Low-truncation-error finite difference equations for photonicssimulation. II. Vertical-cavity surface-emitting lasers

For part I see, ibid., p. 134, 1998. The basic approach outlined in the previous article is applied to the difficult problem of computing the optical modes of a vertical-cavity surface-emitting laser. The formulation utilizes a finite difference equation based upon the lowest order term of an infinite series solution of the scalar Helmholtz equation in a local region. This difference equation becomes exact in the one-dimensional (1-D) limit, and is thus ideally suited for nearly 1-D devices such as vertical-cavity lasers. The performance of the resulting code is tested on both a simple cylindrical cavity with known solutions and an oxide-confined vertical-cavity laser structure, and the results compared against second-order-accurate code based upon Crank-Nicolson differencing     

On the reliability of Landsat TM for estimating forest variables byregression techniques: a methodological analysis

In order to build models that relate thematic mapper (TM) imagery to field forest variables, several regression techniques, such as the ones based on the Mallows' C_p and the adjusted R² statistics, were applied. Nevertheless, although the best created models had good fittings (R²>0.65) apparently supported by a clear statistical significance (p<0.0001), later trials tested with additional plots showed that these models were, in fact, nonrobust models (models with very low-predictive capabilities). Two factors were pointed out as causes of these inconsistencies between predicted and observed values: a relatively small number of available field plots and a relatively high number of possible independent variables. Actually, different trials suggested much lower fittings for the expected “really” predictive models. Some restrictions of TM satellite data, such as its radiometric, spectral, and spatial limitations, together with restrictions arising from gathering and processing of field data, might have led to these poor relations. This study shows the need for guarantees stronger than the usual ones before concluding that there is a clear possibility of using satellite information to estimate forest parameters by means of regression techniques     

Influence of the sulfonate countercation on the thermal stability of nafion perfluorosulfonate membranes

We report a strong dependence of the thermal stability of Nafion® perfluorosulfonate ionomer on the nature of the counterion associated with the fixed sulfonate site. These results were obtained using thermal gravimetric analysis on a series of alkali metal and alkyl ammonium cation-exchanged Nafion films. We have found that the temperature of decomposition of Nafion is inversely dependent on the size of the exchanged cation; i.e., Nafion films show improved thermal stability as the size of the counter cation decreases. We attribute this inverse relationship of thermal stability with counterion size to an initial decomposition reaction which is strongly influenced by the strength of the sulfonate-coun-terion interaction. © 1993 John Wiley & Sons, Inc.     

Correlation of the leakage current and charge pumping in silicon oninsulator gate-controlled diodes

The leakage and charge pumping currents were measured in gate-controlled MOS p-i-n diodes fabricated on thin SIMOX substrates. The efficiencies of the techniques as well as their complementary features are analyzed for various experimental conditions. The interface properties of device-grade SIMOX wafers are characterized and shown to be compatible with VLSI requirements. Special interface coupling effects, which occur only in fully depleted SOI devices and modify the conventional signature of charge pumping and leakage current, are thoroughly investigated     

Magnetometer spacing criterion for biomagnetic source currentimaging

A criterion for determining the maximum spacing between magnetometers for measuring the magnetic field is derived. A two-dimensional (2-D) filter model is employed to determine the maximum spatial frequency component present in the magnetic field that is above the spectral noise level. This maximum frequency component is then sampled at a rate greater than twice per period as indicated by the Nyquist criterion, yielding the required magnetometer spacing. It is shown that the rule-of-thumb employed in current clinical biomagnetic array systems, that the spacing between the coils should be approximately equal to the depth of the source, is adequate when the signal-to-noise power ratio is less than 28.4 (14.5 dB). The analysis also quantitatively demonstrates that reducing the separation between the measurement and source planes has a greater effect on the resolution than decreasing the noise level by the same factor. This result is important for employing high T_c superconductor magnetometers that allow thinner thermal insulating layers at the cost of higher thermal noise     

Minimum-phase filter design from linear-phase startpoint viabalanced model truncation

A new practical design approach for minimum-phase FIR or IIR filters, setting out from a high dimensionality FIR linear-phase prototype is described. The novelty of this technique lies in overcoming the inherent problem of finding the roots of a high order polynomial with repeated and/or very closely clustered roots     

Mixed Mode VLSI Implementation of a Neural Associative Memory

A mixed mode digital/analog special purpose VLSI hardware implementation of an associative memory with neural architecture is presented. The memory concept is based on a matrix architecture with binary storage elements holding the connection weights. To enhance the processing speed analog circuit techniques are applied to implement the algorithm for the association. To keep the memory density as high as possible two design strategies are considered. First, the number of transistors per storage element is kept to a minimum. In this paper a circuit technique that uses a single 6-transistor cell for weight storage and analog signal processing is proposed. Second, the device precision has been chosen to a moderate level to save area as much as possible. Since device mismatch limits the performance of analog circuits, the impact of device precision on the circuit performance is explicitly discussed. It is shown that the device precision limits the number of rows activated in parallel. Since the input vector as well as the output vector are considered to be sparsely coded it is concluded, that even for large matrices the proposed circuit technique is appropriate and ultra large scale integration with a large number of connection weights is feasible.     

The Cooperative Molecular Field Effect

Two‐dimensional arrangements of molecules can show remarkable cooperative electronic effects. Such effects can serve to achieve direct electronic sensing of chemical and physical processes via electrostatic effects, i.e., without transfer of charge or matter between the locus of sensing and that of detection.