A MODEL OF TROPICAL MARINE RESERVE‐FISHERY LINKAGES

ABSTRACT. The excessive and unsustainable exploitation of our marine resources has led to the promotion of marine reserves as a fisheries management tool. Marine reserves, areas in which fishing is restricted or prohibited, can offer opportunities for the recovery of exploited stock and fishery enhancement. In this paper we examine the contribution of fully protected tropical marine reserves to fishery enhancement by modeling marine reserve‐fishery linkages. The consequences of reserve establishment on the long‐run equilibrium fish biomass and fishery catch levels are evaluated. In contrast to earlier models this study highlights the roles of both adult (and juvenile) fish migration and larval dispersal between the reserve and fishing grounds by employing a spawner‐recruit model. Uniform larval dispersal, uniform larval retention and complete larval retention combined with zero, moderate and high fish migration scenarios are analyzed in turn. The numerical simulations are based on Mombasa Marine National Park, Kenya, a fully protected coral reef marine reserve comprising approximately 30% of former fishing grounds. Simulation results suggest that the establishment of a fully protected marine reserve will always lead to an increase in total fish biomass. If the fishery is moderately to heavily exploited, total fishery catch will be greater with the reserve in all scenarios of fish and larval movement. If the fishery faces low levels of exploitation, catches can be optimized without a reserve but with controlled fishing effort. With high fish migration from the reserve, catches are optimized with the reserve. The optimal area of the marine reserve depends on the exploitation rate in the neighboring fishing grounds. For example, if exploitation is maintained at 40%, the ‘optimal’ reserve size would be 10%. If the rate increases to 50%, then the reserve needs to be 30% of the management area in order to maximize catches. However, even in lower exploitation fisheries (below 40%), a small reserve (up to 20%) provides significantly higher gains in fish biomass than losses in catch. Marine reserves are a valuable fisheries management tool. To achieve maximum fishery benefits they should be complemented by fishing effort controls.     

Performance and modeling of advanced Ti:LiNbO3 digitaloptical switches

High-performance Y-branch digital optical switches realized in Ti:LiNbO₃ are presented. Their switching response functions have been optimized in terms of switch voltage and crosstalk ratio. The optimization is based on analyzing different types of waveguide shaping and switching arrangements using coupled mode theory and computer simulations. Excellent switching characteristics are achieved with devices exploiting a specially shaped waveguide branch in a dilated switch arrangement. Demonstrated performances include switching voltage as low as 9 V with crosstalk suppression better than 45 dB and fiber-to-fiber losses as low as 4 dB. Polarization independence with crosstalk suppression better than 40 dB over a 1520- to 1570-nm wavelength range is achieved for any applied switch voltage greater than 18 V. These optimized digital optical switches have further demonstrated the capability to reshape electrical input signals at switching rates of several hundred megahertz     

Electronic properties of Fibonacci quasi-periodic heterostructures

We study the electronic states of different GaAs-AlAs Fibonacci quasi-perodic heterostructures grown along the (001) direction. We employ an empirical tight-binding Hamiltonian including spin-orbit coupling together with the surface Green function matching method. We present results for the eighth Fibonacci generation formed from different building blocks. We compare these results with those of the constituent quantum wells and with those of heterostructures containing the same number of GaAs and AlAs slabs after periodic repetition of the building blocks. No Fibonacci spectrum is found in the energy regions near the conduction and valence band edges of GaAs. A selective localization of the local density of states in the GaAs layers is found for many electronic states.     

A high-linearity 100-element diode grid mixer

Grid-mixer arrays can achieve high linearity and dynamic range through quasi-optical power combining. We present a 100-element single-ended diode grid mixer operating at 2.45 GHz. Each element incorporates two diodes in series. We measure an input third-order intercept of 11 W (40.5 dBm), and output third-order intercept of 3.4 W (35.4 dBm), and an associated conversion loss of 5.1 dB. The power-handling capability of the array is 100 times larger than that of a microstrip mixer using a single element. The local oscillator (LO) drive requirement for the entire array is 1.4 W (31.6 dBm). The angular dependence of the array's IF power is also presented and is in agreement with theory     

Miscibility of bisphenol-A polycarbonate with poly(methyl methacrylate)

The miscibility of bisphenol-A polycarbonate (PC) with poly(methyl methacrylate) (PMMA) has been reexamined using differential scanning calorimetry (DSC) and optical indications for phase separation on heating, i.e., lower critical solution temperature (LCST) behavior. Various methods have been used to prepare the blends including methylene chloride (CH₂Cl₂) and tetrahydrofuran (THF) solution casting, melt mixing, and precipitation of PC and PMMA simultaneously from THF solution by using the nonsolvents methanol and heptane. It is shown that the resulting phase behavior for PC/PMMA blends is strongly affected by the blend preparation method. However, these blends are miscible over the whole blend composition range (unambiguous single composition-dependent T_g's and LCST behavior) when prepared by precipitation from solution using heptane as the nonsolvent. To the contrary, solution-cast and melt-mixed PC/PMMA blends were all phase separated, which may be attributed to the “solvent” effect and LCST behavior, respectively, not discovered in previous reports. Methanol precipitation does not lead to fully mixed blends, which demonstrates the importance of the choice of nonsolvent when using the precipitation method.     

Low-threshold, high-power zero-order lateral-mode DQW-SCH metal-clad ridge waveguide (AlGa)As/GaAs lasers

Metal-clad ridge waveguide (MCRW), double quantum well, separately confined heterostrucuture (DQW-SCH) lasers have been fabricated having continuous-wave (CW) threshold currents of 10?12 mA and external differential quantum efficiencies of 41?46% per uncoated facet. Light/current characteristics are linear to >70 mW, and zero-order lateral mode operation was measured at 56 mW. The CW burn-off power density is nearly double the best previously reported value.     

Stochastic radiative transfer in a finite plane-parallel medium with general boundary conditions

The time-independent radiative transfer problem in a scattering and absorbing planar random medium with general boundary conditions and internal energy source is considered. The medium is assumed to consist of two randomly mixed immiscible fluids, with the mixing statistics described as a two-state homogeneous Markov process. The problem is solved in terms of the solution of the corresponding free-source problem with simple boundary conditions which is solved using Pomraning-Eddington approximation in the deterministic case. A formalism, developed to treat radiative transfer in statistical mixtures, is used to obtain the ensemble-averaged solution. The average partial heat fluxes are calculated in terms of the albedoes of the source-free problem. Results are obtained for isotropic and anisotropic scattering for specular and diffused reflecting boundaries.     

Simulation of magnetic component models in electric circuitsincluding dynamic thermal effects

It is essential in the simulation of power electronics applications to model magnetic components accurately. In addition to modeling the nonlinear hysteresis behavior, eddy currents and winding losses must be included to provide a realistic model. In practice the losses in magnetic components give rise to significant temperature increases which can lead to major changes in the component behavior. In this paper a model of magnetic components is presented which integrates a nonlinear model of hysteresis, electro-magnetic windings and thermal behavior in a single model for use in circuit simulation of power electronics systems. Measurements and simulations are presented which demonstrate the accuracy of the approach for the electrical, magnetic and thermal domains across a variety of operating conditions, including static thermal conditions and dynamic self heating     

Coherence properties of the supercontinuum source

Mutual–temporal coherence of the supercontinuum (SC) generation has been experimentally investigated using a diffraction grating based interferometer. A broadband SC generation was produced in a pyrex glass plate with a 1.6-μm coherence length at 550-nm center wavelength. The degree of mutual coherence of 0.34 was measured for a wavefront shift for zero and first diffraction orders of half of the beam diameter. A design of SC source with the capability of manipulating the amplitudes and phases of optical frequency components within the SC pulse is presented for coherence applications.