二维正方各向异性碲圆柱光子晶体完全禁带中缺陷模的FDTD计算分析和设计

用FDTD方法计算了二维正方晶胞各向异性碲圆柱光子晶体的点缺陷模.为了得到TE,TM模式在完全禁带中具有相同共振频率的缺陷模,对中心点缺陷半径Rd以及中心附近对称位置的点缺陷半径Rn做了一系列微调.计算表明,TM模对于Rn的变化不敏感,而TE模随着Rn的改变出现了明显的规则的移动趋势.通过计算分析,发现对应于f=0.4的背景(R=0.3568a),当Rd=0.55a,Rn=0.26a时在完全禁带中TE和TM的缺陷模具有相同的共振频率ω0=0.2466ωe(其中ωe=2πca,a为晶格常数) 关键词： 时域有限差分法 光子晶体 缺陷模 各向异性     

Growth of NaBi（WO4）2 Dendrite and Mechanism

The solid-liquid interface motion of NaBi（WO4）2 （NBWO） melt crystal growth is observed in an in situ system, in which the whole processes of interface transition from fiat interface and cellular to dendrite are visualized. The spacing of the dendrite under smaller temperature gradient turns out to be larger than that under larger temperature gradient, which is found to be sensitive to the temperature distribution. The mechanism of dendrite growth of NBWO is studied based on the model of the growth units of anion coordination polyhedra. The { 001} face has two apex links, so it shows higher stability and has high growth rate and forms the arm of dendrite, whereas the {010} face has only one apex link, and thus shows relative slower growth rate and firstly forms the branches.     

Microstructure of laser melted Al18B4O33w/2024Al composite

The microstructure of a laser treated Al₁₈B₄O₃₃w/2024Al composite has been investigated using transmission electron microscope (TEM), low-angle (glancing angle) X-ray diffraction (XRD) techniques. Various surface microstructures were observed in the laser treated composite. The Al₁₈B₄O₃₃ whisker on the surface of the composite was decomposed during laser surface melting, various decomposition products were studied in the laser treated composite. Eutectic phases and the precipitation in the matrix of the composite with laser-treated were observed. The main phases detected in the molten zone were aluminum and decomposition products Al₂O₃. The effect of laser treatment on the hardness of the composite was also examined. A surface hardness of 400 Hv was noted.     

轻型汽车后桥半轴断裂件的组织及断口特征

采用光学显微镜和扫描电子显微镜等手段，对某轻型汽车40Cr后桥半轴断裂件的组织及断口特征进行了分析结果表明：半轴在调质处理时的淬火温度不够高，使其表层和心部组织中存在较多的铁素体相，造成了工件最终的硬度和疲劳强度不足，导致半轴在使用中发生扭转疲劳断裂．     

基于Internet/Intranet的大学物理实验系统

利用计算机技术、传感技术和校园网，将现代教育技术引入大学普通物理实验教学中，实现实验数据的自动采集，基于网络的实验预习和实验报告写作、递交、批改及管理等功能．     

Study on deactivation and regeneration of Pd/Al2O3 catalyst in hydrogen peroxide production by the anthraquinone process

Deactivated palladium catalysts in the hydrogenation of anthraquinione were regenerated with ethanol, nitric acid, hydrogen peroxide, boiling water and steam, respectively. The deactivated and regenerated catalysts were characterized by XPS, ICP, TG, FTIR, TPD, XRD, etc., and studied in the hydrogenation of anthraquinone. The results showed that the main cause of catalyst deactivation is the coverage of the active component by deposits. The treatments by hydrogen peroxide and boiling water can effectively regenerate the deactivated catalysts. This revised version was published online in August 2006 with corrections to the Cover Date.     

用改进嵌入原子法计算Cu晶体的表面能

用改进嵌入原子法(MEAM)计算了Cu晶体12个晶面的表面能.结果表明，密排面(111)的表面能最小.其他晶面的表面能随其晶面与(111)晶面夹角的增加而增加，据此可以粗略地估计各晶面表面能的相对大小.给出的几何结构因子的确定方法及结果可以直接用于计算其他面心立方晶体的表面能及其他特性.在Cu,Ag等面心立方薄膜中出现(111)择优取向或织构的机理是表面能的最小化. 关键词： 改进嵌入原子法 铜 表面能 计算     

某些类氖离子和类镍离子等离子体状态对应关系的研究

利用一维拉格朗日流体动力学程序Med103详细研究了产生类镍Ag,Cd,In,Sn, Sb离子和类氖Fe,Co,Ni,Cu,Zn离子的等离子体状态.通过对电子温度、离子丰度、离子数密度等状态参量的分析比较，得到了这两类等离子体状态之间的对应关系.即类镍银的等离子体状态与类氖铁 的相近，类镍镉的与类氖钴的相近，依次类推.利用这一对应关系可以方便地由类氖机理x射线激光的等离子体状态来对相应元素的类镍x射线激光的等离子体状态进行判断. 关键词： 类氖 类镍 等离子体状态 x射线激光     

吡罗红为底物的辣根过氧化物酶催化荧光反应测定葡萄糖

吡罗红在辣根过氧化物酶催化下可被过氧化氢氧化而使其荧光猝灭。在pH 7.2中性介质中,稳态催化速率由酶和底物浓度决定,催化体系服从Michaelis-Menten方程,用Lineweaver-Burk作图法求得米氏常数、最大反应速度、催化常数分别为2.4×10~(-5)mol·L-1,2.5×10~(-6)mol·L-1s-1,75.8 s-1。在最佳反应条件下,荧光F0/F的猝灭程度与过氧化氢浓度在0-3.6×10~(-7)mol·L-1范围内成线性关系,检测限为6.3×10~(-9)mol·L-1;当与葡萄糖氧化酶联用时,可定量检测葡萄糖,线性关系为0-8.0×10~(-7)mol·L-1,检测限为3.4×10~(-8)mol·L-1。方法用于分析人血清中葡萄糖含量,分析结果与苯酚-4-氨基安替比林法基本一致。     

雷达仿真系统中电磁干扰环境的仿真设计和实施

雷达仿真系统是为检测雷达设备的抗干扰能力以及在各种电磁环境下的工作性能而设计的，包括有源干扰和无源干扰的模拟仿真。本文阐述了无源干扰即杂波的散射模型和仿真过程；从同步脉冲干扰的基本原理出发，阐明在雷达工作环境仿真系统中距离拖引、速度拖引、虚假目标等同步脉冲有源干扰的设计和实施过程；并针对工作在搜索和跟踪交替模式下的相控阵雷达提出自适应综合干扰方式；最后分析并总结了系统仿真时为真实、有效地模拟电磁干扰环境应注意的关键问题。