Concentrations of hazardous heavy metals in environmental samples collected in Xiamen, China, as determined by vapor generation non-dispersive atomic fluorescence spectrometry.

Non-dispersive atomic fluorescence spectrometry (NDAFS) coupled with vapor generation (VG) sample introduction was applied to the determination of the concentrations of hazardous heavy metals, such as arsenic, cadmium, lead and mercury, in seawater, soils and total airborne particulate matter (PM) collected around the Xiamen area in China. Almost 100% sample introduction efficiency was achieved by using thiourea and ascorbic acid for the pre-reduction of As(V) to As(III), K3Fe(CN)6 and tartaric acid for pre-oxidation of Pb(II) to Pb(IV), and masking the interferences arising from the co-existing transition metals to As, Cd, Hg and Pb during their vapor generation process. Moreover, a novel sample pretreatment device was developed to avoid the loss of mercury, lead, cadmium and arsenic during sample pretreatment. With such methods, the detection limit (DL) of arsenic, cadmium, lead and mercury was down to 0.08, 0.03, 0.05, 0.01 ng mL(-1) (3sigma), respectively. The relative standard deviations (RSD, n = 11) for arsenic, cadmium, lead and mercury at 10 ng mL(-1) were 0.9%, 1.6%, 1.3% and 2.0%, respectively. The concentrations of hazardous heavy metals in the environmental samples collected in Xiamen, China are in the range from 0.02 +/- 0.001 ng mL(-1) in seawater to 15.3 +/- 0.2 microg g(-1) in soils. Besides flame/GF-AAS and ICP-AES/MS, VG-NDAFS should be another choice for the determination of hazardous heavy metals in environmental samples.     

光纤光栅选频掺Yb3+双包层光纤激光器

利用相位掩模法 ,在D形内包层掺Yb3 双包层光纤一端直接写制出Bragg光栅 ,用作双包层光纤激光器的输出腔镜 .试验得到了线宽为 0 196nm ,波长为 10 5 8 2nm ,最高输出功率为 5 70mW的稳定激光输出 ,解决了激光器中模式竞争造成的输出不稳定现象 .从速率方程出发 ,对激光器的输出功率与抽运功率、光栅反射率的关系以及最佳光纤长度进行了理论分析 ,结果与实验符合很好     

Spectra Analysis of a Novel Ti-Doped LiAlO2 Single Crystal

LiAlO2 single crvstals doped with Ti at concentration 0.2at.% are grown by the Czochralskl technique with dimensions φ42×55mm. Ti ions in the crystal are quadrivalence proven by comparing the absorption and fluorescence spectra of pure LiAlO2 and Ti： LiAlO2. After air and Li-rich atmosphere annealing, the absorption peaks in the range of 600-800nm disappear. We conclude that 682 and 756nm absorption peaks are attributed to the VLi and Vo absorptions, respectively： The peaks at 716nm and 798nm may stem from the VLi^＋ and absorptions. The colour-centre model can be applied to explain the experimental phenomena. Ti^4＋-doping produces more lithium vacancies in the LiAlO2 crystal. The intensities of [LiO4] and the associated bonds remain unchanged, which improves the anti-hydrolyzation and thermal stability of LiAlO2 crystals.     

文件静态特性评估下的木马检测机制

本文提出了一种针对木马的静态信息进行分析的新的检测机制,建立了基于BP神经网络的数据处理模型。PE文件是Windows平台下的可执行文件,也是木马等后门程序的主要载体, 由于PE文件的结构复杂、灵活,而BP神经网络摸型的自身要求,导致数据的建摸过程遇到两个难点,本文首先引入了变化粒度的概念,解决了输入端非线性数据的问题。同时,也解决了将PE文件中大量的字符串归一化(0,1)区间)的问题,最终建立了一套较为理想的解决方案,取得了较为理想的测试数据。     

Fast adders using enhanced multiple-output domino logic

Using an enhanced multiple output domino logic (EMODL) implementation of a carry lookahead adder (CLA), sums of several consecutive bits can be built in one nFET tree with a single carry-in. Based on this result, a new sparse carry chain architecture is proposed for the CLA adder. We demonstrate the design approach using a 32-b adder, and show that only four carries are sufficient for generating all sums, with a consequent reduction in the number of stage delays. Using a 1.2-μm CMOS technology, we verify our simulation procedures by fabrication and measurement of a 2.7 ns critical path     

负动量压缩因子的环形对撞机磁聚焦结构的研究

探讨了设计负动量压缩因子(α_p<0)的正负电子对撞机储存环磁聚焦结构的可行性及方法.作为应用实例,说明了设计α_p<0的τ–粲工厂磁聚焦结构的可能性.     

智能工作站主机的MMPIS实验模型研究──一个全互连式结构MMPIS硬件环境的设计与实现

本文介绍中日国际合作开发研究的Ａ１型智能网（Ａ１型ＩＮ）智能工作站（ＩＷ）主机的并行推理硬件结构的实验模型设计与实现，给出了一种并行推理硬件支持环境实现方案和该方案在实现中若干问题的解决方法。     

Study and design of step-index channel waveguide bends withlarge-angle and low-loss characteristics

By using micro-prisms, improved three-dimensional (3-D) bends of the embedded and buried waveguides of step-index profile are proposed. A simple phase compensation rule for the optimal design of the micro-prism is also presented. Through the simulation of 3-D semivectorial finite-difference beam propagation method, the transmission characteristics of the improved bends are shown to have been enhanced dramatically as compared with those of the conventional ones. Even for a bend angle of as large as 10°, the normalized transmitted power can still be greater than 95%. These results of 3-D bends are then compared with those of the two-dimensional (2-D) ones which are simplified from 3-D structures by the effective index method, and physical explanation of the discrepancy between the 3-D and 2-D results is introduced. The influences of waveguide structures and prism parameters on the transmission characteristics are discussed in detail. Some criteria for the design of large-angle low-loss 3-D improved bends are also accessed     

Enhanced electron emission from phosphorus-doped diamond-cladsilicon field emitter arrays

Undoped and phosphorus (P)-doped diamond-clad Si field emitter arrays have been successfully fabricated using microwave plasma chemical vapor deposition (MPCVD) technology. The electron emission from the blunt diamond-clad microtips are much higher than those for the pure Si tips with sharp curvature due to a lower work function. Furthermore, the characteristics of emission current against applied voltage for the P-doped diamond-clad tips show superior emission at lower field to the undoped ones. After the examination of Auger electron spectroscopy (AES) and electrical characteristics of as-grown diamond, such a significant enhancement of the electron emission from the P-doped diamond-clad tips is attributed to a higher electron conductivity and defect densities     

Exact evaluation of laser linewidth requirements for optical PSKhomodyne communication systems with balanced PLL receivers

The power penalty induced by imperfect phase recovery in PSK homodyne communication systems with balanced phase-locked loop receivers are exactly evaluated. Optimum phase deviations between the mark-state and the space-state bits are used in this study. This study for the first time shows the imperfect-phase-recovery-induced power penalty as a function of laser linewidth with optimum phase deviations considered. It can be estimated from the theoretical result that an optimal balanced PLL receiver requires the laser linewidth as Δν⩽1.15×10^-6× (bit rate) in contrast to the previous reported one Δν⩽5.88×10^-6× (bit rate). We also point out here that the previously reported laser linewidth requirement was wrongly estimated