A high performance liquid chromatographic assay for AMP-deaminase activity in the erythrocytes of healthy subjects and patients with inherited purine disorders

A novel method for measuring AMP-deaminase activity in human erythrocytes is presented, based on the determination of the reaction product, IMP, using high performance liquid chromatography. IMP formation was found to be proportional both to the incubation time and the amount of haemolysate over a wide range. The minimal detectable AMP-deaminase activity was more than 1000 times lower than the mean activity found in healthy controls (1083 nmol/h/mg Hb). No marked difference of activity was found in the patients with the following inherited purine disorders: familial juvenile gouty nephropathy and deficiencies of adenosine deaminase, hypoxanthine-guanine phosphoribosyltransferase or adenine phosphoribosyltransferase. The activity in the erythrocytes of patients with chronic renal failure was also similar to controls. The existence of subjects with low erythrocyte AMP-deaminase activity in the population has been confirmed.     

Solution and applications of the Lyapunov equation for controlsystems

Recent advances in control systems analysis and design have implied new uses for the Lyapunov equation of the form AX+XA^T+Q=0. Implementation requirements for the incorporation of the use of Lyapunov equations in practical design, however, point out the need for a set of specialized numerical procedures. This special set of numerical procedures must efficiently solve large, sparse Lyapunov equations, solve sets of Lyapunov equations that differ only in the coefficient matrix Q, and provide good low rank estimates of the Lyapunov equation solution X in the case where low rank approximations are applicable. Discussions of the motivations for the solution of these problems and of candidate solution approaches are provided     

Scanning tunnelling microscopic images of the surface ordering of the liquid crystal 4-n-octyl-4'-cyanobiphenyl

Images of the surface ordering of 4-n-octyl-4'-cyanobiphenyl, a room temperature smectic liquid crystal deposited upon graphite, have been obtained by scanning tunnelling microscopy. The microscope was operated in air using the constant-current mode. Under certain tunnelling conditions it has been possible to resolve both the aliphatic and aromatic parts of the molecule, and to observe individual benzene rings. Two previously unreported conformations have been observed: an overlapping bilayer structure with spacing 3.7 nm, and a monolayer structure with spacing 2.4 nm. The latter structure may represent the first visual evidence for a surface polar ordered structure.     

Transient behavior of subthreshold characteristics of fullydepleted SOI MOSFETs

It has been found that the subthreshold currents of fully depleted silicon-on-insulator (SOI) MOSFETs show a transient behavior under certain front-gate and back-gate voltage conditions. The cause of this anomaly is explained, and applications for the phenomenon are pointed out. Particularly, a simple way to measure the silicon film thickness is suggested     

Isotopic study of the mechanism of ozone formation

The mechanism of ozone formation has been studied using ¹⁶O and ¹⁸O₂. High-resolution microwave spectroscopy was used to measure the amounts of the isotopomeric ozone species formed. The study is hampered by the very rapid exchange process between the reactants, that tends to scramble the isotopes and hence give a 2:1 statistical ratio between the two possible isotopomers. We have found a strategy to come around this difficulty and conclude that the mechanism is a simple end-on-addition.     

Highly compact AC-AC converter achieving a high voltage transferratio

This paper reports a new, highly integrated modular design approach for pulsewidth-modulation AC-AC converters based on a modular phase-bank structure. Novel high-power 3-in-1 integrated bi-directional power modules (IBPM) rated at 1200-V AC and 150 A and the 3-to-1 phase bank circuits have been successfully developed, fabricated and tested. This enables the modularity design of the multiphase converter systems and reduces the critical parasitic inductance. A theoretical analysis of the IBPM's silicon utilization for this new breed of direct power converters has been outlined. A lab prototype at medium power level has been successfully designed, implemented, and tested with good results. A nearly 460-VRMS out voltage at a 1:0.955 voltage transfer ratio, which, perhaps, is the highest performance reported so far in the literature, has been achieved by the novel two-side modulation control system. The converter-fed AC motor system is able to operate over the 0-240 Hz range with inherent regenerative capability and four-quadrant operation. Potential industrial applications are also briefly highlighted in this paper     

Temperature dependence of the rate constants for reactions of the carbonate radical with organic and inorganic reductants

Rate constants have been measured by pulse radiolysis for the reactions of the carbonate radical, CO₃^·?, with a number of organic and inorganic reactants as a function of temperature, generally over the range 5 to 80°C. The reactants include the substitution-inert cyano complexes of Fe^II, Mo^IV, and W^IV, the simple inorganic anions SO₃^2?, ClO₂^?, NO₂^?, I^?, and SCN^?, several phenolates, ascorbate, tryptophan, cysteine, cystine, methionine, triethylamine, and allyl alcohol. The measured rate constants ranged from less than 10⁵ to 3 × 10⁹ M^?1 s^?1, the activation energies ranged from ?11.4 to 18.8 kJ mol^?1, and the pre-exponential factors ranged from log A = 6.4 to 10.7. The activation energies for the metal complexes and inorganic anions generally decrease with increasing driving force for the reaction, as expected for an outer sphere electron transfer. For highly exothermic reactions, however, the activation energy appears to increase, probably reflecting the temperature dependence of diffusion. For many of the organic reactants, the activation energies were low and independent of driving force, suggesting that the oxidation is via an inner sphere mechanism.     

Modeling of multilevel converters

In this paper, the imbricated cells multilevel converters are studied and modeled from a control viewpoint. These converters make use of several switches connected in a series, which allows using switches with reduced voltage ratings; these low voltage switches have lower conduction losses and can switch at higher frequency. In addition to this feature common to all converters using series connected switches, the control signals of multilevel converters can be phase shifted to increase the apparent switching frequency and improve the dynamic performances of the whole converter. It is shown that a multilevel inverter leg, composed of p pairs of switches and p-1 capacitors, forms a multivariable nonlinear system that cannot be properly modeled by standard methods such as state-space averaging. The transient behavior of this system depends on the current harmonics and their phase shift with the different control signals. A specific model is detailed, studied, and used to illustrate the properties of these converters. In particular, the natural balancing of the voltage across the switches is demonstrated and the time constants involved in this process are determined