面向方向图保形的共口径基站天线去耦技术

为了节省基站天线所占空间资源,降低其运营成本,现代移动通信需要将多个天线阵列紧密地排列在一起,构成多频共口径基站天线。多天线的紧密排列势必造成天线间强烈的耦合,不仅使得天线阻抗失配、隔离度变差,同时也造成辐射方向图的严重变形。因此,近年来多频共口径基站天线的去耦成为工业界和学术界研究的热点,早期的去耦技术主要是面向改善天线的阻抗匹配和隔离度,而对面向方向图保形的去耦技术研究相对较少。文章在简要介绍面向方向图保形的基站天线去耦技术的研究现状的基础上,重点阐述了褚庆昕教授天线射频团队基于感应电流抵消、耦合场抵消和辐射阻断等原理,提出的几种新型的去耦技术。这些技术不仅可以有效地改善基站天线的阻抗匹配和隔离,更重要的是很好地实现了天线方向图保形。仿真和测试结果验证了原理的正确性和设计的可行性。一些技术已被用于5G基站天线产品。     

Weak signal detection and adaptive synchronous stability of a novel fifth-order memristive circuit system

This paper is devoted to introduce a novel complex fifth-order memristive circuit system and its applications in synchronous stability and weak signal detection. Firstly, the typical dynamical behaviors of the memristive system are discussed by chaotic phase portrait, complexity analysis, one-parameter bifurcation and Lyapunov exponent spectrum. Secondly, the adaptive control method is applied to realize the synchronization between the drive memristive system (DMS) and the response memristive system (RMS). The results indicate that the synchronization method has strong robustness and anti-interference ability. Thirdly, the weak signal detection of the novel five-dimensional memristive system is realized by using the extreme sensitivity of chaotic system to initial values. Finally, the fifth-order memristive circuit is designed by using basic electronic elements and simulated by Multisim software. And the anti-interference ability and sensitivity of the fifth-order memristive circuit are further verified by adding different weak disturbance signals at different positions of the circuit.     

主动干扰辅助下的无人机隐蔽通信功率与位置联合优化

利用友好干扰节点发送人工噪声是无线隐蔽通信中一种常见实现方法,可以增加监听者做出判断的不确定性,从而实现隐蔽传输。为此,考虑在无人机隐蔽通信网络中,部署一个空中的友好干扰节点,发射人工噪声干扰地面监听者的检测。对无人机与地面用户之间实现无线隐蔽传输进行了研究,分析了其有效隐蔽性能,联合优化了2架无人机的发送功率和位置部署以最大化隐蔽传输速率,使用粒子群优化算法与功率位置交替迭代算法2种优化方法得到最优的无人机部署位置及功率分配方案。仿真结果表明,联合优化方案相比于固定位置只优化功率的基准方案可以显著地提高系统隐蔽传输性能,且交替迭代算法所得结果要优于粒子群优化算法。     

Reflectivity measurement technology of special high reflective mirrors and uncertainty analysis of measurement results

In order to meet the reflectivity measurement requirements of any incident angle at different points of the large size special high mirror, a rotating cavity ring-down spectroscopy high reflectivity measurement system was built, in which the rotation function of the resonant cavity was set, and the lifting and parallel travelling mechanism of the measured mirror was added. Furthermore, the uncertainty of the measurement results was analyzed and calculated. The results showed that the reflectivity of a high reflective mirror measured by the system was 99.979 5%, the measurement accuracy reached the order of 10-6, and the combined standard uncertainty of reflectivity measurement was 0.002 8%. Collectively, these results provide a detection guarantee for the maintenance of the large size special high mirror, and provide ideas and methods for the uncertainty analysis of measurement results of similar equipment parameters.     

Fast Ion Transport in Li-Rich Alloy Anode for High-Energy-Density All Solid-State Lithium Metal Batteries

All-solid-state Li batteries (ASSLBs) with solid-polymer electrolytes are considered promising battery systems to achieve improved safety and high energy density. However, Li dendrite formation at the Li anode under high charging current density/capacity has limited their development. To tackle the issue, Li-metal alloying has been proposed as an alternative strategy to suppress Li dendrite growth in ASSLBs. One drawback of alloying is the relatively lower operating cell voltages, which will inevitably lower energy density compared to cells with pure Li anode. Herein, a Li-rich Li₁₃In₃ alloy electrode (LiRLIA) is proposed, where the Li₁₃In₃ alloy scaffold guides Li nucleation and hinders Li dendrite formation. Meanwhile, the free Li can recover Li's potential and facilitate fast charge transfer kinetics to realize high-energy-density ASSLBs. Benefitting from the stronger adsorption energy and lower diffusion energy barrier of Li on a Li₁₃In₃ substrate, Li prefers to deposit in the 3D Li₁₃In₃ scaffold selectively. Therefore, the Li–Li symmetric cell constructed with LiRLIA can operate at a high current density/capacity of 5 mA cm⁻²/5 mAh cm⁻² for almost 1000 h.     

Vacancy Manipulation Induced Optimal Carrier Concentration,Band Convergence and Low Lattice Thermal Conductivity in Nano-Crystalline SnTe Yielding Superior Thermoelectric Performance

Synergetic optimization of electrical and thermal transport properties is achieved for SnTe-based nano-crystalline materials. Gd doping is able to suppress the Sn vacancy, which is confirmed by positron annihilation measurements and corresponding theoretical calculations. Hence, the optimal hole carrier concentration is obtained, leading to the improvement of electrical transport performance and simultaneous decrease of electronic thermal conductivity. In addition, the incremental density of states effective mass m* in SnTe is realized by the promotion of the band convergence via Gd doping, which is further confirmed by the band structure calculation. Hence, the enhancement of the Seebeck coefficient is also achieved, leading to a high power factor of 2922 µW m⁻¹ K⁻² for Sn_0.96Gd_0.04Te at 900 K. Meanwhile, substantial suppression of the lattice thermal conductivity is observed in Gd-doped SnTe, which is originated from enhanced phonon scattering by multiple processes including mass and strain fluctuations due to the Gd doping, scattering of grain boundaries, nano-pores, and secondary phases induced by Gd doping. With the decreased phonon mean free path and reduced average phonon group velocity, a rather low lattice thermal conductivity is achieved. As a result, the synergetic optimization of the electric and thermal transport properties contributes to a rather high ZT value of ≈1.5 at 900 K, leading to the superior thermoelectric performance of SnTe-based nanoscale polycrystalline materials.     

一种面向序列密码的混合粒度并行运算单元

针对可重构密码处理器对于不同域上的序列密码算法兼容性差、实现性能低的问题,该文分析了序列密码算法的多级并行性并提出了一种反馈移位寄存器(FSR)的预抽取更新模型。进而基于该模型设计了面向密码阵列架构的可重构反馈移位寄存器运算单元(RFAU),兼容不同有限域上序列密码算法的同时,采取并行抽取和流水处理策略开发了序列密码算法的反馈移位寄存器级并行性,从而有效提升了粗粒度可重构阵列(CGRA)平台上序列密码算法的处理性能。实验结果表明与其他可重构处理器相比,对于有限域(GF)(2)上的序列密码算法,RFAU带来的性能提升为23%～186%;对于GF(2u)域上的序列密码算法,性能提升达约66%～79%,且面积效率提升约64%～91%。     

云应用程序编程接口安全研究综述:威胁与防护

云时代,云应用程序编程接口(API)是服务交付、能力复制和数据输出的最佳载体。然而,云API在开放服务和数据的同时,增加了暴露面和攻击面,攻击者通过数据劫持和流量分析等技术获取目标云API的关键资源,能够识别用户的身份和行为,甚至直接造成背后系统的瘫痪。当前,针对云API的攻击类型繁多,威胁与防护方法各异,缺乏对现有攻击和防护方法的系统总结。该文梳理了云API安全研究中云API面临的威胁和防护方法,分析了云API的演化历程和类别划分;讨论了云API的脆弱性以及云API安全研究的重要性;提出了云API安全研究框架,涵盖身份验证、云API分布式拒绝服务(DDoS)攻击防护、重放攻击防护、中间人(MITM)攻击防护、注入攻击防护和敏感数据防护6个方面相关研究工作综述。在此基础上,探讨了增加人工智能(AI)防护的必要性。最后给出了云API防护的未来挑战和发展趋势。     

基于知识图谱的信号智能运维故障树模型实现方案

城市轨道交通信号系统存在设备繁多、日常报警和故障数据量大、种类繁杂等特点,智能运维故障处置功能急需新的技术来实现。文中提出了一种基于知识图谱的信号智能运维故障树模型实现方案,针对现有故障数据建立信号系统专家知识库,使用图数据库进行存储,界面则使用故障树模型对专家系统进行可视化输出,为日常设备维护、报警分析和故障排查等提供了技术支持。     

基于机器学习的FPGA电子设计自动化技术研究综述

随着后摩尔时代的来临,现场可编程门阵列(FPGA)凭借其灵活的重复可编程特性、开发成本低的特点,现已被广泛应用于物联网(IoTs)、5G通信、航空航天以及武器装备等各个领域。作为FPGA设计开发过程中所必备的手段,FPGA电子设计自动化(EDA)技术的研究在各界得到了广泛的关注。尤其是在机器学习方法的推动下,FPGA EDA工具的运行效率和结果质量(QoR)得到了很大的提升。该文首先对FPGA EDA技术与机器学习技术的概念内涵进行了简要概述,随后综述了机器学习技术在FPGA EDA高层次综合(HLS)、逻辑综合、布局与布线等各个不同阶段应用的研究现状。最后,对基于机器学习的FPGA EDA技术的发展进行了展望。以期为本领域及相关领域的专家和学者提供参考,为后摩尔时代我国集成电路产业的发展提供技术支持。