A One‐Kilobit PQR‐CMOS Smart Pixel Array

The photonic quantum ring (PQR) laser is a three dimensional whispering gallery (WG) mode laser and has anomalous quantum wire properties, such as microampere to nanoampere range threshold currents and √T‐dependent thermal red shifts. We observed uniform bottom emissions from a 1‐kb smart pixel chip of a 32×32 InGaAs PQR laser array flip‐chip bonded to a 0.35 µm CMOS‐based PQR laser driver. The PQR‐CMOS smart pixel array, now operating at 30 MHz, will be improved to the GHz frequency range through device and circuit optimization.     

Electrotunable Non‐reciprocal Laser Emission from a Liquid‐Crystal Photonic Device

A liquid crystal (LC) photonic device with an anisotropic optical heterojunction structure has been fabricated. The device has a phase‐retarding nematic LC (NLC) layer sandwiched between two polymer cholesteric LC films with right‐handed helices of different pitches. Electrotunable non‐reciprocal light transmittance and unidirectional circularly polarized (CP) lasing emission have been successfully demonstrated for this device structure. Two left CP (LCP) lasing emission peaks are observed at the edges of the overlapping region between the two photonic bands in the structure and are shifted upon the application of a voltage. In contrast, a non‐reciprocal right CP (RCP) lasing emission peak emerges at one of the band edges and diminishes upon the application of a voltage. These phenomena are interpreted based on the selective reflection of RCP light and the reorientation of the NLC molecules by the application of a voltage.     

A fiber depolarizer using polarization beam splitter loop structure for narrow linewidth light source

A new fiber depolarizer employing a polarization beam splitter loop structure is proposed and demonstrated. The depolarizer is devised for broad-band operation and the depolarization of narrow linewidth light source without any help of polarization controllers or Faraday rotator mirrors. A polarizing method is developed that shows good performance without polarization control unit. Therefore, the proposed depolarizer can be cost-effective and easily configured. From experiments, low output degree of polarization less than 10% is obtained for a narrow linewidth light source.     

Parasitic-aware RF circuit design and optimization

RF circuit synthesis techniques based on particle swarm optimization and adaptive simulated annealing with tunneling are described, and comparisons of parasitic-aware designs of an RF distributed amplifier and a nonlinear power amplifier are presented. Synthesized in 0.35-/spl mu/m digital CMOS using a single 3.3-V power supply, the designs provide an 8-dB gain and 8-GHz bandwidth for a four-stage distributed amplifier, and 1.2-W output power with 55% drain efficiency at 900 MHz for a three-stage power amplifier. A standard circuit simulator, HSPICE or SPECTRE, embedded in an optimization loop is used to evaluate cost functions. The proposed design and optimization methodology is computationally efficient and robust in searching complex multidimensional design spaces.     

Monolithic SiGe Up‐/Down‐Conversion Mixers with Active Baluns

The purpose of this paper is to describe the implementation of monolithically matching circuits, interface circuits, and RF core circuits to the same substrate. We designed and fabricated on‐chip 1 to 6 GHz up‐conversion and 1 to 8 GHz down‐conversion mixers using a 0.8 µm SiGe hetero‐junction bipolar transistor (HBT) process technology. To fabricate a SiGe HBT, we used a reduced pressure chemical vapor deposition (RPCVD) system to grow a base epitaxial layer, and we adopted local oxidation of silicon (LOCOS) isolation to separate the device terminals. An up‐conversion mixer was implemented on‐chip using an intermediate frequency (IF) matching circuit, local oscillator (LO)/radio frequency (RF) wideband matching circuits, LO/IF input balun circuits, and an RF output balun circuit. The measured results of the fabricated up‐conversion mixer show a positive power conversion gain from 1 to 6 GHz and a bandwidth of about 4.5 GHz. Also, the down‐conversion mixer was implemented on‐chip using LO/RF wideband matching circuits, LO/RF input balun circuits, and an IF output balun circuit. The measured results of the fabricated down‐conversion mixer show a positive power conversion gain from 1 to 8 GHz and a bandwidth of about 4.5 GHz.     

Semiconductor optical amplifier for CWDM operating over 1540-1620 nm

A semiconductor optical amplifier was developed for coarse wavelength-division-multiplexing (CWDM) operating over 1540-1620 nm (C-L band). A unique quantum-well structure was designed to meet the requirements for the CWDM operation such as wide bandwidth, low polarization-dependent gain, and high-saturation power at the short wavelength end of the band (1540 nm). Over the band, 24-dB maximum chip gain was obtained with less than 4.3-dB gain flatness and more than 14.6-dBm saturation power.     

2.488 Gb/s-318 km repeaterless transmission using erbium-dopedfiber amplifiers in a direct-detection system

The authors have achieved a 2.488 Gb/s, 318 km repeaterless transmission without any fiber dispersion penalty through a nondispersion-shifted fiber in a direct detection system. The system was loss limited with a T-R power budget of 57 dB. Three key components enabled the authors to achieve this result: (1) a Ti:LiNbO₃ external amplitude modulator enabling a dispersion-free transmission, (2) erbium-doped fiber amplifiers increasing the transmitting power to +16 dBm, and (3) an erbium-doped fiber preamplifier enabling a high-receiver sensitivity of -4.1 dBm for 10^-9 BER. To the author's knowledge, this result is the longest repeaterless transmission span length ever reported for direct detection at this bit rate. From the experimental results and a theoretical model, the authors identified the sources of the receiver sensitivity degradation from the quantum limit (-48.6 dBm) and estimated the practically achievable receiver sensitivity of ~-44 dBm (~-124 photons/bit) for 2.5 Gb/s optical preamplifier detection     

Pseudorandomness of Basic Structures in the Block Cipher KASUMI

The notion of pseudorandomness is the theoretical foundation on which to consider the soundness of a basic structure used in some block ciphers. We examine the pseudorandomness of the block cipher KASUMI, which will be used in the next‐generation cellular phones. First, we prove that the four‐round unbalanced MISTY‐type transformation is pseudorandom in order to illustrate the pseudorandomness of the inside round function FI of KASUMI under an adaptive distinguisher model. Second, we show that the three‐round KASUMI‐like structure is not pseudorandom but the four‐round KASUMI‐like structure is pseudorandom under a non‐adaptive distinguisher model.     

共面转换液晶显示器中获得对比度高于1:600的新技术

薄膜晶体管液晶电视(TFT-LCD TV)因为具有薄、轻、紧凑和可随意放置的特点，已经占据了大部分电视机市场。除了这些物理特性以外，最重要的特性是已具有了良好像质的对比度。为了将对比度提高到1：600以上，对偏振片膜、背光源板、滤色片树脂、电极锥角和摩擦条件等都进行了研究。优化的背光板组合，光滑的电极锥角和摩擦方法的控制是提高对比度的主要控制因素。应用新开发的滤色片树脂，对获得高对比度最为有效。