A 60-GHz point-to-multipoint millimeter-wave fiber-radio communication system

A 60-GHz point-to-multipoint wireless access link with data rate of 156 Mb/s incorporating 60-GHz transceiver modules and full-duplex fiber-optic millimeter-wave transmission is developed for short-range applications such as indoor wireless local area networks and intelligent transport systems. For compact system configuration, a small-size millimeter-wave transceiver module with planar antennas is developed. The transceiver module is based on broadband planar integration and packaging of millimeter-wave circuits. The RF output power is +10 dBm and the measured 3-dB antenna beamwidth is 30/spl deg/. The total size of the developed 60-GHz transceiver module, except input and output connectors, is 50 mm /spl times/ 75 mm /spl times/ 35 mm. A point-to-point full duplex fiber-optic configuration is extended to the scheme with multiple access points (APs) by using a tree coupler and a dense wavelength division multiplexing multiplexer. The AP has a simple configuration without frequency conversion. The bit error rate and packet error rate performances of the 60-GHz fiber-radio access link are evaluated. Furthermore, the effect of the extension to the scheme with multiple APs is investigated.     

A miniature UWB planar monopole antenna with 5-GHz band-rejection filter and the time-domain characteristics

A planar monopole antenna with a staircase shape and small volume (25/spl times/26/spl times/1 mm/sup 3/) is proposed in this paper. With the use of a half-bowtie radiating element, the staircase-shape, and a modified ground plane structure, the proposed antenna has a very wide impedance bandwidth measured at about 11.6 GHz (2.9-14.5 GHz, bandwidth ratio about 1:5) below VSWR 2 including the WLAN band notched in the vicinity of 5 GHz. An omnidirectional radiation pattern is obtained. The group delay which is an indication of linearity between two proposed antennas is less than 1 ns. The electrical characteristics in terms of frequency and time domains and physical ones of the proposed antenna make it attractive for use in ultrawideband (UWB) systems.     

Enhanced carrier confinement in AlInGaN-InGaN quantum wells in near ultraviolet light-emitting diodes

To increase carrier confinement, the GaN barrier layer was substituted with an AlInGaN quaternary barrier layer which was lattice-matched to GaN in the GaN-InGaN multiple quantum wells (MQWs). Photoluminescence (PL) and high-resolution X-ray diffraction measurements showed that the AlInGaN barrier layer has a higher bandgap energy than the originally used GaN barrier layer. The PL intensity of the five periods of AlInGaN-InGaN MQWs was increased by three times compared to that of InGaN-GaN MQWs. The electroluminescence (EL) emission peak of AlInGaN-InGaN MQWs ultraviolet light-emitting diode (UV LED) was blue-shifted, compared to a GaN-InGaN MQWs UV LED and the integrated EL intensity of the AlInGaN-InGaN MQWs UV LED increased linearly up to 100 mA. These results indicated that the AlInGaN-InGaN MQWs UV LED has a stronger carrier confinement than a GaN-InGaN MQWs UV LED due to the larger barrier height of the AlInGaN barrier layer compared to a GaN barrier layer.     

High-performance 94-GHz single balanced mixer using 70-nm MHEMTs and surface micromachined technology

We reported 94-GHz, low conversion loss, and high isolation single balanced active gate mixer based on 70-nm gate length InGaAs/InAlAs metamorphic high-electron mobility transistors (MHEMTs). This mixer showed that the conversion loss and isolation characteristics were 2.5/spl sim/3.5 dB and under -29 dB in the range of 92.95/spl sim/94.5 GHz, respectively. The low conversion loss of the mixer is mainly attributed to the high-performance of the MHEMTs exhibiting a maximum drain current density of 607 mA/mm, an extrinsic transconductance of 1015 mS/mm, a current gain cutoff frequency (f/sub t/) of 330 GHz, and a maximum oscillation frequency (f/sub max/) of 425 GHz. High isolation characteristics are due to hybrid ring coupler which adopted dielectric-supported air-gapped microstrip line structure using surface micromachined technology. To our knowledge, these results are the best performance demonstrated from 94 GHz single balanced mixer utilizing GaAs-based HEMTs in terms of conversion loss as well as isolation characteristics.     

Convenient Synthesis of Phenyl Pyridyl-Ethers Utilizing Fluoride Ion

Aryl pyridyl ethers were prepared from phenols and active halopyridines under essentially neutral condition via fluoride ion assisted reaction.     

Note on generalized Wiener integrals

We establish a change of path formula for generalized Wiener integrals and develop a rotation theorem for Wiener measure with respect to Gaussian paths.     

Investigation on the stress behavior of cellulose acetate and the development of highly moisture‐resistant optical films for display devices

An optical film with high optical anisotropy was prepared by the stretching of a cellulose acetate film and the consequential orienting of a retardation‐enhancing additive. The change in retardation in response to moisture absorption was explored and it was found that the degree of the retardation variation is strongly related to the stretching temperature. Stress generated by the stretching and its relaxation was systematically investigated to elucidate the effect of stretching temperature on the irreversible change in retardation upon moisture absorption. The results show that the magnitude of releasable stress plays an important role in controlling changes in optical properties. In addition, the difference in the deformation behavior between glassy and rubbery states should be taken into account in the development of a moisture‐resistant optical film. © 2017 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2017 , 55, 1470–1478     

Quantitative determination of duloxetine and its metabolite in rat plasma by HPLC‐MS/MS

The major metabolite of duloxetine is a glucuronide conjugate of 4‐hydroxy duloxetine (4‐HD). However, interestingly, there have been no reports determining concentrations of 4‐HD and no fully validated method has been established for measuring duloxetine and 4‐HD in rat plasma. We developed a method for the simultaneous quantification of duloxetine and its metabolite in rat plasma using high‐performance liquid chromatography tandem mass spectrometry. Duloxetine and 4‐HD were analyzed on a reverse‐phase C₁₈ analytical column after protein precipitation of the plasma sample with methanol, using carbamazepine as an internal standard. The isocratic mobile phase of 5 mm ammonium acetate–methanol (4:6, v/v) was eluted at 0.4 mL/min. Quantification was performed on a triple‐quadrupole mass spectrometer using electrospray ionization, and the ion transition monitored in selective reaction monitoring mode. The coefficient of variation for assay precision was <18.0%, and the accuracy was 84.0–118.0%. This method was successfully used to measure the concentrations of duloxetine and its metabolite in plasma following the oral administration of a single 40 mg/kg dose in rats. Copyright © 2013 John Wiley & Sons, Ltd.