Comparison of quantitative methods for analysis of polyphasic pharmaceuticals

Adequate very sensitive quantification methods are needed for the development and are also now required for the monitoring of undesirable solid form(s) as routine tests. The pre-requisite for quantitation are selectivity, sensitivity and most important the purity of standards and their proper storage, what is a challenge for metastable forms. Several analytical techniques are available such as X-ray diffraction, spectroscopy, thermal analysis and microcalorimetry. The different steps of the validation of the analytical methods and problems to be solved are discussed. Examples illustrate the different techniques and compare their possible advantages and limits. The relative standard deviation of measurements should allow for checking the homogenization procedure of mixtures for calibration. The validation should be carried out following ICH guidelines for validation of analytical methods. Comparison of different techniques in adequate concentration range add confidence in the analytical results.     

Supramolecular porphyrin-fullerene via 'two-point' binding strategy: axial-coordination and cation-crown ether complexation

A highly stable porphyrin-fullerene conjugate with defined distance and orientation, was formed using a newly developed 'two-point' binding strategy involving axial-coordination and cation-crown ether complexation; photochemical studies performed in benzonitrile revealed efficient charge separation and slow charge-recombination in the supramolecular complex.     

Temperature influence on hydrogen sorption in palladium limited-volume electrodes (Pd-LVE)

The effect of temperature on hydrogen and deuterium electrosorption into a palladium LVE (limited-volume electrode) has been investigated. A decrease in hydrogen capacity (H/Pd ratio) with increasing temperature has been observed. Temperature strongly influences the plots of measured H(D)/Pd values vs. potential scan rate. In addition, hydrogen absorption was found to be dependent on the composition of the surrounding electrolyte solution. These results have confirmed the hypothesis that two different mechanisms of hydrogen desorption from the palladium electrode take place, namely electrochemical oxidation and non-electrochemical recombination. Further, the ratio between the rate constants for these two processes has been found to change with temperature. Electronic Publication     

Kinetics of thermal decomposition of alkaline phosphates

Summary The thermal behavior of KH₂PO₄, NaH₂PO₄ and Na₂HPO₄ under non-isothermal conditions using TG method with different heating rates was studied. The values of the reaction rate were processed by means of Friedmans differential-isoconversional method. A dependence of the activation energy vs. conversion was observed. Therefore a procedure based on the compensation effect (suggested by Budrugeac and Segal) was applied. A less speculative data processing protocol was offered by the non-parametric kinetics method suggested by Serra, Nomen and Sempere. Three steps were observed by non-isothermal heating: a dehydration, a dimerization and a polycondensation. The differences in the intimate reaction mechanism are determined by the initial number of water molecules.     

Interaction of gas phase atomic hydrogen with Pt(111):Direct evidence for the formation of bulk hydrogen species

Employing hot tungsten filament to thermal dissociate molecular hydrogen,we generated gas phase atomic hydrogen under ultra-high vacuum(UHV)conditions and investigated its interaction with Pt(111) surface.Thermal desorption spectroscopy(TDS)results demonstrate that adsorption of molecular hy- drogen on Pt(111)forms surface Had species whereas adsorption of atomic hydrogen forms not only surface Had species but also bulk Had species.Bulk Had species is more thermal-unstable than surface Had species on Pt(111),suggesting that bulk Had species is more energetic.This kind of weakly- adsorbed bulk Had species might be the active hydrogen species in the Pt-catalyzed hydrogenation reactions.     

Backbone cleavages of [M - H](-) anions of peptides. Cyclisation of citropin 1 peptides involving reactions between the C-terminal [CONH](-) residue and backbone amide carbonyl groups. A new type of beta cleavage: a joint experimental and theoretical study

This paper reports the study of backbone cleavages in the collision-induced negative-ion mass spectra of the [M - H](-) anions of some synthetic modifications of the bioactive amphibian peptide citropin 1 (GLFDVIKKVASVIGGL-NH(2)). The peptides chosen for study contain no amino acid residues which could effect facile side-chain cleavage, i.e. Ser (-CH(2)O, side-chain cleavage) and Asp (-H(2)O) are replaced by Ala or Lys. We expected that such peptides should exhibit standard and pronounced peaks due to alpha cleavage ions (and to a lesser extent beta cleavage ions) in their collision-induced negative-ion spectra. This expectation was realised, but the spectra also contained peaks formed by a new series of cleavage anions. These are produced following cyclisation of the C-terminal CONH(-) moiety at carbonyl functions of amide groups along the peptide backbone; effectively transferring the NH of the C-terminal CONH(-) group to other amino acid residues. We have called the product anions of these processes beta' ions, in order to distinguish them from standard beta ions. Some beta' ions also fragment directly to some other beta' ions of smaller mass. The reaction coordinates of alpha,beta and beta' backbone processes have been calculated at the HF/6-31G*//AM1 level theory for simple model systems. The initial cyclisation step of the beta' sequence is barrierless and exothermic. Subsequent steps have a maximum barrier of +40 kcal mol(-1), with the overall reaction being endothermic by some 30 kcal mol(-1) at the level of theory used. These calculations take no account of the complexity of the conformationally flexible peptide system, and it is surprising that each of the two reacting centres can 'find' each other in such a large system.     

An Easy One-Pot Procedure for the Synthesis of <Emphasis Type="Italic">N</Emphasis>-Sulfonyl Phosphorous Ylides and Sulfonyl Iminophosphoranes

Summary. Reaction of triphenylphosphine and an electron deficient acetylenic ester in the presence of strong N–H acid such as alkyl and aryl sulfamides or acetamide produces phosphorous ylides at room temperature in CH₂Cl₂. The aryl sulfamide phosphoranes undergo a smooth transformation reaction in boiling toluene and produce iminophosphoranes.     

Host-guest complexes of crown ethers with HN-proton-donor molecules

Crown ethers were reacted with HN-proton-donor molecules to obtain crystalline molecular host-guest complexes. It was found that complexes with crown ethers of different structure are formed, depending on the linear dimensions and mode of steric shielding of active centers of the proton-donor molecules.Translated from Zhurnal Obshchei Khimii, Vol. 74, No. 12, 2004, pp. 2030–2033.Original Russian Text Copyright © 2004 by Wang, Ganin.This revised version was published online in April 2005 with a corrected cover date.