A 0.25-/spl mu/m CMOS quad-band GSM RF transceiver using an efficient LO frequency plan

This paper describes a single-chip CMOS quad-band (850/900/1800/1900 MHz) RF transceiver for GSM/GPRS applications. It is the most important design issue to maximize resource sharing and reuse in designing the multiband transceivers. In particular, reducing the number of voltage-controlled oscillators (VCOs) required for local oscillator (LO) frequency generation is very important because the VCO and phase-locked loop (PLL) circuits occupy a relatively large area. We propose a quad-band GSM transceiver architecture that employs a direct conversion receiver and an offset PLL transmitter, which requires only one VCO/PLL to generate LO signals by using an efficient LO frequency plan. In the receive path, four separate LNAs are used for each band, and two down-conversion mixers are used, one for the low bands (850/900 MHz) and the other for the high bands (1800/1900 MHz). A receiver baseband circuit is shared for all four bands because all of their channel spaces are the same. In the transmit path, most of the building blocks of the offset PLL, including a TX VCO and IF filters, are integrated. The quad-band GSM transceiver that was implemented in 0.25-/spl mu/m CMOS technology has a size of 3.3/spl times/3.2 mm/sup 2/, including its pad area. From the experimental results, we found that the receiver provides a maximum noise figure of 2.9 dB and a minimum IIP3 of -13.2dBm for the EGSM 900 band. The transmitter shows an rms phase error of 1.4/spl deg/ and meets the GSM spectral mask specification. The prototype chip consumes 56 and 58 mA at 2.8 V in the RX and TX modes, respectively.     

Fast DCT algorithm with fewer multiplication stages

A novel fast DCT scheme with reduced multiplication stages and fewer additions and multiplications is proposed. The proposed algorithm is structured so that most multiplications tend to be performed at the final stage, which reduces the propagation error that could occur in the fixed-point computation. Minimisation of the multiplication stages can further decrease the error     

The implementation of TS MAC (transmitter station monitor, alarmand control) system for digital DBS system

The implementation of TS MAC system for KOREASAT DBS (direct broadcast satellite) system is presented. This TS MAC controls and monitors the status of the TS equipment and gathers the alarm for them. The advantage of this system is the center-concentrated, real time processing, remote control, and object oriented module decomposing     

Lossless subband coding system based on rounding transform

We propose a new rounding transform called the overlapping rounding transform (ORT). It is defined as a two-port input/two-port output FIR filtering system with a pair of rounding operations. The ORT is applied to develop lossless subband coding systems. The ORT approach has both a simpler representation and more possibilities for lossless subband implementation than the lifting scheme     

Dynamic Point Location in General Subdivisions

The dynamic planar point location problem is the task of maintaining a dynamic set S of n nonintersecting (except possibly at endpoints) line segments in the plane under the following operations:

• Locate (: point): Report the segment immediately above , i.e., the first segment intersected by an upward vertical ray starting at ;

• Insert (: segment): Add segment to the collection of segments;

• Delete (: segment): Remove segment from the collection of segments.

We present a solution which requires space O(n) and has query and insertion time O(log n log log n) and deletion time O(log²n). The bounds for insertions and deletions are amortized. A query time below O(log²n) was previously only known for monotone subdivisions and subdivisions consisting of horizontal segments and required nonlinear space.     

Advantages of CDMA and spread spectrum techniques over FDMA andTDMA in cellular mobile radio applications

A unified theoretical method for the calculation of the radio capacity of multiple-access schemes such as FDMA (frequency-division multiple access), TDMA (time-division multiple access), CDMA (code-division multiple access) and SSMA (spread-spectrum multiple access) in noncellular and cellular mobile radio systems is presented for AWGN (additive white Gaussian noise) channels. The theoretical equivalence of all the considered multiple-access schemes is found. In a fading multipath environment, which is typical for mobile radio applications, there are significant differences between these multiple-access schemes. These differences are discussed in an illustrative manner revealing several advantages of CDMA and SSMA over FDMA and TDMA. Novel transmission and reception schemes called coherent multiple transmission and coherent multiple reception are briefly presented     

Stability control of the electrooptic effect with new maleimide copolymers containing photoreactive tricyanopyrrolidene‐based chromophores

New photocrosslinkable maleimide copolymers have been synthesized by the attachment of a tricyanopyrrolidene‐based chromophore. The 2‐(3‐cyano‐4‐(2‐{4‐[hexyl‐(6‐hydroxy‐hexyl)‐amino]‐phenyl}‐vinyl)‐5‐oxo‐1‐{4‐[4‐(3‐oxo‐3‐phenyl‐propenyl)‐ phenoxy]‐butyl}‐1,5‐dihydro‐pyrrol‐2‐ylidene)‐malononitrile chromophore exhibits nonlinear optical activity and contains a chalcone moiety that is sensitive to UV light (λ = 330–360 nm) for crosslink formation. The maleimide monomers have also been functionalized with chalcone moieties. The resultant copolymers exhibit great processability, and one of them shows a maximum electrooptic coefficient of 90 pm/V at 1300 nm. We could control the thermal stability of the electrooptic coefficient with the newly synthesized photoreactive copolymers successfully. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 531–542, 2007     

Photoswitching of holographic polymer-dispersed liquid crystals doped with chiral dopant

Chiral dopants were added to the formulation of holographic polymer-dispersed liquid crystals and the effects studied in terms of grating formation dynamics, morphology, diffraction efficiency, contrast ratio and electro-optical properties of the films. A gradual increase of real-time diffraction efficiency, decrease of droplet size and increase of diffraction efficiency of the composite film were obtained with the addition and increasing content of chiral dopant, due to the increased viscosity of the liquid crystal (LC) doped with the chiral dopant leading to decreased droplet coalescence. The contrast ratio decreased with increasing content of chiral dopant due to the difficult orientation of LC molecules caused by the formation of a helical structure. Addition of a small amount of the chiral dopant increased the driving voltage slightly, whereas the decay time is decreased significantly as a result of the high twisting of the helical structure.