Storage performance-metrics and benchmarks

The metrics and benchmarks used in storage performance evaluation are discussed. The technology trends taking place in storage systems, such as disk and tape evolution, disk arrays, and solid-state disks, are highlighted. The current popular I/O benchmarks are then described, reviewed, and run on three systems: a DECstation 5000/200 running the Sprite Operating System, a SPARCstation 1+ running SunOS, and an HP Series 700 (Model 730) running HP-UX. Two approaches to storage benchmarks-LADDIS and a self-scaling benchmark with predicted performance-are also described     

Experimental investigation and numerical simulation of the influence of resonator-length detuning on the output power,pulse duration and spectral width of a cw mode-locked picosecond optical parametric oscillator

We report on a cw mode-locked non-critically phase matched KTP optical parametric oscillator synchronously pumped by a picosecond Ti:Sapphire laser. High average signal output power of up to 950 mW over a large tuning range has been achieved. For this OPO the influence of resonator-length detuning on the output power, pulse duration and spectral bandwidth has been investigated. The measured data are in good agreement with the results of a numerical simulation using a split-step Fourier method which considers the group-velocity mismatch, the group-velocity dispersion and the self-phase modulation. The numerical simulation also describes the measured strong pump depletion and its influence on the OPO output and efficiency.     

1.3 μm InAsyP1-y-InPstrained-layer quantum-well laser diodes grown by metalorganic chemicalvapor deposition

The authors have fabricated 1.3-μm InAsP-InP separate-confinement-heterostructure (SCH) strained-layer double-quantum-well (SL-DQW) laser diodes (LDs) by metalorganic chemical vapor deposition (MOCVD). A low threshold current density of 410 A/cm ² was obtained. The CW threshold current was as low as 1.8 mA at 20°C, and maximum CW operating temperature of 120°C was obtained. These characteristics are almost the same as those of well-designed GaInAsP-InP SL-QW LDs. Further improvement of the characteristics of InAsP-InP LDs is expected by optimizing the device structure     

The correlation of texture and magnetic properties in Co-Cr films

This investigation focuses on the correlation between the crystallographic orientation of grains with respect to magnetic properties in Co-Cr films. Based on a distribution measured for the (0002) crystallographic pole densities, modified formulae describing the texture were used to calculate the coercivity Hc, the squareness ratio Rs (Mr⊥/TMs) and the anisotropy field Ha for Co-Cr films. In general, calculated values for the coercive force He agreed well with the measured values. The calculated Rs⊥. values were much larger than the measured ones, however, indicating that the influence of the demagnetizing field and the magnetostriction on the orientation of the magnetization cannot be neglected. On leave from Institute of Computing Technology, Academia Sinica, P.O.Box 2704-6, Beijing, P.R. China.     

Normal-incidence InAs self-assembled quantum-dot infrared photodetectors with a high detectivity

An InAs/AlGaAs quantum-dot infrared photodetector based on bound-to-bound intraband transitions in undoped InAs quantum dots is reported. AlGaAs blocking layers were employed to achieve low dark current. The photoresponse peaked at 6.2 /spl mu/m. At 77 K and -0.7 V bias, the responsivity was 14 mA/W and the detectivity, D*, was 10/sup 10/ cm/spl middot/Hz/sup 1/2//W.     

SAR-retrieved wind in polar regions-comparison with in situ data and atmospheric model output

European remote sensing (ERS) satellites synthetic aperture radar (SAR) wind retrievals using CMOD-IFR2 are, for the first time, retrieved in the marginal ice zone (MIZ) and in Arctic coastal areas and compared with in situ observations from reseach vessels (RVs) and output from a high-resolution atmospheric model. The root mean squares (rms) of the comparisons were 1.6 m s/sup -1/ and 2 m s/sup -1/, respectively. The spatial variation of the SAR wind fields established a decrease in wind speed close to the ice edge for the late summer situations where the wind was along the ice edge with the ice to the left. This decrease is believed to be due to changes in atmospheric stability, possibly through development of an internal boundary layer caused by the cold ice cover and melt water. Lower wind speed near the ice edge is confirmed by the atmospheric model and the in situ observations. Furthermore, good results are obtained from SAR wind retrieval in leads when compared with model output during a cold-air outbreak. Routine measurements in the MIZ are useful for estimating the wind stress, and therefore SAR may play an important role in this region. Finally, the identification of a jet out from Hinlopen Strait in the Svalbard region and low wind wakes along the coast in the SAR-retrieved wind field is confirmed by in situ observations as the RV moves through the region. The jet is also confirmed by the atmospheric model, which is able to reproduce the situation.     

Flicker noise in gate overlapped polycrystalline silicon thin-filmtransistors

A study of the noise performance of gate overlapped polycrystalline silicon thin-film transistors (TFTs) is presented. Low-frequency noise measurements were carried out on n- and p-type samples fabricated by excimer laser crystallization. It is shown that the carrier number fluctuation model applies not only to n-type but also to p-type devices. The density of oxide traps was extracted from the noise measurements and was of the order of 10¹⁸-10¹⁹ eV^-1 cm^-3     

An easy-to-use mismatch model for the MOS transistor

In this paper, a physics-based mismatch model is presented. It is demonstrated on a 0.18-/spl mu/m technology that a simple mismatch model can still be used to characterize deep-submicron technologies. The accuracy of the model is examined and found to be within 20% in the strong inversion region. Bulk bias dependence is modeled in a physical way. To extract the mismatch parameters, a weighted fit is introduced. It is shown that the width and length dependence of the mismatch parameters is given by the Pelgrom model.