A simple flow injection spectrophotometric determination method for iron(III) based on O-acetylsalicylhydroxamic acid complexation

A simple and rapid flow-injection spectrophotometric method for the determination of iron(III) and total iron is proposed. The method is based on the reaction between iron(III) and O-acetylsalicylhydroxamic acid (AcSHA) in a 2 % methanol solution resulting in an intense violet complex with strong absorption at 475 nm. Optimum conditions for the determination of iron(III) and the interfering ions were tested. The relative standard deviation for the determination of 5 μg L⁻¹ iron(III) was 0.85 % (n = 10), and the limit of detection (blank signal plus three times the standard deviation of the blank) was 0.5 μg L⁻¹, both based on the injection volumes of 20 μL. The method was successfully applied in the determination of iron(III) and total iron in water and ore samples. The method was verified by analysing a certified reference material Zn/Al/Cu 43XZ3F and also by the AAS method.     

Preparation of highly selective solid-phase extractants for Cibacron reactive dyes using molecularly imprinted polymers

Selective polymeric extractants were prepared for preconcentration of Cibacron reactive red dye, a dye that is often applied with Cibacron reactive blue and Cibacron reactive yellow for dyeing of fabrics. The best extractant was fabricated (in chloroform) using methacrylic acid (as monomer), ethylene glycol dimethacrylate (as crosslinker), AIBN (as initiator for polymerization), and red dye as template molecule, with a molar stoichiometric ratio of 8.0:40.0:2.5:0.63, respectively. The structure of the molecularly imprinted polymer (MIP) was robust, and resisted dissolution up to 260 °C. Compared with the un-imprinted polymer, the imprinted product has a large specific surface area which improved its adsorption capacity. The effect of imprinting was obvious from the adsorption capacity measured at pH 4 for red dye (the imprinted molecule), which was increased from 24.0 to 79.3 mg g⁻¹ after imprinting. Equilibrium adsorption studies revealed that the dye-imprinted-polymer enables efficient extraction of red dye even in the presence of blue and yellow dyes which have similar chemical natures to the red dye. The selectivity coefficients S _{red dye/dye}, were 13.9 and 17.1 relative to the yellow and blue dyes, respectively. The MIP was found to be effective for red dye preconcentration, with a preconcentration factor of 100, from tap water and treated textile wastewater. The factors affecting extraction of red dye by the MIP were studied and optimized. Under the optimized extraction conditions, red dye was selectively quantified in the presence of other competing dyes at a concentration of 20 μg L⁻¹ from different water systems with satisfactory recoveries (91–95%) and RSD values (∼5.0%).     

Imidomethylation of C-nucleophiles using O-phthalimidomethyl trichloroacetimidate and catalytic amounts of TMSOTf

The O-phthalimidomethyl trichloroacetimidate (1), as a latent aminomethylating agent, exhibits high electrophilicity towards a variety of C-nucleophiles in the presence of catalytic amounts of TMSOTf and mild reaction conditions. The nucleophiles include aromatics, alkenes and active methylene compounds 2-11 whereby a phthalimidomethyl group could be introduced to give compounds 12-22. Removal of the phthaloyl group gave the respective amines, β-amino ketones, and β-amino acids. The O-(trichloroacetamido)methyl trichloroacetimidate (35) was also found to be a good amidomethylating agent.     

Liquid crystals alignment with PbS nanosculptured thin films

Lead sulphide (PbS) nano-sculptured thin films (nSTFs) are prepared for the first time using glancing angle deposition technique by physical vapour deposition process. An anisotropic morphology is obtained, which provides an orientational effect. Due to this anisotropic nature of PbS nSTF an attempt has been made to check its effect on the alignment of nematic liquid crystals (LCs). Two different LC devices were fabricated, that is, anti-parallel aligned or electrically-controlled birefringence and hybrid twisted nematic. It is noticed that in both types of devices, good alignment is obtained with high extinction and contrast. A significant effect of these alignments on the electro-optic properties of the LC is reported such as the threshold voltage, response time and contrast ratio.     

N‐(Ferrocenecarbonyl)‐N′‐(quinolin‐8‐yl)thio­urea

In the title compound, [Fe(C₅H₅)(C₁₆H₁₂N₃OS)], the 8‐am­inoquinoline and acyl­thio­urea moieties are almost planar. There are two perpendicular arrangements of the mol­ecules in the crystal with slightly different conformations. The two cyclo­penta­dienyl rings in each mol­ecule are parallel and eclipsed.     

Intermolecular interactions in (arene)chromium carbonyl compounds: prediction of chiral crystal packing from racemate structure

Six X-ray crystal structures are reported, all containing substituted triphenylmethanol derivative 4 either alone or as its mono or bis(chromium tricarbonyl) complexes. All four chromium complexes studied crystallize with two independent molecules in the crystallographic asymmetric unit. It is demonstrated that from the X-ray crystal structure of the acentric racemic (+/-)-(1pR,1' 'R)(1pS,1' 'S)-[Cr(CO)(3)(eta(6)-t-BuC(6)H(3)(CMeOMe)CPh(2)OH)], (+/-)-3, it is possible to deduce the 4-fold helical structure of the chiral (-)-(1pR,1' 'R) isomer, (-)-3. The bimetallic derivatives demonstrate the ability to control intermolecular interactions by the positioning of relative stereochemistry.     

Metal adsorption of gamma-irradiated carboxymethyl cellulose/polyethylene oxide blend films

Blend films of different ratios of carboxymethyl cellulose (CMC)/polyethylene oxide (PEO) were prepared by the solution casting method. To investigate the effect of irradiation on all properties of prepared blend, it was exposed to different gamma irradiation doses (10, 20, and 30?kGy). Physical properties such as gel fraction (GF) (%) and swelling (SW) (%) were investigated. It was found that the GF (%) increases with increasing irradiation dose up to 20?kGy, while SW (%) decreases with an increase in the irradiation doses for all blend compositions. Moreover, the structural and mechanical properties of the prepared films were studied. The results of the mechanical properties obtained showed that there is an improvement in these properties with an increase in both CMC and irradiation dose up to 20?kGy. The efficiency of metal ions uptake was measured using a UV spectrophotometer. The prepared films showed good tendency to absorb and release metal ions from aqueous media. Thus, the CMC/PEO film can be used in agricultural domain.     

Mechanical properties of sisal fibre-reinforced polymer composites: a review

There has been a growing interest in the utilization of sisal fibres as reinforcement in the production of polymeric composite materials. Natural fibres have gained recognition as reinforcements in fibre polymer–matrix composites because of their mechanical properties and environmental friendliness. The mechanical properties of sisal fibre-reinforced polymer composites have been studied by many researchers and a few of them are discussed in this article. Various fibre treatments, which are carried out in order to improve adhesion, leading to improved mechanical properties, are also discussed in this review paper. This review also focuses on the influence of fibre content and fabrication methods, which can significantly affect the mechanical properties of sisal fibre-reinforced polymer composites.     

A highly sensitive and specific polyclonal antibody-based enzyme immunoassay for therapeutic monitoring and pharmacokinetic studies of atorvastatin

This study describes the development and validation of a highly sensitive and specific enzyme immunoassay (EIA) for therapeutic monitoring and pharmacokinetic studies of atorvastatin (ATR). The assay employs a polyclonal antibody that recognizes ATR with high specificity and affinity, and ATR conjugated to bovine serum albumin (ATR-BSA) immobilized onto microwell plates as a solid phase. The assay involved a competitive binding reaction between ATR and the immobilized ATR-BSA for the binding sites on a limiting amount of the anti-ATR antibody. The bound anti-ATR antibody was quantified with horseradish peroxidase-labeled anti-immunoglobulin secondary antibody and 3,3′,5,5′-tetramethylbenzidine as a substrate for the peroxidase enzyme. The concentration of ATR in the sample was quantified by its ability to inhibit the binding of the anti-ATR antibody to the immobilized ATR-BSA and subsequent color development in the assay wells. The conditions for the EIA were investigated and optimized for the determination of ATR in plasma samples. The limit of detection was 0.04 ng mL^?1 and the effective working range at relative standard deviations (RSD) of ≤5% was 0.1–10 ng mL^?1. Mean analytical recovery of ATR from spiked plasma was 99.3?±?2.8%. The precision of the assay was satisfactory; RSD were 2.7–4.6 and 3.3–5.7% for intra- and inter-assay precision, respectively. The reliability of the EIA was confirmed by HPLC. The EIA is convenient, and one can analyze ～ 200 samples per working day, facilitating the processing of large-number of samples of ATR.     

Defects-engineered tailoring of tri-doped interlinked metal-free bifunctional catalyst with lower gibbs free energy of OER/HER intermediates for overall water splitting

Controllable tailoring of metal-free/carbon-based nanostructures tends an encouraging way to enhance the bifunctional activity of electrodes, but a great challenge owing to the sluggish kinetics of oxygen evolution reaction (OER) and hydrogen evolution reaction (HER). Herein, a facile tempted-defects assisted fractionation strategy is presented to synthesize N, S, and O tri-doped metal-free catalyst (DE-TDAP). Due to this effective tempted-defects and heteroatoms interlinking in DE-TDAP, it delivers the lowest overpotential toward both the OER (346 mV) and HER (154 mV) at 10 mA cm^?2. Remarkably, the DE-TDAP-electrode carries only a cell voltage of 1.81 V at 10 mA cm^?2 for overall water splitting and long-term stability. Considerably, the density functional theory (DFT) calculation exposes that the tailored-defects in tri-doped interlinking could enhance bifunctional catalytic performance devising from lower Gibbs free energy of OER/HER intermediates on active sites. This struggle henceforth provides a perceptive understanding of the synergetic principles of heteroatom-interlinking-tailoring nanostructures in water splitting.