosion

Journal of Solid State Electrochemistry - There are two key factors in the fabrication of superhydrophobic surfaces. One is to have the appropriate micro/nano structure, and the other is to reduce...     

One step synthesis of Fe4.4Ni17.6Se16 coupled NiSe foam as self-supported,highly efficient and durable oxygen evolution electrode

The development of cost-effective, durable and high-efficient oxygen evolution reaction (OER) electrocatalysts is an extremely critical technology for the large-scale industrial water electrolysis. Here, a new strategy is proposed to significantly enhance the electrocatalytic activity by forming a hybrid electrode of NiSe and Fe_4.4Ni_17.6Se₁₆ through direct selenization of porous iron-nickel (FeNi) alloy foam via thermal selenization process. The obtained self-supported Fe_4.4Ni_17.6Se₁₆/NiSe hybrid (FNS/NiSe) foam displays outstanding durability and remarkable catalytic activity in 1.0 M KOH with low overpotentials of 242 and 282 mV to achieve the current densities of 100 and 500 mA cm^?2, respectively. To the best of our knowledge, it exceeds most of the reported OER electrocatalysts in alkaline electrolytes.     

钙钛矿材料组分调控策略及其光电器件性能研究进展

近年来，钙钛矿太阳电池的光电转换效率取得了爆发式增长，这与电池中钙钛矿薄膜的制备工艺和材料组分密切相关.关于钙钛矿薄膜的制备方法，相关的研究报道及综述较多，然而钙钛矿材料组分调控方面的研究梳理工作相对缺乏.本综述总结了近年来不同组分体系钙钛矿材料的研究进展，包括有机无机铅卤钙钛矿、全无机铅卤钙钛矿、少铅钙钛矿以及无铅钙钛矿.重点介绍了不同体系中具有代表性的材料组分及其对器件性能的影响，旨在梳理通过组分调控提高钙钛矿电池的效率及稳定性的研究思路，最终实现商业化应用.