Graphitic nanofillers in PMMA nanocomposites—An investigation of particle size and dispersion and their influence on nanocomposite properties

Mechanical, thermal, and electrical properties of graphite/PMMA composites have been evaluated as functions of particle size and dispersion of the graphitic nanofiller components via the use of three different graphitic nanofillers: “as received graphite” (ARG), “expanded graphite,” (EG) and “graphite nanoplatelets” (GNPs) EG, a graphitic materials with much lower density than ARG, was prepared from ARG flakes via an acid intercalation and thermal expansion. Subsequent sonication of EG in a liquid yielded GNPs as thin stacks of graphitic platelets with thicknesses of ～10 nm. Solution‐based processing was used to prepare PMMA composites with these three fillers. Dynamic mechanical analysis, thermal analysis, and electrical impedance measurements were carried out on the resulting composites, demonstrating that reduced particle size, high surface area, and increased surface roughness can significantly alter the graphite/polymer interface and enhance the mechanical, thermal, and electrical properties of the polymer matrix. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2097–2112, 2007     

An over 2200-km coherent transmission experiment at 2.5 Gb/s usingerbium-doped-fiber in-line amplifiers

A 2223 km transmission distance was achieved with a 2.5-Gb/s heterodyne detection system that used erbium-doped-fiber in-line amplifiers and dispersion-shifted single-mode fibers. Twenty-five amplifiers, placed at approximately 80-km intervals, offered a total gain of more than 440 dB. Receiver sensitivity was -42.0 dBm, with only a 4.2-dB penalty from the initial sensitivity achieved by the back-to-back configuration     

A surface distortion analysis applied to the hoop/column deployablemesh reflector antenna

A practical approach is demonstrated for the deterministic analysis of surface distortions in reflector antennas, based on a first-order approximation to the aperture field phase. Measured pattern results from the 15-m-diameter hoop/column deployable mesh reflector antenna are used to demonstrate the accuracy which can be obtained with this surface distortion analysis. The only practical limitation of the first-order approximation is determined by the slope derivations of the distorted surface from the best-fit paraboloid     

Multiterminal source encoding with one distortion criterion

The authors unify earlier investigations concerning the encoding of two correlated sources {X_k}, {Y_k } by means of separate encoders. Decoding is done by a single decoder which receives the outputs from both encoders. The reconstruction of {X_k} is required to be perfect in the usual Shannon sense. The authors determine the admissible rate region R (D), where D is the distortion of the reconstruction of {Y_k}. The binary Hamming case is investigated explicitly     

Soft decision decoding of block codes using received signalenvelope in digital mobile radio

The codeword error rate (WER) performance of noncoherent frequency-shift keying with soft decision decoding of block codes using Chase's second algorithm (1972) is investigated in a Rayleigh fading channel. The received signal envelope is sampled and used as channel measurement information. The theoretical upper and lower bounds of the WER are derived, assuming independent Rayleigh envelope samples in a received block. When the Golay (23, 12, 7) code is used, soft decision decoding with 6-bit error correction capability (3-bit error and 3-bit erasure) requires an average signal-to-noise power ratio about 5 dB lower than that for minimum distance decoding with 3-bit error correction to obtain a WER=10^-3. The effects of bit interleaving on the WER performance when fading envelope variation is slow compared to the bit rate are investigated through computer simulations     

Decompositions of continuity and complete continuity

We introduce the notions of δ-t-sets, δ_β-t-sets, δ-B-continuity and δ_β -B-continuity and obtain decompositions of continuity and complete continuity.     

Extraction of strontium using an irradiated extraction agent of crown structure

The partition coefficient of strontium upon its extraction from the aqueous solutions of picric acid into chloroform containing DC-18-crown-6, B-15-crown-5 after their exposition to gamma radiation has been studied. A significant decrease of the partition coefficient in the studied range of doses 10–70 kGy was observed. This effect can be attributed to the radiolytic products of chloroform. The radiation destruction as well as dehydrogenation of crown ethers were not observed.     

Growth and characterization of GaAs films deposited on Ge/Si composite substrates by metalorganic chemical vapor deposition

We report the results of studies which have been made on heteroepitaxial layers of GaAs and AlGaAs grown by metalorganic chemical vapor deposition on composite substrates that consist of four different types of heteroepitaxial layered structures of Ge and Ge-Si grown by molecular beam epitaxy on (100)-oriented Si substrates. It is found that of the four structures studied, the preferred composite substrate is a single layer of Ge ∼1 μm thick grown directly on a Si buffer layer. The double-crystal X-ray rocking curves of 2 μm thick GaAs films grown on such substrates have FWHM values as small as 168 arc sec. Transmission electron micrographs of these Ge/Si composite substrates has shown that the number of dislocations in the Ge heteroepitaxial layer can be greatly reduced by an anneal at about 750° C for 30 min which is simultaneously carried out during the growth of the GaAs layer. The quality of the GaAs layers grown on these composite substrates can be greatly improved by the use of a five-period GaAs-GaAsP strained-layer superlattice (SLS). Using the results of these studies, low-threshold optically pumped AlGaAs-GaAs DH laser structures have been grown by MOCVD on MBE Ge/Si composite substrates.     

A compact full MMIC module for Ku-band phase-lockedoscillators

A compact Ku-band phase-locked oscillator module has been developed in a full MMIC (monolithic microwave integrated circuit) configuration. The module includes an MMIC voltage-controlled oscillator, an analog frequency divider, and interstage amplifiers. The constituent monolithic chips are integrated in a very small single-package module and operate at the target frequencies without any external trimming or matching network. The oscillator is tuned more than 1 GHz with a constant output amplitude. The frequency-divided output is also obtained over the whole tuning range. Spurious output is not found at any frequency up to 22 GHz. In spite of the very low-Q factor of GaAs monolithic circuitry, the oscillator phase noise exhibited is less than -80 dBc/Hz, due to the high-gain, high-speed phase lock