Ce0.8Y0.2O1.9-Ca3(PO4)2-K3PO4复合电解质在中温区的质子导电性及在常压合成氨中的应用

A precursor of Ce_0.8Y_0.2O_1.9(YDC) solid electrolyte was synthesized by the gol-gel method. YDC and phosphates powders were prepared by mixing the YDC and phosphates according to different weight ratios. The mixtures of the YDC and binary phosphates were ground and sintered at 1 400 ℃. The proton conductivity in solid electrolyte of the sintered samples was examined using electrochemical methods at 400～800 ℃. Ammonia was synthesized from nitrogen and hydrogen at atmospheric pressure in the solid state proton conducting cell reactor. The optimal condition for the ammonia production was determined. The result indicated that composite electrolyte of 80wt% YDC: 20wt% binary phosphates as proton conductor could obtain the highest ionic conductivity and ammonia production rate among the four samples, the rate of evolution of ammonia was up to 9.5 × 10^-9 mol·s^-1·cm^-2.     

中孔分子筛SO42-/Zr-MCM-41催化裂解聚丙烯反应研究

采用水热合成法制备了不同硅锆比的中孔分子筛Zr-MCM-41,用强酸性基团SO42-对其进行修饰,制得SO42-/Zr-MCM-41中孔分子筛.采用XRD、FT-IR、NH3-TPD及氮气吸附脱附等技术对其结构和酸强度进行表征.通过改变硅锆比、负载不同的酸性基团对Zr-MCM-41的酸性进行调变,并将其用于催化聚丙烯(PP)的裂解反应,结果表明S i/Zr=40的SO42-/Zr-MCM-41具有较好的催化裂解活性.另外,与热裂解以及HZSM-5和Zr-MCM-41为催化剂时PP的裂解反应结果进行了比较,结果证明SO42-/Zr-MCM-41不仅具有较高的裂解转化率,而且具有较高的液体产物收率,适宜于空间位阻较大的PP的催化裂解反应.     

REE AND Sr, Nd, Pb ISOTOPIC GEOCHEMISTRY OF HUANGYISHAN BASALT, KUANDIAN, LIAONING, NORTHEAST CHINA

In the light of major element geochemistry, mineral chemistry and REE and isotopic data, the small but apparent isotopic differences between the Cenozoic volcanic rocks east and west of the Tancheng-Lujiang fault are believed to be caused by the mixing and metasomatism of crustal and mantle material in tho mantle source region in response to Pacific plate subduction. The presence of phlogopite and pargasite in mantle xenoliths lends strong support to mantle metasomatism.     

8-羟基喹啉单体及二聚体质子转移反应的理论研究

Density functional theory （DFT） of quantum chemistry method was employed to investigate proton transfer reactions of 8-hydroxyquinoline （8-HQ） monomers and dimers. By studying the potential energy curves of the isomerization, the most possible reaction pathway was found. The total energy of 8-hydroxyquinoline was lower than that of quinolin-8（1H）-one, whereas the order was reversed in dimers. The findings explained the contrary experimental phenomena. The minimum reaction barrier of intramolecular proton transfer was 47.3 kJ/mol while that in dimer was only 25.7 kJ/mol. Hence it is obvious that proton transfer reactions of 8-HQ monomer have a considerable rate but it is easier to proceed for 8-HQ dimer than monomers. It implied that the hydrogen bond played an important role in depressing the activation energy of reaction. The mechanism of the tautomerization was discussed on the basis of theoretical results.     

芴取代的有机膦化合物的合成及发光性能

合成了以芴为取代基，P原子为核的一类新型有机膦化合物．此类化合物的HOMO值在-5．35～-5．24eV之间．在二氯甲烷中的最大紫外吸收光谱峰值在313～351nm之间，荧光光谱峰值在334～397nm之间．利用此类小分子与纯聚芴进行掺杂，制作了有机电致发光器件．低HOMO值有机膦化合物的引入有效地降低了聚芴发光器件的开启电压，提高了器件的发光效率．     

Et2NH2[Nd(S2CNEt2)4]的晶体结构和生成反应焓变

在干燥氮气气氛下,以无水乙醇为溶剂,制备了低水合氯化钕与二乙氨基荒酸二乙铵(D-DDC)配合物,确定其组成为Et2NH2[Nd(S2CNEt2)4].单晶结构分析表明,配合物中4个二乙氨基荒酸根各通过2个硫原子与钕离子成键形成八配位十二面体阴离子,并与二乙铵阳离子形成缔合型分子.晶体属单斜晶系,空间群P21/n,a=1.37517(14)nm,b=2.1146(2)nm,c=1.44641(15)nm,β=102.028(2)°,Z=4.用微量热法测定了298.15K下水合氯化钕和D-DDC在无水乙醇中的溶解焓及二乙氨基荒酸钕液相生成反应焓变分别为(-17.89±0.096),(50.280±0.151)和(-10.116±0.065)kJ/mol,求得固相生成反应焓变.     

B2O3/TiO2-ZrO2催化环己酮肟气相Beckmann重排反应研究 Ⅰ.B2O3含量的影响

 制备了不同B2O3含量（0～20％）的B2O3／TiO2－ZrO2固体酸催\r\n化剂，用XRD，FT－IR，N2吸附及NH3－TPD等方法测定了其结构、比表\r\n面积、孔分布和表面酸性．结果表明，当B2O3含量较低（≤5％）时，\r\n催化剂呈无定形态，样品中的B2O3主要以BO4结构存在．当B2O3含量较\r\n高（≥8％）时，催化剂中的TiO2－ZrO2以ZrTiO4晶相存在，分散于Ti\r\nO2－ZrO2表面的B2O3主要以玻璃体形式和BO3结构存在．随着B2O3含量\r\n的增加，催化剂的比表面积减小，孔径增大．300℃下的环己酮肟气相\r\nBeck－mann重排反应结果表明，随着B2O3含量的增加，己内酰胺的选择\r\n性逐渐增大，而己内酰胺的收率在B2O3含量为12％时达到最大值．讨论\r\n了B2O3／TiO2－ZrO2的催化性能与其表面酸性及孔径大小的关系．     

季铵盐固相催化使聚氯乙烯脱HCl

通过将季铵盐与聚氯乙烯(PVC)混溶成膜,使其在固相脱HCl,研究了催化剂对PVC脱HCl反应速度和产物结构的影响以及固相反应与温度、时间的关系.发现在催化性能上下基铵盐比乙基铵盐好得多,根据实验结果提出了季铵盐通过分解成叔胺实现催化的机理.     

星状四芳胺类空穴传输材料的合成

有机电致发光器件 (ＯＥＬＤ)是继阴极射线管平板显示器 (ＣＲＴ)和液晶显示器 (ＬＣＤ)之后的第三代平板显示器。它具有主动发光、驱动电压低(2伏左右 )、发光亮度高 (1 3 0 0 0ｃｄ ｍ2 以上 ) ,无软Ｘ 射线污染 ,响应速度快 (1 0 -6 ～ 1 0 -8秒 )等优点。从 1 987年美藉华人邓清云等提出多层结构的ＯＥＬＤ的器件结构以来的十多年间 ,ＯＥＬＤ以及其材料的研究已成为显示技术以及显示材料等方面的研究热点 ,发展很快[1～ 3] 。在 1 999年日本先锋公司已开发出了单色的汽车用ＯＥＬ平板显示器商品 ,今年东芝公司又开发出了 2 .7英寸的彩…     

热致液晶共聚酯酰胺／PET共混物的流变性能和原位增强特性

采用Ｉｎｓｔｒｏｎ３２１１型毛细管流变仪研究了ＰＥＡ／ＰＥＴ共混物的流变性能，据此探讨共混物熔体的可纺性，讨论了共混物配比与复合纤维力学性能的关系，并且偏光显微镜，扫描电镜研究纤维的结构。结果表明，共混物的表观粘度低于ＰＥＴ的粘度，当ＰＥＡ为１０％，共混物的表观粘度达到最小值；且ＰＥＡ含量低于１０％时，共混物的可纺性即，表现出良好的原位增强效果。