A microfluidic device using a green organic light emitting diode as an integrated excitation source

A simply fabricated microfluidic device using a green organic light emitting diode (OLED) and thin film interference filter as integrated excitation source is presented and applied to fluorescence detection of proteins. A layer-by-layer compact system consisting of glass/PDMS microchip, pinhole, excitation filter and OLED is designed and equipped with a coaxial optical fiber and for fluorescence detection a 300 microm thick excitation filter is employed for eliminating nearly 80% of the unwanted light emitted by OLEDs which has overlaped with the fluorescence spectrum of the dyes. The distance between OLED illuminant and microchannels is limited to approximately 1 mm for sensitive detection. The achieved fluorescence signal of 300 microM Rhodamine 6G is about 13 times as high as that without the excitation filter and 3.5 times the result of a perpendicular detection structure. This system has been used for fluorescence detection of Rhodamine 6G, Alexa 532 and BSA conjugates in 4% linear polyacrymide (LPA) buffer (in 1 x TBE, pH 8.3) and 1.4 fmol and 35 fmol mass detection limits at 0.7 nl injection volume for Alexa and Rhodamine dye have been obtained, respectively.     

溶液酸度和反应温度对CaMoO4薄膜电化学制备的影响

本工作研究了恒电流电化学技术制备CaMoO₄薄膜工艺中，溶液酸度和反应温度对薄膜形成的影响。结果表明，酸度会影响薄膜的生长时间和光致发光特性，在较低酸度沉积薄膜时，容易造成薄膜的团簇生长和不确定相的形成；适当升高反应温度会加快晶粒的生长、提高薄膜的纯度、增加薄膜发射光谱的相对强度。在CaMoO₄薄膜电化学制备工艺中，溶液pH值控制在12.0附近和反应温度控制在60 ℃的左右比较好。     

Statistics aided optimization for high-performance liquid chromatographic analysis of organic acids in tobacco

HPLC analysis for organic acids in tobacco was optimized with the aid of statistical experimental design, a central composite face-centered design. In the design, only thirteen HPLC analyses were needed for identifying two optimal separation parameters. A Bio-Rad Aminex HPX-87H column was used for the analyses. An optimal separation for seven acids in tobacco was found at a temperature of 57 degrees C and a mobile phase of 0.032 N sulfuric acid solution, or at a temperature of 70 degrees C and a mobile phase of 0.024 N sulfuric acid solution, with a flow rate of 0.6 ml min(-1).     

毛细管电泳法快速分离和检测肠毒性大肠杆菌

 建立了快速分离和检测引起仔猪腹泻的肠毒性大肠杆菌K88、K99和 987P细菌细胞的毛细管区带电泳方法 ,并进行了腹泻仔猪粪便中肠毒性大肠杆菌的应用检测分析。结果表明 ,在电泳缓冲液为 0 0 5mol/LNa2 CO3 NaHCO3(pH 9 9)、分离电压为 1 4 1kV、检测波长为 2 1 0nm的电泳条件下 ,E coliK88、K99和 987P的细胞分别具有单一、稳定的特征谱峰 ,其保留时间的相对标准偏差RSD≤ 0 9% ;在确定的实验条件下 ,实现了腹泻仔猪粪便中肠毒性大肠杆菌的快速检测分析 ,发现将出生 5d～ 6d的腹泻仔猪粪便引入培养基中增殖后主要检出K88。     

传感法研究固态钢中镧活度

本文采用LaF3单晶固体电解质测量了473～1223K温度范围内钢中镧的活度.两个平行样品的活度值符合很好,并且LaF3单晶的起始工作温度约为880K.     

溴原子取代对二茂铁液晶化合物介晶性的影响

二茂铁液晶因其独特的稳定性和易于衍生化受到研究人员的青睐[1- 8] 。我们曾经报道过一类单取代二茂铁液晶的合成与介晶性[9] 。这里我们报道另外一类二茂铁单取代液晶 ,并对分子的长度、溴原子取代对介晶性的影响进行探讨。合成路线如下 :1　实验部分ＢｒｕｃｋｅｒＡＣＥ -2 0 0ｓｐｅｃｔｒｏｍｅｔｅｒ,ＣＤＣｌ3作溶剂。ＮｉｃｏｌｅｔＭａｇｎａ-ＩＲ 5 0 0Ｓｐｅｃｔｒｏｍｅｔｅｒ,ＳｅｒｉｅｓⅡ ,ＫＢｒ压片。ＷＲＳ -ＩＡ ,ＣａｒｌｏＥｒｂａ 1 1 0ｂ。Ｐｅｒｋｉｎ -Ｅｌｍｅｒ 7Ｓｅｒｉｅｓ热分析仪 ,分温速度 1 0℃ /ｍｉ…     

甲醇与乙醇一步合成异丁醛用CuO-ZnO/Al2O3催化剂

在ＣｕＯ－ＺｎＯ／Ａｌ２Ｏ３催化剂上，甲醇与乙醇在常压和２１０￣３６０℃温度下一步反应合成异丁醛。利用正交设计方法，研究了ＣｕＯ－ＺｎＯ／Ａｌ２Ｏ３体系催化剂组成和制备条件等因素对催化剂催化性能的影响。结果表明，催化剂中ＣｕＯ含量对催化剂的催化活性影响最大，而ＺｎＯ含量则主要影响催化剂对异丁醛的选择性。催化剂制备条件，如沉淀温度、陈化时间等，也不同程度也影响催化剂的催化性能。ＸＲＤ和ＢＥＴ表征结果     

增敏双波长光度法同时测定底泥中的铜和铬

在pH6．4的磷酸二氢钾-磷酸氢二钾缓冲液和CIMAJB、正丁醇、正庚烷组成的微乳液的介质中，水杨基荧光酮与铜（Ⅱ）、铬（Ⅵ）的显色体系灵敏度都有很大提高，选择了合适的测定波长，利用双波长解方程组法同时测定了底泥中的铜和铬。结果令人满意。     

ADSORPTION OF 2,4-DICHLOROBENZOXYACETIC ACID ONTO HYPERCROSSLINKED RESIN MODIFIED BY PHENOLIC HYDROXYL GROUP (AM-1)

INTRODUCTIONAdsorption has been considered to be the best available technology for removing organics from water in the USSafe Drinking Water Act[1]. Due to many drawbacks of activated carbon[2-7], the most widely used adsorbent,hypercrosslinked polymeric adsorbents developed by Tsyurupa and Davankov[8] have been increasingly viewedas an alternative to activated carbon for selective removal of specific organic substances from contaminatedwater[9-12], and series of researches have been do…