Phase-Error Measurement and Compensation in PLL Frequency Synthesizers for FMCW Sensors—I: Context and Application

The synthesis of linear frequency sweeps or chirps is required, among others, in frequency-modulated continuous-wave radar systems for object position estimation. Low phase and frequency errors in sweeps with high bandwidth are a prerequisite for good accuracy and resolution, but, in certain applications where high measurement rates are desired, the additional demand for short sweep cycles has to be met. Transient phenomena in dynamic synthesizers as well as nonlinear system behavior usually cause unknown phase errors in the system output. For the class of phase-locked-loop (PLL)-based frequency synthesizers, a novel output phase-measurement method and dedicated circuitry are proposed that allow significant reduction of phase errors by adaptive input predistortion. The measurement procedure is implemented within the PLL control circuitry and does not require external equipment. The application of this method to PLL system identification and linearization of extremely short frequency sweeps is shown     

Impact of Preferential P-Diffusion Along the Grain Boundaries on Fine-Grained Polysilicon Solar Cells

Thin-film polysilicon solar cells are a promising low-cost alternative for bulk silicon solar cells due to their reduced material thickness. Recently, we showed that the use of an amorphous silicon/polycrystalline silicon heterojunction emitter instead of a diffused homojunction emitter led to a boost in the open-circuit voltage by 90 mV. Now, we present a full evidence that shows that this improvement is related to the absence of dopant smearing along the grain boundaries. By using scanning spreading resistance microscopy, we found an enlargement of the junction area by a factor of five in case of a homojunction. The tips of the dopant spikes represent lowly doped areas with an enhanced recombination.     

Spectrum of an electron in a quantum well in high inclined magnetic field and high transverse electric field

The energy and wave functions of localized electron states in a quantum well in a high magnetic field arbitrarily oriented with respect to the layers of the structure, and a high transverse electric field are studied. The situation where the quantum-confined energy and the Landau energy are close to each other is considered. The evolution of the spectrum with varying orientation of the magnetic field over the entire angle range is studied.     

Detecting anomaly and failure in Web applications

Improving Web application quality will require automated evaluation tools. Many such tools are already available either as commercial products or research prototypes. The authors use their automated evaluation tools, ReWeb and TestWeb, for Web analysis and testing that improves Web pages and applications and to find some anomalies and failures in four case studies.     

X-ray fluorescence determination of bromine in halogenated organic compounds using quasisolid emitters

A series of quasi-solid emitters is proposed for the X-ray fluorescence determination of bromine in different bromine-containing compounds. It is shown that sucrose-based glasses are the best emitters for analyzing alkali solutions of halogenated organic compounds, saccharose-based glasses and polymer films are best for analyzing powder samples, and organic gels offer most promise for analyzing liquid (at normal conditions) samples. It is noted that the proposed method can expand the possibilities of commercially produced element analyzers, which are currently intended for determining only C, H, O, N, and S in organic compounds and cannot be used for determining halogens.     

Empirical analysis of a 2 x 2 MIMO channel in outdoor-indoor scenarios for BFWA applications

The unquestionable advantages of multiple-input multiple-output (MIMO) systems are having a strong influence on the development of new wireless systems, both in wireless local-area networks (WLANs), and in those designed to offer broadband fixed wireless access (BFWA) services in wireless metropolitan-area networks (WMANs). The MIMO channel characterization in different environments and for different operating frequency bands is a crucial factor in the design of new systems and standards, and for adequate planning of existing systems. This article makes two main contributions. First, the experimental characterization of a 2 times 2 MIMO channel at a frequency of 2.4 GHz in a canonical outdoor-indoor scenario is presented. The channel characterization performed includes the analysis of the spatial correlation between the MIMO system subchannels and its impact on the channel capacity. Second, on the basis of the capacity results obtained, a proposal is made for the use of a 2 times 2 MIMO system in outdoor-indoor scenarios for BFWA applications in metropolitan environments. The proposal is based on the experimentally verified hypothesis that the path loss due to building penetration can be practically compensated for by the diversity gain of 2 times 2 systems     

Orientation and relaxation of polymer–clay solutions studied by rheology and small-angle neutron scattering

The influence of shear on viscoelastic solutions of poly(ethylene oxide) (PEO) and clay [montmorillonite, i.e., Cloisite NA+ (CNA)] was investigated with rheology and small-angle neutron scattering (SANS). The steady-state viscosity and SANS were used to measure the shear-induced orientation and relaxation of the polymer and clay platelets. Anisotropic scattering patterns developed at much lower shear rates than in pure clay solutions. The scattering anisotropy saturated at low shear rates, and the CNA clay platelets aligned with the flow, with the surface normal parallel to the gradient direction. The cessation of shear led to partial and slow randomization of the CNA platelets, whereas extremely fast relaxation was observed for laponite (LRD) platelets. These PEO–CNA networklike solutions were compared with previously reported PEO–LRD networks, and the differences and similarities, with respect to the shear orientation, relaxation, and polymer–clay interactions, were examined. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 3102–3112, 2004     

Laser lineshape effects on cavity-enhanced absorption spectroscopy signals

The quantitative effects of laser lineshape on signals from cavity-enhanced absorption spectroscopy (CEAS) and integrated cavity output spectroscopy (ICOS) experiments are examined. The governing equations for CEAS signals including the laser lineshape are derived. Approximations under which the laser lineshape may be neglected or replaced with an effective lineshape are presented. It is shown that the laser lineshape effects may be parameterized with two dimensionless variables: the laser linewidth normalized by the absorption linewidth, and the peak sample absorbance normalized by the mirror loss. In terms of the dimensionless variables, we simulate CEAS and ICOS signals and the absorbances inferred from them. The simulation results provide a useful tool for CEAS and ICOS practitioners to gauge the importance of laser lineshape effects in specific experiments. Simulations are performed for the four combinations of Gaussian and Lorentzian lineshapes for the laser and the absorption. PACS 42.62.Fi; 78.40.-q; 32.70.Jz     

Characterisation of adsorbed layers on sulphide minerals by photoelectron spectroscopy

The systems galena/2-mercaptobenzothiazole (MBT) and pyrite/MBT have been studied using synchrotron radiation excited photoelectron spectroscopy (SRXPS). The chemisorption of MBT and the multilayer formation of 2,2′-dithiobis(benzothiazole) (BBTD) are evidenced by additional structures, observed beside the substrate signals, in the S2p-spectra of cleaved mineral surfaces after adsorption of MBT. The amount of the complex remains constant at concentrations as high as 10^–5 mol/L whereas the amount of BBTD increases. From the dependence of the adsorbate intensities on the excitation energy the conclusion can be drawn that an overlayer of BBTD on a chemisorbed layer of MBT is formed. The very weak adsorption of MBT on pyrite in alkaline solutions may explain the selective flotation of galena from pyrite in alkaline media.     

Arsenic deactivation enhanced diffusion and the reverseshort-channel effect

The effect of enhanced diffusion caused by the electrical deactivation of arsenic on the reverse short-channel effect (RSCE) in NMOS devices is investigated. A simple four-mask process was utilized to fabricate deep sub-micron NMOS devices. Source/drain (S/D) implant and anneal conditions were varied in order to determine their implications on the RSCE. Results indicate that when high concentrations of arsenic deactivate, enhanced diffusion occurs, leading to significantly more RSCE. This implies that the dose of the arsenic implant and the subsequent anneals should be carefully considered in source/drain engineering