基于CB的串行口和接口板端口程序应用

串行口及接口板端口是计算机通信的主要途径 ,也是目前计算机工程测控中通用的基本方法。C Builder (简称CB)编程语言以其功能完备、开发效率高的特点而成为目前流行的程序开发工具 ,介绍了利用CB语言编写串行口和端口通信的程序的方法 ,并对具体的各方法编写了相应的示例。     

Blind feedforward cyclostationarity-based timing estimation for linear modulations

By exploiting a general cyclostationary (CS) statistics-based framework, this letter develops a rigorous and unified asymptotic (large sample) performance analysis setup for a class of blind feedforward timing epoch estimators for linear modulations transmitted through time nonselective flat-fading channels. Within the proposed CS framework, it is shown that several estimators proposed in the literature can be asymptotically interpreted as maximum likelihood (ML) estimators applied on a (sub)set of the second- (and/or higher) order statistics of the received signal. The asymptotic variance of these ML estimators is established in closed-form expression and compared with the modified Crame/spl acute/r-Rao bound. It is shown that the timing estimator proposed by Oerder and Meyr achieves asymptotically the best performance in the class of estimators which exploit all the second-order statistics of the received signal, and its performance is insensitive to oversampling rates P as long as P/spl ges/3. Further, an asymptotically best consistent estimator, which achieves the lowest asymptotic variance among all the possible estimators that can be derived by exploiting jointly the second- and fourth-order statistics of the received signal, is also proposed.     

Cs-K混合蒸气中Cs(8D)+K(4S)碰撞能量转移

在Cs-K混合蒸气中，两步激发Cs原子到8D态，观察了Cs(8D) K(4S)→Cs(5D) K(4P)碰撞能量合并逆过程(REP，reverse energy pooling)。应用双调制技术探测K(4P)原子发射的荧光，基态K原子密度用光学吸收方法测量。得到了REP速率系数，讨论了其它过程对速率系数的影响．     

用于提高国产氩离子激光器相干长度的相干扩展器

本文报导了最近研制成功的用于提高国产氩离子激光器相干长度的相干扩展器。利用这种基于F-P理论的相干扩展器可以使国产氩离子激光器的相干长度由不足5cm一下提高到m的量级,功率损耗在25%～40%之间,有着很好的应用前景。     

MEMS移相器及其在微型通信系统中的应用

从传统移相器的构造和原理出发，进一步分析了MEMS移相器的结构、特性。结果表明，MEMS移相器具有传统移相器所无法比拟的体积小、损耗小、成本低、频带宽、易于集成等突出优点。随着高阻硅衬底在微波领域应用的扩展，MEMS移相器介质损耗大幅度降低，将能与信号处理电路一同集成于硅衬底上，便于相控阵雷达等通信系统实现微小型化。     

NiTi合金中马氏体相的低频力学谱研究

我们用最近研制成功的LMA型低频力学谱测试系统对NiTi合金马氏体相进行了在很大频率范围内（0．003～1Hz）的低频等温力学谱和温度谱的测量．我们研究的形状记忆合金NiTi（Ni50．2at％）试样长34mm，直径1mm细丝．经一定热处理，分别在333K．343K和353K做了内耗随频率的变化的测量。实验表明：频率越小，内耗越大，也就是内耗随频率减少而增大。同时我们采用阶梯升温的方法在八个温度下每个温度测量三种频率（1Hz，0．1Hz，0．01Hz）的内耗，结果清楚地表明：不同频率下，内耗峰都出现在372K（99℃）。而且频率越低，峰高越高。这是具有相变峰的特点：相变峰的峰温不随测量频率不同而变化，相变峰高度随频率减少而增大。我们还测量了在1Hz与0．5Hz频率下内耗随温度的变化。本文用马氏体相的位错理论初步讨论了上述实验结果。     

Improvement of RCA transistor using RTA annealing after theformation of interfacial oxide

A polysilicon emitter RCA transistor (an ultra-thin interfacial oxide layer exists between polysilicon and silicon emitter) is presented which can operate at 77 K for the first time. An ultra-thin (1.5 nm) interfacial oxide layer is grown deliberately between polysilicon and silicon emitter using RCA oxidation and excellent device stability is obtained after rapid thermal annealing (RTA) treatment in nitrogen atmosphere. The RCA transistor exhibits good electrical performance at very low temperature for an emitter area of 3 × 8 μm². The maximum toggle frequency of a 1:2 static divider is 1.2 GHz and 732 MHz at 300 K and 77 K, respectively     

Optimal diagonal precoder for multiantenna communication systems

In this paper, we examine a multiantenna single-user wireless communication system fitted with a QR-based successive cancellation receiver (QR receiver). Initially, our consideration is confined to uncoded binary phase shift keying (BPSK) signals transmitted through independent and identically distributed (IID) Rayleigh fading channels and to the design of an optimum precoder for the transmitter. For minimum feeding back of the channel state information (CSI) to the transmitter from the receiver, we stipulate the precoder to be in the form of a power loading square diagonal matrix. We proceed to develop the theory for the design of this diagonal matrix based on the minimization of the lower bound of the average bit error rate (BER) of transmission. The design obtained provides substantially lower error rates than most of other existing schemes under the same environment. The corresponding gain in signal-to-noise ratio (SNR) can be several decibels. To further improve the performance, we extend the design to include an optimal detection order of the received bits using an iterative approach. This iterative process proves to have fast convergence and results in a design providing significant SNR gain. We also propose a subchannel dropping scheme for cases in which SNR is low, and when the minimum BER precoder is equipped with this scheme, its average performance can be substantially superior to the Vertical Bell Laboratories Layered Space-Time (V-BLAST) detection. We extend our design of the optimum precoder to quadrature amplitude modulation (QAM) modulation scheme and similar performance gain has been observed.     

用于实时数据传输的滑动帧方法及其实现

根据某雷达系统对测量信号的快速传输要求,提出采用滑动帧的处理方法并在FPGA中实现,克服了传统帧处理难以满足快速传输要求的不足。阐述了滑动帧结构的构造思想,详述了滑动帧结构的特点及具体功能模块的实现。根据实际应用需求构造了滑动帧结构处理器,试验和应用结果表明设计可行有效,能充分满足实时数据传输的要求。     

一种新的基于PARC技术的MIMO系统

MIMO (Multiple-Input Multiple-Output)的显著优点就是在不增加带宽的情况下,能够成倍地提高通信系统容量和频谱利用率,是未来移动通信与个人通信系统实现高速率数据传输,提高高传输质量的重要途径,也是未来移动通信系统广泛采用的关键技术.文中简要介绍了MIMO系统及其一种新的MIMO系统中的应用技术,即PARC(Per-antenna Rate Control)技术.