A 0.18-/spl mu/m SiGe BiCMOS receiver and transmitter chipset for SONET OC-768 transmission systems

A 43-Gb/s receiver (Rx) and transmitter (Tx) chip set for SONET OC-768 transmission systems is reported. Both ICs are implemented in a 0.18-/spl mu/m SiGe BiCMOS technology featuring 120-GHz f/sub T/ and 100 GHz f/sub max/. The Rx includes a limiting amplifier, a half-rate clock and data recovery unit, a 1:4 demultiplexer, a frequency acquisition aid, and a frequency lock detector. Input sensitivity for a bit-error rate less than 10/sup -9/ is 40 mV and jitter generation better than 230 fs rms. The IC dissipates 2.4 W from a -3.6-V supply voltage. The Tx integrates a half-rate clock multiplier unit with a 4:1 multiplexer. Measured clock jitter generation is better than 170 fs rms. The IC consumes 2.3 W from a -3.6-V supply voltage.     

Neural net analysis of integrated circuit yield dependence on CMOS process control parameters

In this practical case study the method of self-organizing map (SOM) neural net is applied to analyze a CMOS process problem, where the device under study is a heartbeat rate monitor integrated circuit. The wafer yield is analyzed against the process control monitoring (PCM) parameter measurement values. The SOM efficiently reduces the parameter space dimensions and helps in visualizing the different parameter relations. This makes it possible to identify the most probable PCM parameters affecting the yield. Those were found out to be NMOS transistor drain current and aluminium sheet resistance.     

Bandwidth of reflectarrays

It is shown that the dominant factor controlling reflectarray bandwidth is the bandwidth of the radiating element, and that the effect of non-constant path delays over the surface of the flat reflector has little significance unless the aperture is electrically very large and the f/D ratio is small. An example of a polarisation-twist reflectarray using aperture coupled elements with time delay lines is used to demonstrate this conclusion.     

1,3-dihalo-5,5-dimethylhydantoin/NaNO2 as an efficient heterogeneous system for the N-nitrosation of N,N-dialkylamines under mild conditions

A combination of 1,3-dihalo-5,5-dimethylhydantoin (X = Br, Cl) and sodium nitrite in the presence of wet SiO₂ was used as an effective nitrosating agent for the nitrosation of N,N-dialkyl amines to their corresponding nitroso derivatives under mild and heterogeneous conditions in good to excellent yields.     

Evanescently coupled photodiodes integrating a double-stage taper for 40-Gb/s applications-compared performance with side-illuminated photodiodes

The design, fabrication, and performance of double-stage taper photodiodes (DSTPs) are reported. The objective of this work is to develop devices compatible with 40-Gb/s applications. Such devices require high efficiency, ultrawide band, high optical power handling capability, and compatibility with low-cost module fabrication. The integration of mode size converters improves both the coupling efficiency and the responsivity with a large fiber mode diameter. Responsivity of 0.6 A/W and 0.45 A/W are achieved with a 6-/spl mu/m fiber mode diameter and cleaved fiber, respectively, providing relaxed alignment tolerances (/spl plusmn/1.6 /spl mu/m and /spl plusmn/2 /spl mu/m, respectively), compatible with cost-effective packaging techniques. DSTPs also offer a wide bandwidth greater than 40 GHz and transverse-electric/transverse-magnetic polarization dependence lower than 0.2 dB. Furthermore, a DSTP saturation current as high as 11 mA results in optical power handling greater than +10 dBm and a high output voltage of 0.8 V. These capabilities allow the photodiode to drive the decision circuit without the need of a broad-band electrical amplifier. The DSTP devices presented here demonstrate higher responsivities with large fiber mode diameter and better optical power handling capabilities and are compared with classical side-illuminated photodiodes.     

On the Local Uniqueness of Solutions of Variational Inequalities Under H-Differentiability

In this paper, we give some sufficient conditions for the local uniqueness of solutions to nonsmooth variational inequalities where the underlying functions are H-differentiable and the underlying set is a closed convex set/polyhedral set/box/polyhedral cone. We show how the solution of a linearized variational inequality is related to the solution of the variational inequality. These results extend/unify various similar results proved for C ¹ and locally Lipschitzian variational inequality problems. When specialized to the nonlinear complementarity problem, our results extend/unify those of C ² and C ¹ nonlinear complementarity problems.     

Adaptive antenna system design for multi-element combining with transient interrupted channels

This paper presents an analysis and design procedure for a buoyant cable array antenna used for satellite communications. The towed multi-element array is susceptible to washovers and fluctuations due to the ocean wave interaction with the floating hose where the elements are housed. A model of system performance for coherent multi-element combining is presented based on the dropouts and fades of the individual elements. The array design, including the number and spacing of elements, is shown to be highly dependent on the individual element exposure characteristics and the degree of correlation of the fades between channels. The joint statistics of the array are analyzed using a binary conditional element exposure model and a first-order Markov interelement correlation model. Using this analysis, a family of array designs meeting the communications requirements is produced.     

Improvement in the DOA estimation of broadband signals usingpartially IIR beamformers

An ideal broadband beamformer requires an increased number of taps for each filter, which in turn increases the complexity of the design. It is shown that for angles near the broadside of the antenna the beamforming is more accurate compared to the angles near the endfire, and it is advantageous to use recursive filters combined with a computed number of zeros for angles near the endfire. The proposed method is used for estimating the arrival angle of the incoming signals and displays uniform accuracy for all angles     

LiNbO3 optical waveguides formed in a new proton source

Proton-exchanged planar waveguides have been fabricated on Z-cut and X-cut lithium niobate crystals by using a new proton source formed by a mixture of benzoic and adipic acids. Waveguide index profiles and optical characteristics have been obtained at different values of the adipic-benzoic acid concentration ratio. The samples have been structurally characterized by Raman and infrared (IR) absorption spectroscopy and double-crystal X-ray diffraction. Good quality samples have been fabricated by using 30 mol% ratio dilution, showing very low scattering levels (<0.1 dB/cm), relatively high electrooptic coefficient (r₃₃=0.88 pm/V), and low relative percentage of interstitial protons (26%). The main factor limiting the waveguide optical properties is the substitutional-interstitial proton ratio, which can be easily controlled to produce good quality waveguides. A demonstration of the repeatability of the exchange process in the acid mixture is also provided