Application of differential electrolytic potentiometry for detection in flow injection analysis

The applicability of differential electrolytic potentiometry as a detection system in flow injection analysis is investigated. A computer-controlled injector which delivers precise volumes of sample solutions in a reproducible manner was developed. Conditions such as current density employed, the concentrations of the solutions used and the flow rate were optimized. Chloride in water was determined by means of this system. The relation between chloride concentration and the measured signal was found to be Nernstian for solutions of concentrations above 6 μg ml⁻¹ chloride. For solutions below this concentration, the relation is linear.     

Truly temperature independent current conveyor precision rectifier

A current conveyor based rectifier circuit with very low temperature sensitivity is presented. The use of a current mirror arrangement to bias the rectifying diodes provides higher temperature stability than previously reported designs. The output offset voltage is easily adjustable to the desired optimum level     

Synthesis and analysis of transformer-isolated converters

A systematic and straightforward procedure is developed for the synthesis and analysis of transformer-isolated power converters. The procedure can be used to determine the ranges of duty-ratio over which the transformer-isolated power converters of a given class can be operated without transformer saturation. The procedure can also be used to study the dependence of the power converter switch stresses on duty-ratios. This information is useful in the selection of the transformer-isolated power converter most suitable for a given application and in the design of this power converter with minimum switch stresses, high power density, and low cost     

Investigation of the conditions for feeding filamentary silicon crystals,growing in a reactor with hot walls

An estimate of the factors which influence the rate of growth of filamentary silicon crystals in a standard chloride system using a quartz reactor with hot walls is given. It is shown that a diffusion form of crystallization is observed under the conditions investigated.Voronezh State Technical University. Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Fizika, No. 10, pp. 22–26, October, 1995.     

Integration of the equations of planar and flexural vibrations of anisotropic plates in special functions of generalized complex variables

On the basis of the method of successive approximations in formal series we construct systems of particular solutions of the equations of planar and flexural harmonic vibrations of thin rectilinear anisotropic plates with a plane of symmetry of elastic properties parallel to the faces. The solutions constructed are classified as special sk-functions of generalized complex variables. Translated fromTeoreticheskaya i Prikladnaya Mekhanika No. 24, 1993, pp. 54–61.     

The external magnetic field dependence of RF splitting of57Fe hyperfine lines. NMR + Mössbauer double resonance experiment

We present the results of an experimental investigation of a RF splitting of⁵⁷Fe hyperfine lines in the regime of NMR and Mössbauer double resonance. The experiments have been performed as a function of RF field intensity and static magnetic field magnitude. The intensity of the RF components and the separation between them are extremely sensitive to the frequency and amplitude of the RF magnetic field. The RF splitting of hyperfine lines is inversely proportional to the strength of the static magnetic field.     

Three-dimensional atom probe study of the segregation behaviour of Ni91Pt9 alloy after sputtering

To investigate local ordering and segregation phenomenon in a Ni91Pt9-alloy after sputtering and annealing a 3D optical atom probe (OAP) has been used. The specimen tips have been prepared from polycrystalline samples. To sputter the samples a separate preparation chamber with a scannable Ar-sputter-gun is connected to the OAP vessel. When necessary, the sample can be electrically heated to induce segregation and cure the altered layer. After a heat treatment of a Ni91 at. %Pt 9 at.% specimen at 1100 K the surface of a (111)-oriented specimen is enriched in platinum by a factor of two in relation to the bulk. The phenomenon of short-range ordering has been investigated on the surface and in the subsurface volume. A 3D reconstruction of this annealed NiPt specimen shows regions with high concentration of platinum that gives an indication at short-range ordering. Uniform sputtering of the tip without a heat treatment induces a decisive depletion of Pt on the surface and the following subatomic layers. The atom-probe results of specimens in thermal equilibrium are in close agreement to further surface sensitive results obtained from Ion Scattering Spectroscopy (ISS) and Auger Electron Spectroscopy (AES).     

Correlation of the leakage current and charge pumping in silicon oninsulator gate-controlled diodes

The leakage and charge pumping currents were measured in gate-controlled MOS p-i-n diodes fabricated on thin SIMOX substrates. The efficiencies of the techniques as well as their complementary features are analyzed for various experimental conditions. The interface properties of device-grade SIMOX wafers are characterized and shown to be compatible with VLSI requirements. Special interface coupling effects, which occur only in fully depleted SOI devices and modify the conventional signature of charge pumping and leakage current, are thoroughly investigated     

R&D activities on wireless systems in China

Various wireless systems and the research preceding their practical use in China are described. The topics discussed include research establishments, research and development projects underway, challenges inherent to digital radio, and expansion opportunities afforded by satellite communications     

Optical fiber solitons, their properties and uses

The history and mathematical formulation of solutions are briefly reviewed. Solitons of the nonlinear Schrodinger equation are studied in greater detail because they describe nonlinear pulse propagation on dispersive optical fibers. The proposal by A. Hasegawa and the experiments of L.F. Mollenauer on long distance soliton propagation for use in repeaterless transoceanic fiber transmission cables are described. In 1986, limitations on the distance that can be spanned by a repeaterless link for a given bit rate were shown to exist. It has been shown recently that by proper design these limitations can be overcome, so that newer transoceanic cable designs are likely to utilize solitons. The special properties of solitons make them particularly suited for all optical switching and logic operations. Some recent experiments with such switches are described