Chemoselective Removal of Acyloxy in 1-(Benzotriazole-1-yl)alkyl Esters and Its Application in the Preparation of β-(Benzotriazole-1-yl)alcohols

Mediated by samarium diiodide, 1-(benzotriazole-1-yl)alkyl esters 1 underwent cross-coupling with aldehydes or ketones to afford β-(benzotriazole-1-yl)alcohols 2 exclusively with the selective removal of acyloxy over benzotriazolyl.     

Solubility of Icariin in a Binary Solvent System of Ethanol and Water

The solubility of icariin in the binary solvent system of ethanol and water was measured by UV–Vis spectrophotometry from 288.2 to 328.2 K. The solubility of icariin in the system increased with increasing temperature. A synergistic effect appeared at x ₂ = 0.4 (equivalent to 68.34 % ethanol, v/v) binary mixture. Solubility data were correlated with the modified Apelblat equation. The enthalpy and entropy of solution were evaluated using van’t Hoff plots.     

Effect of partial crosslinking on morphology and properties of the poly(β-hydroxybutyrate)/poly(d,l-lactic acid) blends

Poly(β-hydroxybutyrate) (PHB) is a bio-based and biodegradable aliphatic polyester, however its application is limited by some disadvantages such as high price, brittleness, poor processability and low melt-strength due to serious thermal degradation. Partial crosslinking initiated by dicumyl peroxide (DCP) was applied in this work to improve the performance of poly(β-hydroxybutyrate)/poly(d,l-lactic acid) (PHB/PDLLA) blends. The partial crosslinking of the blends and its effect on the properties, morphology, rheology and thermal behavior of the blends were investigated. The tensile strength and impact toughness of the PHB were increased by incorporation of the PDLLA, which were improved further after the partial crosslinking because of an increased compatibility between the PHB and the PDLLA phases. The rheological study revealed that the storage modulus (G′) and complex viscosity (η*) of the blends were increased after addition of the DCP. On the other hand, the crystallization of PHB in the blends was restricted to a certain extent by the formation of partially crosslinked network while its crystal form was not modified.     

免疫亲和柱净化-液相色谱-串联质谱法同时测定猪肉中6种玉米赤霉醇类化合物残留量

建立了猪肉中6种玉米赤霉醇类化合物残留量的免疫亲和柱净化-液相色谱-串联质谱(IAC-LC-MS/MS)分析方法。酶解后的样品用乙醚提取,提取液浓缩后用三氯甲烷溶解,NaOH溶液反萃取,经免疫亲和柱富集和净化后,采用LC-MS/MS进行测定,外标法定量。在Shimadzu Shim-pack VP-ODS C18反相柱上分离,梯度洗脱,流动相为乙腈和2 mmol/L乙酸铵溶液;质谱采集为电喷雾负离子多反应监测模式。6种目标物的线性范围为0.5～200μg/L,相关系数(R)大于0.999,定量限(LOQ)在0.05～0.63μg/kg之间;添加浓度在1.0～5.0μg/kg范围内,方法回收率为71.3%～93.7%,相对标准偏差在3.7%～9.7%之间。该方法灵敏度高、重现性好,适用于猪肉样品中痕量玉米赤霉醇类药物残留的测定。     

纳米铜/石墨烯修饰电极用于离子交换色谱测定五种单糖

把纳米铜和石墨烯修饰在玻碳电极表面,制备了纳米铜/石墨烯复合修饰电极。采用电化学方法,在!1.5~0 V的循环扫描电位条件下,氧化石墨烯(GO)和Cu2+同时在玻碳电极上被电化学还原,形成石墨烯(Gr)和纳米铜(CuNPs)复合膜。所制备的修饰电极对葡萄糖等单糖化合物具有较高的电催化活性,且电极稳定性和重现性均良好。将此修饰电极作为电化学检测器,与高效阴离子交换色谱联用,分离测定了5种单糖化合物(岩藻糖、阿拉伯糖、半乳糖、葡萄糖和甘露糖)。结果表明,岩藻糖和阿拉伯糖的线性范围为0.1~100 mg/L,半乳糖、葡萄糖和甘露糖的线性范围为0.5~100 mg/L,5种单糖化合物的线性相关系数均大于0.998,相对标准偏差RSD(n=6)为1.9%~2.5%,检出限在0.02~0.10 mg/L之间;将此方法用于测定样品桑黄粗多糖的单糖组成,测得5种单糖的回收率为84.8%~94.5%,准确度和精密度均较好。     

酸碱解聚玉米秸秆分子结构的实验研究

以玉米秸秆为研究对象,分别采用5%H2SO4和5%NaOH溶液对秸秆进行解聚处理,并对解聚前后秸秆结构、化学组成、热稳定性等进行分析和表征。结果表明,与未处理前相比,经酸或碱解聚处理后,秸秆纤维结晶度由51.8%分别提高到63.5%和67.0%,秸秆中大部分半纤维素和部分木质素组分被脱除,半纤维素由29.10%分别降至7.02%和6.86%,木质素由38.12%分别降至32.21%和16.52%,而纤维素则由31.54%分别升至60.54%和76.15%。经酸碱处理后,秸秆表面形态结构变得疏松,出现小孔和裂缝,降解温度达到350℃,热稳定性能增加。上述结果说明,稀酸或稀碱均对玉米秸秆分子结构有一定程度的解聚作用,但就解聚溶出木质素而言,稀碱的解聚溶出效果要优于稀酸的。     

顺铂耐药的分子机制

顺铂被广泛用于多种类型的实体肿瘤的临床治疗.DNA是顺铂的主要靶点,顺铂结合会导致DNA损伤并诱发细胞凋亡.然而,顺铂化疗常常受到内在的和获得性的耐药性的限制.在过去30多年里,大量的研究致力于对顺铂耐药性的理解,并且提出了几种导致顺铂耐药性的分子机制.这些机制显示顺铂的耐药性具有多因素特征.本文系统描述和讨论了顺铂的耐药性机制,包括细胞内药物积累的减少,药物去活作用的增强,DNA修复作用,DNA损伤反应和凋亡通路的变化以及一些间接信号通路的调控影响.     

Highly Efficient Orange and Warm White Phosphorescent OLEDs Based on a Host Material with a Carbazole–Fluorenyl Hybrid

A new carbazole–fluorenyl hybrid compound, 3,3′(2,7‐di(naphthaline‐2‐yl)‐9H‐fluorene‐9,9‐diyl)bis(9‐phenyl‐9H‐carbazole) (NFBC) was synthesized and characterized. The compound exhibits blue‐violet emission both in solution and in film, with peaks centered at 404 and 420 nm. In addition to the application as a blue emitter, NFBC is demonstrated to be a good host for phosphorescent dopants. By doping Ir(2‐phq)₃ in NFBC, a highly efficient orange organic light‐emitting diode (OLED) with a maximum efficiency of 32 cd A^?1 (26.5 Lm W^?1) was obtained. Unlike most phosphorescent OLEDs, the device prepared in our study shows little efficiency roll‐off at high brightness and maintains current efficiencies of 31.9 and 26.8 cd A^?1 at a luminance of 1000 and 10 000 cd m^?2, respectively. By using NFBC simultaneously as a blue fluorescence emitter and as a host for a phosphorescent dopant, a warm white OLED with a maximum efficiency of 22.9 Lm W^?1 (21.9 cd A^?1) was also obtained.     

·OH自由基引发CH3SSCH3•+自由基裂解反应机理的理论研究

采用UωB97X-D/6-311+G^**方法, 研究了气相、 甲苯和水中OH自由基(·OH)引发CH₃SSCH₃自由基阳离子(CH₃SSC{\mathrm{H}}_{\mathrm{3}}^{?}⁺, DMDS^?+)裂解的反应机理, 并讨论了溶剂效应对反应的影响. 结果表明, ·OH和DMDS^·+首先形成自由基耦合产物CH₃S(OH)SCH₃⁺(R1)和氢提取产物复合物[CH₂=SSCH₃+H₂O]⁺(R2); 随后R1裂解直接发生 S—S键断裂协同质子转移, 而R2裂解依次发生构象变化、 C=S键亲碳加成和S—S键断裂协同质子转移. 去质子化的裂解产物为CH₃SOH, CH₂=S和HSCH₂OH. 甲苯略微降低了裂解反应速控步骤的自由能垒. 水溶剂有利于R1裂解, 但不利于R2裂解, 尤其是单个水分子参与反应. 在气相、 甲苯和水中, 以·OH和DMDS^·+为初始反应物, 虽然速控步骤的自由能垒为167.6~202.8 kJ/mol, 但裂解反应均是放热反应(?154.3~?31.4 kJ/mol).     

热力学数据对1, 3-丁二烯燃烧特性的影响

基于G4方法, 计算了1,^{3-丁二烯框架燃烧反应机理中102个物种的热力学数据, 并考察了振动非谐性、 频率校正因子以及受阻内转动对结果的影响. 结果表明, 考虑振动非谐性或采用不同的频率校正因子, 对热力学数据的影响不大; 考虑内转动后, 对热力学数据有较大影响. 而且考虑内转动后, 得到的热力学数据与实验热力学数据吻合得更好. 用所得热力学数据模拟了1,3-丁二烯的绝热燃烧温度以及点火延迟时间, 结果显示, 要得到可靠的绝热火焰温度, 对小分子(如CO和CO₂等)的热力学数据需要采用实验结果. 将用所得热力学数据模拟得到的点火延迟时间, 与机理本身的热力学数据所得点火延迟时间进行对比, 二者差别显著, 表明所得热力学数据主要通过改变一些反应的逆反应速率常数来影响点火延迟时间. 进一步确定了用所得热力学数据对点火延迟时间有显著影响的一些物种.}