Influence of focusing depth on the microfabrication of waveguides inside silica glass by femtosecond laser direct writing

We studied the influence of focusing depth on the index change threshold and damage threshold of silica glass irradiated by a focused 120 fs laser beam. Both thresholds increased with the focusing depth. The aspect ratio of the waveguide cross section can be selected by changing the focusing depth. A 5 mm long waveguide was written at the depth of 2100 μm, which was single mode at 632.8 nm and exhibited propagation loss of 0.56 dB/cm. The refractive index change was calculated to be ∼2.47×10^-3. The influence of the focusing depth should be considered in multi-layer devices as shown in the fabrication of a 3×3 waveguide array. PACS 42.62.-b; 42.82.Et; 81.05.Kf     

On the stability of the output characteristics of a grazing incidence grating dye laser transversely pumped by a copper vapor laser

The output characteristics of a high repetition rate pulsed dye laser has both short-term fluctuations and long-term drift. In high power high repetition rate lasers flow induced variations dominate over those due to other factors. In this paper it is shown by dye laser measurements that bandwidth fluctuations can be traced to the effective changes of the resonator dispersion due to fluctuations in the penetration depth of the pump beam in the dye medium. Short-term wavelength fluctuations can be traced to instantaneous deflection of the dye laser axis by the refractive index changes due to absorption of the pump beam. The fluctuations in both the bandwidth and the wavelength decreases with increasing flow rates within a laminar region. A copper vapor laser operating at 5.6 kHz repetition rate pumped the Rhodamine 6G dye laser used. The wavelength fluctuation of ±0.0035, 0.0030, 0.0004 nm and the bandwidth fluctuation of ±710, 132, 45 MHz over approx. 60 minutes were observed at 1.2, 3.7, 5.5 lpm flow rates respectively.     

The measurement of beta asymmetries at UNISOR/NOF using external plastic scintillator detectors

The performance of two external plastic scintillator detectors has been tested in an off-line mode using a source of¹⁰⁶RuFe at UNISOR/NOF. The measurement of beta asymmetries at various temperatures has resulted in the reproduction of the previously-determined magnetic dipole moment for the 1⁺ ground state of¹⁰⁶Rh and in addition the conclusion that the sign of this moment is positive.     

FT-EPR and HPLC study of the mechanism of 4-chlorophenol photolysis

The mechanism of 4-chlorophenol (4CP) photolysis was investigated with the aid of Fourier Transform Electron Paramagnetic Resonance (FT-EPR) and pulsed-laser photolysis combined with High Performance Liquid Chromatography (HPLC) detection-of stable (diamagnetic) products. With FT-EPR transient free radicals produced by pulsed-laser excitation of solutions of 4CP in alcohols could be identified. Time profiles of the FT-EPR spectra provided information on reaction kinetics and Chemically Induced Dynamic, Electron Polarization (CIDEP) effects. It was found that 4CP photolysis in alcohols leads to the simultaneous formation of the phenoxyl radical and radicals produced by hydrogen abstraction from the solvent. CIDEP patterns establish that these radicals are formed in a reaction sequence involving a triplet state precursor and radical pair intermediate. Results of earlier transient optical absorption measurements indicate that the triplet precursor must be the carbene 4-oxocyclohexa-2,5-dienylidene. This assignment is supported by the finding that photolysis of quinone diazide in a hydrogen-donating solvent gives the same free radical products as those obtained from 4CP. The formation of the phenoxyl radical intermediate accounts for the finding that photolysis of deoxygenated solutions of 4CP in alcohols gives phenol as stable diamagnetic product. By contrast, photolysis of aerated and deoxygenated aqueous solutions of 4CP produces benzoquinone and hydroquinone as primary products, respectively.     

Crossing the planes at high speed. Signal integrity issues at splitground and power planes

This article discusses a specific design situation that represents quite a broad class of problems in the study of signal integrity. The article focuses on the effects on high-speed signals that need to cross split ground planes and split power planes that act as signal references or partial references. Such configurations are frequently needed in the layout of printed circuit boards (PCBs), multichip modules (MCMs), and even single-chip modules. Examples of split ground and power planes are discussed first. The conventional effective inductance model is described briefly, and an accurate and efficient transmission line model is then discussed in detail. Examples of modeling and design trade-offs are also presented     

The diversity gain of transmit diversity in wireless systems withRayleigh fading

In this paper, we study the ability of transmit diversity to provide diversity benefit to a receiver in a Rayleigh fading environment. With transmit diversity, multiple antennas transmit delayed versions of a signal to create frequency-selective fading at a single antenna at the receiver, which uses equalization to obtain diversity gain against fading. We use Monte Carlo simulation to study transmit diversity for the case of independent Rayleigh fading from each transmit antenna to the receive antenna and maximum likelihood sequence estimation for equalization at the receiver. Our results show that transmit diversity with M transmit antennas provides a diversity gain within 0.1 dB of that with M receive antennas for any number of antennas. Thus, we can obtain the same diversity benefit at the remotes and base stations using multiple base-station antennas only     

Annular slot-coupled dielectric resonator antenna

An annular slot-coupled dielectric resonator antenna is investigated experimentally. As compared with the previous rectangular-slot version, the new configuration offers a much wider bandwidth of 18%. The return loss, radiation patterns, and antenna gain of the configuration have been measured and are discussed     

Operations and management of a campus packet network

The operation and management of the Kansas University Packet Switch Network (KUPSN),which provides interactive and file transfer services to its users, is discussed, focussing on the problems encountered and solutions developed. Areas of network management of particular concern are identified, and tools developed to deal with them are described. Management system integration and the evolution of problem-handling procedures are discussed     

The nonlinear effects of quantum electrodynamics at high energies

In this paper we considere ⁺ e ^? scattering with intermediate photon-photon scattering as a possibility for getting information about the nonlinear effects of quantum electrodynamics (QED) at high energies. This process is a higher-order correction to double bremsstrahlung. However, these two processes have quite different behaviour with the photon-photon scattering angle. Here we calculate the unpolarized differential cross section of thee ⁺ e ^? scattering with intermediate γγ scattering and also the interference terms with the double bremsstrahlung. Moreover, we show that the sum of these two contributions predominates over the contribution of the double bremsstrahlung for sufficiently large scattering angles of the photons. This result enables us to extract the differential cross section of the γγ scattering. Through extrapolation to different kinematical conditions we can get the cross sections for nearly real photon-photon scattering, photon splitting and Delbrück scattering. As a quantitative example we use the result for a test of the electron propagator in a gauge-invariant way with the usual minimal interaction. We give also numerical examples of this test, which will improve the present values of the testing parameters.     

The phase composition of tin-nickel electrodeposited alloys

It was studied the tin phase composition of the electrodeposited alloys produced at different temperatures and current densities from an acid chloride/fluoride electrolyte and an acid chloride bath. Mössbauer spectra were consistent with a Ni₃Sn₄ intermetallic compound, dissolved tin, and a Cu?Sn intermetallic compound formed at the interface of the copper substrate.