MCM用氮化铝共烧多层陶瓷基板的研究

通过实验优化AlN(氮化铝)瓷料配方及排胶工艺,对共烧W(钨)导体浆料性能及AlN多层基板的高温共烧工艺进行了研究,并对AlN多层基板的界面进行了扫描电镜分析。采用AlN流延生瓷片与W高温共烧的方法,成功地制备出了高热导率的AlN多层陶瓷基板,其热导率为190 W/(m·K),线膨胀系数为4.6106℃1(RT~400℃),布线层数9层,W导体方阻为9.8 m,翘曲度为0.01 mm/50 mm,完全满足高功率MCM的使用要求。     

K- and Q-bands CMOS frequency sources with X-band quadrature VCO

Fully integrated 10-, 20-, and 40-GHz frequency sources are presented, which are implemented with a 0.18-/spl mu/m CMOS process. A 10-GHz quadrature voltage-controlled oscillator (QVCO) is designed to have output with a low dc level, which can be effectively followed by a frequency multiplier. The proposed multipliers generate signals of 20 and 40 GHz using the harmonics of the QVCO. To have more harmonic power, a frequency doubler with pinchoff clipping is used without any buffers or dc-level shifters. The QVCO has a low phase noise of -118.67 dBc/Hz at a 1-MHz offset frequency with a 1.8-V power supply. The transistor size effect on phase noise is investigated. The frequency doubler has a low phase noise of -111.67 dBc/Hz at a 1-MHz offset frequency is measured, which is 7 dB higher than a phase noise of the QVCO. The doubler can be tuned between 19.8-22 GHz and the output is -6.83 dBm. A fourth-order frequency multiplier, which is used to obtain 40-GHz outputs, shows a phase noise of -102.0 dBc/Hz at 1-MHz offset frequency with the output power of -18.0 dBm. A large tuning range of 39.3-43.67 GHz (10%) is observed.     

中国西南武陵山区跳蛛新种记述（蜘蛛目：跳蛛科）

本文记述跳蛛科13个新种,采自西南武陵山地区。暗跳蛛Asemonea、列锡蛛Lycidas和法老蛛Pharacocerus 3属为我国新记录属。     

Studies on self-pumped phase conjugation in Cu-doped (K0.5Na0.5)0.2(Sr0.61Ba0.39)0.9Nb2O6 crystals

The use of Cu-doped (K_0.5Na_0.5)_0.2(Sr_0.61Ba_0.39)_0.9Nb₂O₆ as self-pumped phase conjugators using internal reflection is reported. Reflectivities as high as 63% at 5145.5 nm and 60% at 632.8 nm were realized. It was found that the photorefractive response changes significantly at different doping concentration. The responses of the crystals to the laser wavelength, incident angle and dopant concentration are studied.     

共面转换液晶显示器中获得对比度高于1:600的新技术

薄膜晶体管液晶电视(TFT-LCD TV)因为具有薄、轻、紧凑和可随意放置的特点，已经占据了大部分电视机市场。除了这些物理特性以外，最重要的特性是已具有了良好像质的对比度。为了将对比度提高到1：600以上，对偏振片膜、背光源板、滤色片树脂、电极锥角和摩擦条件等都进行了研究。优化的背光板组合，光滑的电极锥角和摩擦方法的控制是提高对比度的主要控制因素。应用新开发的滤色片树脂，对获得高对比度最为有效。     

Improved domino logic for high speed design

Techniques are introduced to improve the speed of domino logic. With an inverted clock scheme, a serial transistor is removed and capacitances at the output node are reduced in the new structures. HSPICE simulation shows that over 20% performance enhancement is achieved.     

Competitive influence of atactic polystyrene and supercritical carbon dioxide on the conformation of syndiotactic polystyrene

The crystallization behavior of miscible syndiotactic polystyrene (sPS) and atactic polystyrene (aPS) blends with different sPS/aPS weight ratios was investigated in supercritical CO₂ by using Fourier‐transform infrared spectroscopy, differential scanning calorimetry, and wide‐angle X‐ray diffraction. Supercritical CO₂ and aPS exhibited different effects on the conformational change of sPS and competed with each other. Increasing the content of amorphous aPS in the blends made its effect on the conformational change of sPS gradually surpass that of supercritical CO₂. Supercritical CO₂ favored the formation of the helical conformation of sPS in lower temperature range and the all trans planar conformation in higher temperature range, instead of forming the latter one only in higher temperature range in ambient atmosphere. However, increasing aPS content in the blends pushed the range for forming the helical conformation to lower temperature and made the all trans planar conformation dominant in aPS/sPS 25/75 blend after treating in supercritical CO₂ above 60 °C. The all trans planar zigzag conformation was more favorable than the helical conformation after mixing aPS in sPS in supercritical CO₂. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1755–1764, 2007     

Measurements of coupling and reflection characteristics of butt-joints in passive waveguide integrated laser diodes

Amplified spontaneous emission (ASE) spectra of passive waveguide integrated lasers have been studied to estimate the coupling efficiency and the reflectivity at the butt-joints between active and passive waveguides. A new method has been proposed for the analysis of ASE to extract the coupling efficiency and reflectivity at the butt-joints. This method was applied experimentally to estimate the coupling and reflection of the passive waveguide integrated lasers with different amounts of vertical misalignments of active and passive waveguides.     

Nonlinear rheological behavior of silica filled solution‐polymerized styrene butadiene rubber

The reinforcement and nonlinear viscoelastic behavior have been investigated for silica (SiO₂) filled solution‐polymerized styrene butadiene rubber (SSBR). Experimental results reveal that the nonlinear viscoelastic behavior of the filled rubber is similar to that of unfilled SSBR, which is inconsistent with the general concept that this characteristic comes from the breakdown and reformation of the filler network. It is interesting that the curves of either dynamic storage modulus (G′) or loss tangent (tan δ) versus strain amplitude (γ) for the filled rubber can be superposed, respectively, on those for the unfilled one, suggesting that the primary mechanism for the Payne effect is mainly involved in the nature of the entanglement network in rubbery matrix. It is believed there exists a cooperation between the breakdown and reformation of the filler network and the molecular disentanglement, resulting in enhancing the Payne effect and improving the mechanical hysteresis at high strain amplitudes. Moreover, the vertical and the horizontal shift factors for constructing the master curves could be well understood on the basis of the reinforcement factor f(φ) and the strain amplification factor A(φ), respectively. The surface modification of SiO₂ causes a decrease in f(φ), which is ascribed to weakeness of the filler–filler interaction and improvement of the filler dispersion. However, the surface nature of SiO₂ hardly affects A(φ). © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2594‐2602, 2007