Layer by layer buildup of polysaccharide films: physical chemistry and cellular adhesion aspects

The formation ofpolysaccharide films based on the alternate deposition of chitosan (CHI) and hyaluronan (HA) was investigated by several techniques. The multilayer buildup takes place in two stages: during the first stage, the surface is covered by isolated islets that grow and coalesce as the construction goes on. After several deposition steps, a continuous film is formed and the second stage of the buildup process takes place. The whole process is characterized by an exponential increase of the mass and thickness of the film with the number of deposition steps. This exponential growth mechanism is related to the ability of the polycation to diffuse "in" and "out" of the whole film at each deposition step. Using confocal laser microscopy and fluorescently labeled CHI, we show that such a diffusion behavior, already observed with poly(L-lysine) as a polycation, is also found with CHI, a polycation presenting a large persistence length. We also analyze the effect of the molecular weight (MW) of the diffusing polyelectrolyte (CHI) on the buildup process and observe a faster growth for low MW chitosan. The influence of the salt concentration during buildup is also investigated. Whereas the CHI/HA films grow rapidly at high salt concentration (0.15 M NaCl) with the formation of a uniform film after only a few deposition steps, it is very difficult to build the film at 10(-4) M NaCl. In this latter case, the deposited mass increases linearly with the number of deposition steps and the first deposition stage, where the surface is covered by islets, lasts at least up to 50 bilayer deposition steps. However, even at these low salt concentrations and in the islet configuration, CHI chains seem to diffuse in and out of the CHI/HA complexes. The linear mass increase of the film with the number of deposition steps despite the CHI diffusion is explained by a partial redissolution of the CHI/HA complexes forming the film during different steps of the buildup process. Finally, the uniform films built at high salt concentrations were also found to be chondrocyte resistant and, more interestingly, bacterial resistant. Therefore, the (CHI/HA) films may be used as an antimicrobial coating.     

Effect of water in the precursor solution on the catalytic property of LaMnAl11O19 high temperature combustion catalyst

Manganese-substituted lanthanum hexaaluminates were prepared by the sol-gel method. The effect of water content on the catalyst preparation was examined. Large water content caused a rapid decrease in the surface area. When the R (R is the mole ratio of H₂O/ Al(OC₃H₇)₃) is equal to 1.5, the catalyst retains a specific surface area of 13.5 m² g⁻¹ and shows higher activity in CH₄ combustion.     

Transparent conducting oxides: texture and microstructure effects on charge carrier mobility in MOCVD-derived CdO thin films grown with a thermally stable, low-melting precursor

A series of low-melting, thermally stable cadmium metal-organic chemical vapor deposition (MOCVD) precursors have been synthesized, structurally and spectroscopically characterized, and implemented in growth of highly conductive and transparent CdO thin films. One member of the series, bis(1,1,1,5,5,5-hexafluoro-2,4-pentanedionato)(N,N-diethyl-N',N'-dimethyl-ethylenediamine)cadmium(II), Cd(hfa)(2)()(N,N-DE-N',N'-DMEDA), represents a particularly significant improvement over previously available Cd precursors, owing to the low melting point and robust thermal stability. High-quality CdO films were grown by MOCVD on glass and single-crystal MgO(100) between 300 and 412 degrees C. Film growth parameters and substrate surface have large effects on microstructure and electron carrier transport properties. Enhanced mobilities observed for highly biaxially textured films grown on MgO(100) vs glass are attributed, on the basis of DC charge transport and microstructure analysis, to a reduction in neutral impurity scattering and/or to a more densely packed grain microstructure. Although single-grained films grown on MgO(100) exhibit greater mobilities than analogues with discrete approximately 100 nm grains and similar texture, this effect is attributed, on the basis of charge transport and Hall effect measurements as well as optical reflectivity analysis, to differences in carrier concentration rather than to reduced grain boundary scattering. Unprecedented conductivities and mobilities as high as 11,000 S/cm and 307 cm(2)/V.s, respectively, are obtained for epitaxial single-grained films (X-ray diffraction parameters: fwhm(omega) = 0.30 degrees, fwhm(phi) = 0.27 degrees ) grown in situ on MgO(100) at a relatively low temperature (400 degrees C).     

Effects of cobalt-60 γ-ray irradiation on fresh-keeping and storage of kiwifruits

The boxes contained kiwifruits were irradiated with cobalt-60 γ-rays at different dosages (0.6 , 1.8 and 3.6 KGy) and stored in a room ventilated at night, the natural ambient air being used as cool source.The results showed that the treatment which fruits irradiated with 0.6 KGy was the best after 85 days. It gave the normal-fruit rate of 95.10%, fruit flesh hardness of 4.10 Kg · cm^-2, fresh and plump fruits, good quality and less Vc loss.     

Coriatone and corianlactone, two novel sesquiterpenes from Coriaria nepalensis

Both coriatone (1). a novel highly oxygenated picrotoxane-type sesquiterpene, and corianlactone (2). with an unprecedented sesquiterpene basic skeleton, named coriane, were isolated from Coriaria nepalensis Wall. The structures of 1 and 2 were determined by analysis of their two-dimensional NMR data, and the structure of 2 was confirmed by X-ray analysis. Compounds 1 and 2 showed no remarkable inhibitory activity toward K(562) cells. They are cytotoxic with IC(50) > 50 microg/mL (cis-platinim: IC(50) = 0.49 microg/mL).     

硼化合物的研究XX:乙醇胺合三(2-呋喃基)硼烷的合成及其转化

2-呋喃基锂与(N,N-二乙胺基)二氯硼烷的反应是以三烃基化的方式发生,因而可用于制取三(2-呋喃基)硼烷,并可以得到乙醇胺配合物1的稳定形式。乙醇胺合三(2-呋喃基)硼烷(1)可在稀酸中游离出三(2-呋喃基)硼烷,可与吡啶形成吡啶合三(2-呋喃基)硼烷2;化台物1中的呋喃环被8-羟基喹啉或8-羟基喹哪啶裂开以后,分别形成含 B-N 内配键的二呋喃基硼螯合物3及4。化合物1～4均经元素分析及有关波谱鉴定。     

利用跟踪TPR—GC和XRD技术考察LaNiO3的还原机理

钙钛矿型复合氧化物对许多反应具有较高的催化活性,它们被广泛地用作CO氧化的催化剂.陈水华等对SmMeO_3(Me:V、Cr、Mn、Fe、Co)和Tascon等对LaMeO_3(Me:V、Cr、Mn、Fe、Co、Ni)上CO催化活性评价说明,LnMnO_3和LnCoO_3(Ln=La、Sm)活性最好,而LaNiO_3则表现和LaCoO_3相似活性,由此可推断这些氧化物具有相似的催化性能.本文用TPR-GC和XRD考察了在还原气氛下,LaNiO_3的还原机理,这对研究其电、磁特性具有一定的指导意义.     

MoO3、NiO、ZnO在小表面金红石上的分散行为

Dispersion of MoO3, NiO, ZnO on rutile TiO2 with low specific surface area was studied with Mercury Porosimeter, SEM, XPS and Ammonia Extraction method. The dispersion thresholds of MoO3, NiO, ZnO on three rutile TiO2 carriers were obtained with XPS, and com-pared with those on anatase TiO2 with high specific surf are area. Ammonia Extraction method was used to identify the surface oxide species interarting with support surface in different strength and it was found that the proportions of oxides that can not be extracted by ammonia extraction are different for MoO3, NiO and ZnO which are supported on rutile TiO2.     

UO2、UC2和UCO分子的结构和热力学性质

用密度泛函B3LYP方法,计算了UO2、UC2和UCO分子的结构和热力学函数,计算了固体U的振动内能Ev、振动和电子熵Sev,以及U在不同气氛（O2、C2、CO）中形成UO2、UC2和UCO晶体的ΔHfΘ、ΔSfΘ和ΔGfΘ.结果表明,UO2晶体最稳定.     

含有羧基配体的蝎型钒氧配合物的合成、结构及其热分解动力学

设计合成了两种新型的以聚吡唑硼酸盐、氨基酸为配体的钒氧配合物VO[phCH2CH(NH2)COO][HB(pz)3](1)和VO(3,5-Me2pz)[HB(3,5-Me2pz)3](CH3COO)(2). 通过元素分析、红外光谱对配合物进行了表征, 并利用单晶X射线衍射技术解析了它们的结构. 非等温热分解动力学研究表明, 配合物1和2的热分解反应都是分两步进行的. 通过计算, 配合物1热分解的第一步反应的可能机理为成核与生长(n=1/4); 第二步反应的可能机理为化学反应. 其非等温动力学方程分别为, dα/dT=(A/β)e-E/RT(1/4)(1-α)[-ln(1-α)]-3 和dα/dT=(A/β)e-E/RT(1-α)2. 分解反应的表观活化能分别是223.52 和331.94 kJ·mol-1; 指前因子ln(A/s-1)分别是49.67 和57.50. 配合物2 热分解的第一步反应的可能机理为化学反应; 第二步反应的可能机理为成核与生长(n=1/2). 其非等温动力学方程分别为, dα/dT=(A/β)e-E/RT(1-α)2, 和dα/dT=(A/β)e-E/RT(1/2)(1-α)[-ln(1-α)]-1. 分解反应的表观活化能分别是300.56 和444.72 kJ·mol-1; 指前因子ln(A/s-1)分别是75.53 和92.50.