Ultraviolet emission spectra of sunbeds

It is well known that UV radiation contributes to the development of skin cancer. Exposure to solar radiation is predominantly responsible for the high incidence rate of skin cancer, but there are also indications that sunbeds are involved. The aim of the present investigation was to determine the UV emission spectra of sunbeds. It included the most common sunbed models, which cover more than 50% of the Swiss market. The UV emission spectra of sunbeds have special characteristics and are different from the sun spectrum, which can be seen in high-resolution spectral measurements. Sunbed emission spectra are similar to the sun spectrum in the UVB (280-320 nm) range but reach values 10 to 15 times higher in the UVA (320-400 nm) range. An average erythema-effective irradiance of 0.33 W/m2 was determined for sunbeds. This corresponds to a UV index of 13, which is significantly higher than the UV index of 8.5 of the high summer sun at noon at intermediate latitudes. The measurements were spread over the whole effective area of the sunbeds, and an inhomogeneous distribution of the irradiances with variations of up to 30% from the average value was found.     

Molecular ordering and 2D conductivity in ultrathin poly(3-hexylthiophene)/gold nanoparticle composite films

This paper reports the first comparison of the structure and electrical conductivity properties of spin cast (SC) and Langmuir-Schaeffer (LS) films of regioregular poly(3-hexylthiophene) (P3HT). In addition, the effect of incorporating highly monodisperse Au nanoparticles (NPs), with a core diameter of approximately 5 nm, into SC and LS P3HT films is described. A detailed picture of molecular organization in the films has been obtained using ultraviolet-visible absorption spectroscopy, atomic force microscopy, field-emission scanning electron microscopy, X-ray diffraction, and X-ray reflectivity. Film morphology was correlated with pseudo-two-dimensional conductivity measured using scanning electrochemical microscopy, with P3HT in the semiconducting regime. It was found that SC films, which were slightly thicker than those formed with the LS technique, exhibited greater organization. This resulted in an order of magnitude higher lateral conductivity for the SC films. Inclusion of Au NPs (50 wt %) into both SC and LS films resulted in the formation of uniform and relatively flat (rms roughness approximately 1 nm) composite films. Surprisingly, the addition of NPs did not disrupt the characteristic crystal structure found for the native P3HT films. The effect of Au NPs on film lateral conductivity was found to be determined by the distribution of Au NPs within the polymer, which varied significantly between SC and LS films. Whereas Au NPs aggregated into hexagonally packed clusters in SC films, NPs in LS films were predominantly uniformly distributed between the lamella bilayer. It was found that, while the inclusion of Au NPs caused the lateral conductivity to decrease in SC films, in LS films, the lateral conductivity increased by a factor of 2.     

Kinetic resolution of atropisomeric amides

We have demonstrated the feasibility of the kinetic resolution of atropisomeric amides using the commercially avaliable AD-mix. To our knowledge, this methodology represents the first catalytic kinetic resolution of such compounds. Relative rates of up to 32 have been found for the kinetic resolution processes. We have also determined the barriers to rotation and half-lives of some of these amides. The half-lives range from 7 to 135 h at room temperature.     

Anion control of isomerism, crystal packing and binding properties in a mononuclear zinc complex

The coordination chemistry of the tetradentate pyridyl N-donor ligand cis-3,5-bis-[2-pyridinyleneamin]-trans-hydroxycyclohexane (DDOP) has been investigated with zinc(II) nitrate and triflate. The resulting complexes, [Zn(DDOP)(H₂O)(NO₃)](NO₃) (1), and [Zn(DDOP)(H₂O)(OTf)](OTf) (2) differ not only in their counterions, but also the arrangement of the axial ligands and their solid state hydrogen bonded networks. Isothermal titration calorimetry was used to assess the difference in binding properties exhibited by the two zinc complexes at physiological pH in an aqueous environment. A series of coordinating amino acids were found to preferentially bind to the mononuclear zinc triflate (1) complex over the corresponding nitrate (2) assembly, with histidine exhibiting a two centre binding mode.     

Atomistic molecular dynamics simulations of chemical force microscopy

Chemical force microscopy and related force measurement techniques have emerged as powerful tools for studying fundamental interactions central to understanding adhesion and tribology at the molecular scale. However, detailed interpretation of these interactions requires knowledge of chemical and physical processes occurring in the region of the tip-sample junction that experiments cannot provide, such as atomic-scale motions and distribution of forces. In an effort to address some of these open issues, atomistic molecular dynamics simulations were performed modeling a chemical force microscope stylus covered with a planar C12 alkylthiolate self-assembled monolayer (SAM) interacting with a solid wall. A complete loading-unloading sequence was simulated under conditions of near-constant equilibrium, approximating the case of infinitely slow tip motion. In the absence of the solid wall, the stylus film existed in a fluid state with structural and dynamic properties similar to those of the analogous planar SAM at an elevated temperature. When the wall was brought into contact with the stylus and pressed against it, a series of reversible changes occurred culminating with solidification of the SAM film at the largest compressive force. During loading, the chemical composition of the contact changed, as much of the film's interior was exposed to the wall. At all tip heights, the distribution of forces within the contact zone was uneven and subject to large local fluctuations. Analysis using the Johnson-Kendall-Roberts, Derjaguin-Muller-Toporov, and Hertz contacts mechanics models revealed significant deviations from the simulation results, with the JKR model providing best overall agreement. Some of the discrepancies found would be overlooked in an actual experiment, where, unlike the simulations, contact area is not separately known, possibly producing a misleading or incorrect interpretation of experimental results. These shortcomings may be improved upon by using a model that correctly accounts for the finite thickness of the compliant components and nonlinear elastic effects.     

Exploratory Investigations Probing a Preparatively Versatile, Pyridinium Salt Photoelectrocyclization-Solvolytic Aziridine Ring Opening Sequence

A novel pyridinium salt photoelectrocyclization-nucleophilic bicyclic aziridine ring opening reaction sequence has been investigated in order to determine its preparative potential. N-Alkylpyridinium perchlorates were found to undergo photoinduced electrocyclization upon irradiation in nucleophilic solvents, such as H(2)O and MeOH, to efficiently produce 6-alkyl-6-azabicyclo[3.1.0]hex-2-en-4-yl alcohols and ethers. The bicyclic aziridine photoproducts react with a number of different nucleophiles (e.g., H(2)O, MeOH, AcOH, AcSH) under acid-catalyzed conditions to produce 5-(nucleophile-substituted)-4-(alkylamino)cyclopenten-3-yl alcohols and ethers. The aziridine ring opening processes are both regioselective and stereoselective, yielding trans,trans-trisubstituted cyclopentenes exclusively, apparently as a consequence of the operation of an SN(2) mechanism. The effects of C-alkyl substitution on the regiochemistry of the pyridinium cation photocyclization reaction were briefly probed, and a method was developed to produce trans,cis-trisubstituted cyclopentenes by use of this tandem preparative sequence.     

Novel synthesis of sterically hindered N-substituted lactams from imides

An efficient and practical synthesis of sterically hindered N-substituted lactams has been developed starting from simple starting materials. The stereochemistry of the synthetically useful N,N acetal intermediate has been established.     

Heat capacities of binary cycloalkane mixtures at 298.15 K

Volumetric heat capacities of the six binary mixtures formed from cyclopentane, cyclohexane, cycloheptane and cyclooctane were determined at 298.15 K in a Picker flow microcalorimeter. Excess heat capacities obtained from the results are compred with the temperature variation of excess enthalpies from the literature.     

A one-pot multicomponent coupling reaction for the stereocontrolled synthesis of (Z)-trisubstituted allylic alcohols

In this Communication, we outline a new one-pot, multicomponent coupling reaction that allows easy access to (Z)-trisubstituted allylic alcohols. Our strategy is based on E to Z isomerization of the 1-bromo-1-dialkylvinylborane upon reaction with dialkylzinc reagents, and subsequent transmetalation to give (Z)-trisubstituted vinylzinc species. In situ trapping of the reactive vinylzinc intermediates with aldehydes furnished a series of (Z)-trisubstituted allylic alcohols. This method represents a viable alternative to the Still-Gennari modification of the HWE olefination reaction, and it has the advantage that it allows coupling of larger fragments.