Diurnal and spatial variation of xylem dielectric constant in Norway Spruce (Picea abies [L.] Karst.) as related to microclimate, xylem sap flow, and xylem chemistry

Spatial and temporal variations in vegetation dielectric properties strongly influence the microwave backscatter characteristics of forested landscapes. This paper examines the relationship between xylem tissue dielectric constant, xylem sap flux density, and xylem sap chemical composition as measured in the stems of two Norway Spruce (Picea abies [L.] Karst.) trees in the Fichtelgebirge region of Northern Bavaria, Germany. Dielectric constant and xylem sap flux were monitored continuously from June through October 1995, at several heights along the tree trunks. At the end of the measurement series, each tree was harvested, and its xylem sap extracted and analyzed to determine the concentrations of amino acids and cations. Results show that the sap flux density was correlated with vapor pressure deficit (VPD) at all heights in the stem. In contrast, the xylem tissue dielectric constant is influenced by VPD but can exhibit a significant temporal lag relative to changes in VPD. This lag varies with position along the tree trunk. The temporal variability of the dielectric constant is compared with both trees at several positions along the tree trunks. Results of xylem sap chemical analysis are presented. We show that spatial and temporal variability in the xylem tissue dielectric constant is influenced not only by water content, but by variations in xylem sap chemistry as well. This has important implications for microwave remote sensing of forested landscapes, as useful information may be acquired regarding stand physiology and water relations and where variations in dielectric properties within individual trees and across geographic areas can be significant error sources for forest inventory mapping.     

Effect of phonon scattering from neutral and charged impurity centers on the lattice heat conductivity of PbTe:(Tl, Na)

Experimental data on the effect of thallium and sodium impurities on the lattice heat conductivity of PbTe at room temperature are reported. Because the lattice of lead chalcogenides is strongly polarized near charged impurities, the effect of impurities on the lattice heat conductivity depends substantially on their charge state. This property of the material has been used to determine the charge state of the thallium impurity in PbTe. The results obtained argue for a model of quasi-local thallium-impurity states which assumes low electron-correlation energy at an impurity center. Fiz. Tverd. Tela (St. Petersburg) 40, 1206–1208 (July 1998)     

Ideal amplifier spacing for reduction of Gordon-Haus jitter indispersion-managed soliton communications

Based on a variational analysis, the authors demonstrate that the noise-induced Gordon-Haus timing jitter in a dispersion-managed soliton transmission system can be substantially reduced by appropriate placement of the amplifiers     

Elevated temperature performance of pseudomorphic AlGaAs/InGaAsMODFETs

Parametric DC measurements on pseudomorphic AlGaAs/InGaAs modulation-doped field-effect transistors (MODFETs) were carried out over the 300-405 K temperature range. A gradual channel device model was developed to simulate the temperature dependent behavior and assist in the interpretation of the characteristics. The simulations are shown to provide good predictive ability and confirm the physical reasons why the zero temperature coefficient point of a MODFET occurs only for gate bias voltages below the threshold voltage     

Laser spectroscopy of the 1s HFS of H-like ions at a bunched beam in the storage ring ESR

The investigation of the 1s HFS provides a good possibility for testing QED effects in a combination of a strong electric and magnetic field. Here, we report about the laserspectroscopic measurements of the ground state hyperfine splitting in ²⁰⁷Pb⁸¹⁺. To handle this M1-transition in the infrared optical regime with its long lifetime, we developed a new detection technique using a bunched ion beam. For the observation of fluorescence light, a new mirror system is adapted to the emission characteristics from an ion beam at relativistic velocities. This revised version was published online in July 2006 with corrections to the Cover Date.     

Mössbauer study of Martian regolith analogues

Terrestrial basalt rocks considered to be a good analogues of the Martian regolith were studied by using the Mössbauer spectroscopy and X-ray diffraction. The weathering of basalts was followed by the changes of the Fe²⁺/Fe³⁺ ratio. The basalt rock undergoes alteration from primary mineral composition (olivine+pyroxene+plagioclase) through smectite to kaolinite clay with oxides and hydroxides with the increase of the Fe²⁺/Fe³⁺ ratio.     

Impact of crosstalk in an arrayed-waveguide multiplexer onN×N optical interconnection

The impact of crosstalk in an arrayed-waveguide N×N wavelength multiplexer is investigated precisely in relation to its application to wavelength-routing N×N all optical networks. In such systems multiple crosstalk light which has the same wavelength as the signal results in signal-crosstalk beat noise. We confirm that the noise is Gaussian and obtain the relation between crosstalk and power penalty. It is shown that the crosstalk must be less than -38 dB for a 16×16 system to keep the power penalty below 1 dB at a bit error rate of 10^-9     

Multispectral data compression using bidirectional interbandprediction

The introduction of high spatial and spectral resolution sensors on-board remote-sensing spacecraft has increased, by orders of magnitude, the data rates which need to be sustained on the down-link or cross-link transmission channels. Since these channels are severely limited in capacity, the need arises to perform on-board compression to reduce the volume of data which would need to be down-linked. This paper discusses the development and refinement of a low complexity lossy spectral/spatial compression method which provides high compression ratios at low levels of distortion. The developed techniques uses pixels in adjacent bands to predict the intensity of pixels in the band being compressed via a simple linear prediction model. This prediction method when combined with a low-distortion discrete cosine transform (DCT) block coding method yields performance comparable to block-adaptive Karhunen-Loeve Transform (KLT)-DCT methods without incurring the complexity penalty of the KLT. The methods' performance suffers under misregistration. A fractional-pixel interpolation enhancement to the basic technique significantly improves the performance in the case of misregistered bands     

Estimation of linear parametric models of nonGaussian discreterandom fields with application to texture synthesis

A general (possibly asymmetric noncausal and/or nonminimum phase) 2D autoregressive moving average random field model driven by an independent and identically distributed 2D nonGaussian sequence is considered. The model is restricted to be invertible, i.e., system zeros are not allowed to lie on the unit bicircle. Three performance criteria are investigated for parameter estimation of the system parameters given only the output measurements (image pixels). The proposed criteria are functions of the higher order cumulant statistics of an inverse filter output. One of these criteria is novel and the others have been considered in past only for moving average inverses and without any analysis of their consistency. In the paper strong consistency of the proposed methods under the assumption that the system order is known is proved. The convergence of the proposed parameter estimators under overparametrization is also analyzed. Experimental results involving synthesized as well as real life textures are presented to illustrate the performance of two of the considered approaches. Experimental results of synthesis of 128x128 textures visually resembling several real life textures in the Brodatz album (and other sources) are presented.     

An analytic expression of fmax for HBTs

An analytic expression of f_max is derived based on a practical HBT circuit model where collector junction capacitance is split up into internal and external parts. It shows that for advanced HBTs, f_max is well characterized by the product of the base resistance and internal collector capacitance. In other words, the external collector capacitance has only a small impact on the determination of f_max. Good agreement between experimental results and numerical circuit simulation confirms the validity of the HBT circuit model. The influence of the external collector capacitance on maximum available gain is also described