CURING KINETICS AND PROPERTIES OF ACRYLIC RESIN CURED WITH AZIRIDINE CROSSLINKER

A kind of aziridine crosslinkers was synthesized and used to crosslink acrylate copolymers. The crosslinkingproperties and curing kinetics of the resin were studied. It was found that with the increase of the content of crosslinker in theemulsion, the mechanical properties and solvent resistance of the resin will be apparently improved, but its glass transitiontemperature (T_g) is very low. The lowest amount of crosslinker used in the acrylic resin emulsion is 0.25%. Curing kineticsstudied by DSC show that this curing reaction occurs readily because the apparent activation energy of the reaction is low(65.1 kJ/mol). These results demonstrate that the aziridine crosslinker is indeed a low temperature crosslinking agent and canbe used at room temperature.     

A Novel Plasticizer for the Preparation of Thermoplastic Starch

TPS was a biodegradable material based on starch. Starch was an inexpensive and natural renewable polysaccharide, which was widely investigated as the substitute of petroleum-derived plastics. Native starch commonly existed in granule structure with about…     

ADSORPTION OF 4-METHYLANILINE IN AQUEOUS SOLUTION BY BENZOYL-CONTAINING POLYMERIC ADSORBENTS

New polymeric adsorbents (ZH-02, ZH-03) containing benzoyl group for adsorbing and removing 4-methylaniline from its aqueous solutions were prepared. Studies on the isotherms and the comparison of desorption conditions evidenced through the adsorption of 4-methylaniline in water onto ZH-02 and ZH-03, namely that there are chemisorption‘s transitions at a proper higher temperature. Mini-colunm adsorption studies of 4-methylaniline on XAD-4, ZH-02 and ZH-03 at 288 K show that the breakthrough capacities are 2.39, 2.99 and 3.19 mmol/g and the total capacities are 3.45, 3.92 and 4.35 mmol/g, respectively.     

Enhanced Acid/Base Catalysis in High Temperature Liquid Water

High temperature liquid water (HTLW), as an environmentally benign medium, has drawn increasing attention for organic chemical reactions and biomass conversion1-3. HTLW has a strong tendency to ionize and can act as an acid and/or base catalyst. In addition, HTLW can dissolve organic compounds to some extent allowing for a homogenous reaction within an aqueous phase. Extensive researches4-10 have been pursued on acid/base-catalysis reactions in HTLW without addition of acid or base. Howe…     

Electroreduction of α-glucose on CNT/graphite electrode modified by Zn and Zn–Fe alloy

Electroreduction of -glucose to form sorbitol on Zn/CNTs and Zn alloy/CNTs electrodes has been investigated in this paper. Carbon nanotubes (CNTs) used in this paper are grown directly on graphite disks by chemical vapor deposition. Zn and Zn alloy are electrodeposited on the activated CNTs/graphite electrode by pulse galvanostatic method. The micrographs of Zn/CNTs and Zn alloy/CNTs electrodes are characterized by scanning electron microscopy. The results show that the current efficiency of -glucose reduction on CNTs electrodes is much better than that on flat Zn electrodes. The order of the current efficiency on different electrodes is as follows: Zn/CNT (0.58) Zn–Fe/CNT (0.57)>Zn–Ni/CNT (0.43) Zn/graphite (0.42)>Zn (0.40). It indicates that CNTs have good potential application in electrosynthesis. Additionally, effects of some operating parameters, such as pH, temperature and -glucose concentration, on the current efficiency of -glucose reduction are also discussed.     

氧化锶催化性质：Ⅱ.SrO,MgO上异丙醇的分解反应

ＳｒＯ，ＭｓＯ对异丙醇的分解反应有各自的作用形式，因而产物分布也有明显差别．ＭｇＯ上异丙醇分解，在较低温度时，主要产物为丙酮和丙烯；随温度升高，生成丙烯的量增加，而丙酮的量减少，直至消失，在ＳｒＯ上，异丙醇在较高温度时反应，产物几乎为丙酮，丙烯的生成量极少。认为：产物中丙烯来源于异丙醇在催化剂表面强酸中心上的脱水；丙酮在ＭｇＯ上来源于强碱中心和酸中心协同作用异丙醇的脱氢，而在ＳｒＯ上则是ＳｒＯ表面极强的碱中心作用异丙醇而脱氢制得。     

生物质在流化床中的空气-水蒸气气化研究

以流化床为反应器，对生物质的空气-水蒸气气化特性进行了研究。考察了一些主要参变量，如温度 (700 ℃～900 ℃)、水蒸气/生物质比(0～4.04)、空气当量比(0.19～0.27)以及生物质粒度(0.2 mm～0.9 mm)等对气化结果的影响。在实验研究的条件范围内，生物质产气率在1.43 m3/kg～2.57 m3/kg范围内变化，产气的低热值在6 741 kJ/m3～9 143 kJ/m3范围内变化。实验结果表明：较高的气化温度有利于氢的产生；但气化温度过高会使气体热值下降；与常规的空气气化相比，水蒸气的加入使生物质气化产气率显著提高，但水蒸气加入量过多使气化温度下降，产气率和产气热值降低；生物质颗粒粒度的大小对产气组分的分布和产气率均有影响，较小颗粒的生物质会产生较多的CH4、CO和较少的CO2。     

Two New Xanthone Glycosides from Polygala tenuifolia

Two new xanthone glycosides,polygalaxanthone IV and V were isolated from the roots of Polygala tenuifolia Willd. Their structures were established as 6-O-[α-L-rhamnopyranosyl-(1→2)-β-D-glucopyranosyl]-1-hydroxy-3,7-dimethoxyxanthone(polygalaxanthone IV), and 6-O-[α-L-rhamnopyranosyl-(1→2)-β-D-glucopyranosyl]-1,3-dihydroxyl-7-methoxyxanthone (polyga-laxanthone V),respectively, on the basis of chemical and spectral evidence.     

LaNi4.7Al0.3单颗粒微电极电化学行为的研究

报道了一种单颗粒微电极制备新方法, 并研究了LaNi4.7Al0.3球形单颗粒微电极的电化学行为.     

液化石油气水蒸气重整镍催化剂新型载体研究

以共沉淀法合成了硅铝系载体（AS和SA），并采用改性天然高铝石为原料合成了矿物质载体（MC-1和MC-2）,采用浸渍法合成了镍负载型催化剂。用常压固定床管式反应器，考察了液化石油气水蒸气重整反应活性，通过XRD、物理吸附等手段对催化剂进行了表征。结果表明，以MC-1、MC-2和SA、AS为载体的催化剂的水蒸气重整活性明显高于目前普遍使用的Ni/α-Al2O3催化剂。以SA为载体，负载5%镍的催化剂具有最好的水蒸气重整活性。在750 ℃，水碳比为2.0的条件下转化率达100％，C1选择性达94.46％。XRD分析结果表明1 300 ℃焙烧后的SA载体中存在α-Al2O3晶型和莫来石结构。硅、铝添加次序对水蒸气重整活性影响较大，硅-铝添加次序的催化剂样品的活性高于铝-硅添加次序的样品，C1选择性提高12.7％。