PINNING EFFECT OF LEAD LANTHANUM TITANATE THIN FILMS DEPOSITED ON DIFFERENT SUBSTRATES

Pinning effect of lead lanthanum titanate (PLT) ferroelectric thin films with excess PbO of 20 mol% has been studied for deposition on diffe rent substrates. Silicon, sapphire and quartz were used as substrates on which P t/Ti or LaNiO₃ thin films were deposited as bottom electrodes. Electron probe analysis results showed that there was still a certain amount of excess Pb in PLT films after annealing at 550 ℃ for 1 h, and the amount of it was dependent on the substrate used. The distribution of excess Pb in the films was investig ated by Auger electron spectroscopy depth profile. It was shown that the substrates and the bottom electrodes had significant effects on the content and distrib ution of excess Pb in PLT films. The excess Pb and its accumulation at the inter face between the film and bottom electrode may act as pinning centers and have a pinning effect on domains, which can be observed by abnormal P-E hysteresis loops and abnormal C-V curves. The excess Pb content in the films and the accumulation of Pb at the interface were high in PLT films deposited on Pt/Ti/S i, and considerable pinning effect was observed. As LaNiO₃ would absorb most part of the excess Pb in PLT films, the content of excess Pb in the films deposited on LaNiO₃/Si was very low and the pinning effect was hardly observed.     

纳米复合固体超强酸SO_4~(2-)/ZrO_2-Fe_2O_3的制备及其催化合成硝基苯的研究

采用纳米化学技术制备了新型的纳米复合固体超强酸催化剂SO42-/ZrO2-Fe2O3,并用XRD、TEM进行了表征.结果表明:所研制的SO42-/ZrO2-Fe2O3催化剂为晶态纳米粒子,平均粒径为30 nm,分散性较好;当活化温度为580℃,反应温度为75℃,n(硝酸)/n(苯)=2,m(苯)/m(催化剂)=20,催化反应时间5 h时,硝基苯收率可达89.6%.     

PEO-LiClO_4-ZSM5 composite polymer electrolyte (IV): Polarized optical microscopy study

All solid-state lithium polymer batteries may be one of the best choices for the future electrochemical power source, characterized by high energy densities, good cyclability, reliability and safety[1,2]. Owing to its potential capability to replace the t…     

STUDY ON THE EFFECT OF POLYSTYRENE SULFONIC ACID MACROMOLECULES ON THE POLYMERIZATION OF ACRYLAMIDE

The effect of polystyrene sulfonic acid (PSSA) macromolecules on the polymerization of acrylamide (AM) has been studied. It was found that the rates of polymerization of AM were greatly increased in the presence of PSSA in the polymerization system.The maximum value of the rate of polymerization of AM was obtained when the ratio of [—SO_3H]: [AM] reached 3:1. When the insoluble crosslinked PSSA was used instead of the soluble one, this effect decreased considerably. The interaction between molecules of PSSA and AM was determined by infrared spectroscopy, elementary analysis and X-ray photoelectron spectroscopy. The combination form, —SO_3-NH_3~ CO—, formed between sulfonic group and amide group was found to be existed since the infrared absorption band of —NH_2 shifted from 3400cm~(-1) to 3150 cm~(-1), the binding energy of electron N_(18) changed from 399.7 eV to 401.3 eV, and the atomic ratio of N to S of the products was similar to the ratio of reagents. Based on these experimental results, the mechanism of AM polymerization in the presence of PSSA is proposed. The initial step is the combination of AM with sulfonic group to form —CONH_3~ , then followed by polymerization on the PSSA macromolecule. The role of PSSA on the polymerization of AM is discussed.     

Morphology Control over the Organic Nanoparticles of 1,3-Diphenyl-5-（9-anthryl）-2-pyrazoline

The organic nanoparticles of a blue-light-emitting molecule, 1,3-diphenyl-5-(9-anthryl)-2-pyrazuline, were prepared by reprecipitation method using acetonitrile as the solvent for the molecular precursor. Three morphologies, spherical, doughnut-shaped and cubic, could be observed on the silicon substrate forthe nanoparfides by the volume-controlled addition of acetonitrile. The evolution of particle morphology as a function of acetonitrile addition was attributed to the variation of the growth habits of the particles in the different environment. The nanoparticles exhibit the novel photoluminescence spectra as compared to those of monomer and the bulk crystals.     

气固吸附等温线的研究进展

综述了近些年来在气固吸附理论研究领域对吸附等温线的研究进展。论述了从早期的BDDT的5种类型吸附等温线，到IUPAC的6种类型吸附等温线，再到基于Ono-kondo晶格模型的Gibbs吸附分类的5种类型吸附等温线．讨论了与各种类型吸附等温线类型相对应的吸附机理，并对滞留回环现象进行了解释和分析。     

硫堇褪色光度法测定微量肝素

在pH 4.10的Britton-Robinson缓冲溶液中,肝素与碱性吩噻嗪染料硫堇形成离子缔合物时,染料发生明显的褪色。体系吸光度的降低与肝素钠浓度成正比,肝素的质量浓度在0~60μg/25 mL范围内符合比耳定律,摩尔吸光系数为3.58×106L.mol-1.cm-1。研究了表面活性剂和共存物质的影响,表明方法选择性好。用于肝素钠注射液效价的测定,相对标准偏差小于3%,回收率为96.5%~101.9%。     

甲基丙烯酸三苯墓甲酯和甲基丙烯酸酯类的共聚物在溶液中的螺旋诱导和解旋作用

甲基丙烯酸三苯墓甲酯和甲基丙烯酸酯类的共聚物在溶液中的螺旋诱导和解旋作用陈传福，刘卫宏，陈永明，任长玉，习复（中国科学院化学研究所北京１０００８０）关键词甲基丙烯酸三苯基甲酯，甲基丙烯酸甲酯，光学活性，螺旋诱导，解旋在手性阴离子复合引发剂存在下，甲基...     

STRUCTURE AND PROPERTIES OF P(MMA-MAA)/PEO INTERMACROMOLECULAR COMPLEX FORMED THROUGH HYDROGEN BONDING

The superstructure and properties of polymers might be improved and enhanced througl intermolecular complexation. In this paper, the preparation, structure and properties of P(MMA-MAA)/PEO intermolecular complex through hydrogen bonding are studied. By acid hydrolysis of PMMA, a series of P(MMA-MAA) copolymers have been prepared, the MAA content of which depends on the temperature and time of hydrolyzation. In case the MAA content in P(MMA-MAA) is beyond 0.4 mole fraction, the hydrogen bonding between P(MMA-MAA) and PEO is strong enough to form intermolecular complex. The supermolecular structure of the complex is quite different from that of its constituent, which was observed by an X-ray diffraction and transmission electron microscope. The crystallization of PEO is confined owing to complexation. The complex exhibits quite a lot of good properties in thermal stability, gas permeability as well as mechanical strength, and could be used in many fields.     

基于改进三维块匹配滤波的红外全息降噪算法北大核心CSCD

红外全息技术更适用于长距离的大视场成像,但其散斑噪声与高斯噪声对图像质量的影响也更加显著,限制了红外全息技术的应用与推广。本文通过引入全局傅立叶阈值与自适应维纳滤波的方法对三维块匹配滤波算法进行优化,提高了其对红外全息图像降噪的适应性与细节保留,得到改进的三维块匹配滤波算法,并与多种采用传统滤波方法的结果进行了对比。结果表明,改进后的算法可以在对红外全息图像中的高斯噪声等环境噪声与散斑噪声进行降噪的同时保留更多细节,是一种更加适用于红外全息图像的降噪方法。