Improvement of AlGaInP light emitting diode by sulfide passivation

The brightness of AlGaInP light emitting diodes (LEDs) has been raised by a factor of 1.12 at 20 mA by sulfide passivation. Meanwhile, the sulfide also can decrease leakage current of AlGaInP LEDs at -2 V to nearly one thousandth of that in the as-fabricated device. The possible causes for the brightness increase of AlGaInP LEDs after sulfide treatment including surface roughness, reduction of Fresnel loss, and effective injection of carriers were demonstrated.     

A universal matrix solver for integral-equation-based problems

A new method has been developed for compressing the matrices that occur in most integral-equation-based computer programs. This method is easy to interface with existing computer programs, and allows them to run significantly faster and with significantly less memory. This method applies not only to electromagnetic and acoustic computation, but also to most programs involving a Green's function or any integral equation with a kernel having some smoothness properties. Our numerical computations, running on a high-end personal computer, have achieved compression ratios of fifty times, and compressed inversion of the matrices fifty times faster than by previous methods. For larger problems, solved on high-performance computers, these ratios would improve to about one thousand to one for larger moment method problems.     

Thermal conductivity of doped PbTe-based solid solutions with off-center impurities

The coefficients of thermopower and electrical and thermal conductivity in the PbTe_0.8Se_0.1 S _0.1 solid solution with electron concentration (4.6–54) × 10¹⁸ cm^?3 are studied in the range of 85–300 K (and in some cases up to 700 K). The temperature dependences of electrical and thermal conductivity indicate that the low-temperature electron and phonon scattering initiated by the off-center impurity of sulfur exists. The temperature dependences of the electronic and lattice components of thermal conductivity are calculated in the approximation of a parabolic spectrum and electron scattering by acoustic phonons and neutral substitutional impurities. The lattice thermal conductivity is found to have a feature in the form of a shallow minimum in the range of 85–250 K. A similar feature, while not so clearly pronounced, is found to exist also in Pb_1?x Sn_xTe_1?x Se_x alloys (x≥0.15) with an off-center tin impurity. An analysis of the possible origins of this effect suggests that, at low temperatures, the Lorentz numbers L of the materials under study are smaller than the L₀ numbers employed which correspond to the above scattering mechanisms. The cause of the decrease in L is related to electron scattering at two-level systems, a mechanism whose effect grows with increasing electron energy. An analysis of experimental data obtained at high temperatures, as well as on undoped samples with the lowest possible carrier concentrations, yields the values of L for samples with different electron densities. The minimum value L/L₀ = 0.75 is obtained for a lightly doped sample at ～130 K.     

A left-handed composite medium based on waveguiding structures with a bianisotropic filling

A new composite medium based on waveguiding structures loaded with bianisotropic gratings of planar double split rings (PDSRs) and planar helices is considered. The microwave transmission spectra of this medium are studied experimentally. The effective parameters of the medium are determined theoretically, and its passbands are investigated. The characteristics of the medium are compared to those of infinite homogeneous bianisotropic media. A relationship between the spectral transmission characteristics and the type of resonance excitation is established. The transparency bands and overforbidden bands of the composite medium are revealed. The combinations of the medium’s effective parameters that correspond to these bands are determined. It is shown that the transparency bands where the medium is characterized simultaneously by negative permittivity and negative permeability can be identified.     

Bandpass filters with reconfigurable transmission zeros using varactor-tuned tapped stubs

In this letter, bandpass filters with one or two tunable transmission zeros are proposed. The reconfigurable transmission zeros are implemented through varactors in combination with tapped quarter-wavelength stubs. Based on mixed mode simulations including EM simulation and circuit simulation, the proposed filters were designed and fabricated on low-cost FR4 board. The measurement results verified the design concepts.     

Reversed Temperature-Dependent Propagation Delay Characteristics in Nanometer CMOS Circuits

The supply voltage to threshold voltage ratio is reduced with each new technology generation. The gate overdrive variation with temperature plays an increasingly important role in determining the speed characteristics of CMOS integrated circuits. The temperature-dependent propagation delay characteristics, as shown in this brief, will experience a complete reversal in the near future. Contrary to the older technology generations, the speed of circuits in a 45-nm CMOS technology is enhanced when the temperature is increased at the nominal supply voltage. Operating an integrated circuit at the prescribed nominal supply voltage is not preferable for reliable operation under temperature fluctuations. A design methodology based on optimizing the supply voltage for temperature-variation-insensitive circuit performance is proposed in this brief. The optimum supply voltage is 45% to 53% lower than the nominal supply voltage in a 180-nm CMOS technology. Alternatively, the optimum supply voltage is 15% to 35% higher than the nominal supply voltage in a 45-nm CMOS technology. The speed and energy tradeoffs in the supply voltage optimization technique are also presented     

Equivalent electrical network of the DNA molecule

The variation of current density with bias or temperature is examined for DNA molecules of different configuration. To this end, the DNA molecule is represented as an equivalent electrical network whose behavior is then simulated with PSPICE. The results are found to be in close agreement with ones obtained within a physical model. It is established that the electrical response of a DNA molecule to an applied electric field depends on the boundary conditions and the potential profile along the molecule. This finding should contribute to the creation of a complete library of DNA-molecule configurations with prescribed electrical properties.     

Radiative lifetimes of electrons and holes in a thin semiconductor layer

Radiative lifetimes of nondegenerate electrons and holes distributed uniformly in a semiconductor layer either deposited on a substrate or bounded by two dielectric media are calculated. The obtained expression takes into account the radiation reabsorbtion and interference effects and determines the dependences of the radiative lifetimes on the refractive indices of the external media and on the layer thickness.     

Single-polarization single-mode photonic crystal fibers

A new structure of single-polarization single-mode (SPSM) photonic crystal fiber (PCF) is proposed and analyzed by using a full-vector finite element method with anisotropic perfectly matched layers. From the numerical results it is confirmed that the proposed fiber is low-loss SPSM-PCF within the wavelengths ranging from 1.48 to 1.6 /spl mu/m, where only the slow-axis mode exists and the confinement loss is less than 0.1 dB/km.     

The rank and kernel of extended 1-perfect /spl Zopf//sub 4/-linear and additive non-/spl Zopf//sub 4/-linear codes

A binary extended 1-perfect code of length n + 1 = 2/sup t/ is additive if it is a subgroup of /spl Zopf//sub 2//sup /spl alpha// /spl times/ /spl Zopf//sub 4//sup /spl beta//. The punctured code by deleting a /spl Zopf//sub 2/ coordinate (if there is one) gives a perfect additive code. 1-perfect additive codes were completely characterized and by using that characterization we compute the possible parameters /spl alpha/, /spl beta/, rank, and dimension of the kernel for extended 1-perfect additive codes. A very special case is that of extended 1-perfect /spl Zopf//sub 4/-linear codes.