Studies on the Performance and Structure of Supported Catalysts for the Partial Oxidation of Methane to Syngas

The catalytic properties of several supported metal catalysts on different carriers were studied in the partial oxidation of methane (POM) to syngas. In our experiment, supported noble metal catalysts exhibited better performance than the other supported transition metal catalysts. The catalyst performances were significantly influenced by the d-electron configuration of the active metal components and the dispersion of active metal components on the support. A catalyst with a moderate number of unpaired electrons in the d-orbital of the active metal support without obvious acidity or redox activity (e.g. MgO) was suitable for POM performance. The Rh/SiO2 catalyst was the best in the POM reaction, among those investigated. Reaction conditions apparently also affected the POM performance of the catalyst. The conversion of methane and the selectivity for CO increased with the reaction temperature, and a high CH4/O2 ratio was not beneficial for POM performance.     

新式夹心型光透薄层光谱电化学电解池

本文设计了一种新式夹心型光透薄层紫外-可见光谱电化学池。该池采用铂网工作电极,两侧平行放置铂片为对极置于同一石英窗口夹层中,同时以聚四氟乙烯隔离膜作为边际限制器,结合池内小孔道设置内参比点进行精确的电位控制,具有理想的光谱电化学响应。利用循环伏安、循环电位-吸收、恒电位现场光谱、双电位跃-计时电量、双电位跃-计时吸收等技术,对铁氰化钾在氯化钾溶液中的行为进行了表征。     

POROUS MEMBRANE TEMPLATED SYNTHESIS OF POLYMER PILLARED LAYER

The anodic porous alumina membranes with a definite pore diameter and aspect ratio were used as templates tosynthesize polymer pillared layer structures. The pillared polymer was produced in the template membrane pores, and thelayer on the template surfaces. Rigid cured epoxy resin, polystyrene and soft hydrogel were chosen to confirm themethodology. The pillars were in the form of either tubes or fibers, which were controlled by the alumina membrane pore surface wettability. The structural features were confirmed by scanning electron microscopy results.     

Synthesis and crystal structure of two novel nickel (imidazole) complexes having hydrogen-bonded networks

Two nickel (imidazole) complexes, Ni(im)₆Cl₂·4H₂O (1) and Ni(im)₆(NO₃)₂ (2) (im=imidazole) have been synthesized and characterized by elemental analysis, IR, UV, TG and single crystal X-ray diffraction. 1 crystallizes in the triclinic space group P-1 with a=8.800(6) Å, b=9.081(6) Å, c=10.565(7) Å, =75.058(9)°, β=83.143(8)°, γ=61.722(8)°, V=718.3(8) Å³, Z=1 and R₁ (wR₂)=0.0469 (0.1497). 2 crystallizes in the trigonal space group R-3 with a=12.370(6) Å, b=12.370(6) Å, c=14.782(14) Å, =90.00°, β=90.00°, γ=120.00°, V=1959(2) Å³, Z=3 and R₁ (wR₂)=0.0358 (0.0955). 1 and 2 exhibit different supramolecular network due to their different counter anions and different hydrogen bonding connection. In compound 1, [Ni(im)₆]²⁺ cation and counter anions Cl⁻ alternatively array in an ABAB fashion via N–HCl hydrogen bonding. In compound 2, the plane of each NO₃²⁻ is almost parallel and each NO₃²⁻ connect three different [Ni(im)₆]²⁺ cations via N–HO hydrogen bonding.     

Si/SiGe resonant interband tunnel diode with f/sub r0/ 20.2 GHz and peak current density 218 kA/cm/sup 2/ for K-band mixed-signal applications

This letter presents the room-temperature high-frequency operation of Si/SiGe-based resonant interband tunnel diodes that were fabricated by low-temperature molecular beam epitaxy. The resulting devices show a resistive cutoff frequency f/sub r0/ of 20.2 GHz with a peak current density of 218 kA/cm/sup 2/, a speed index of 35.9 mV/ps, and a peak-to-valley current ratio of 1.47. A specific contact resistivity of 5.3/spl times/10/sup -7/ /spl Omega//spl middot/cm/sup 2/ extracted from RF measurements was achieved by Ni silicidation through a P /spl delta/-doped quantum well by rapid thermal sintering at 430/spl deg/C for 30 s. The resulting devices are very good candidates for RF high-power mixed-signal applications. The device structures presented here are compatible with a standard complementary metal-oxide-semiconductor or heterojunction bipolar transistor process.     

平面型RTD及其MOBILE的设计与研制

鉴于已报道的平面共振遂穿二极管(PRTD)存在的缺点,文中提出了一种新的平面RTD器件结构.以n+ GaAs代替半绝缘GaAs衬底,利用硼离子注入产生的非晶化作为RTD器件的电隔离,成功设计研制平面型RTD和由其构成的单-双稳转换逻辑单元,此种结构可适用于以输出端作为公用端的所有电路.     

A Phosphorescent Platinum(II) Bipyridyl Supramolecular Polymer Based on Quadruple Hydrogen Bonds

A platinum(II) bipyridyl complex bearing bis‐ureidopyrimidinone (Pt‐bisUPy) has been designed and its self‐assembling behavior has been thoroughly investigated by ¹H NMR, DOSY NMR, Ubbelohde viscometry analysis, UV/Vis, and emission spectroscopies. Pt‐bisUPy underwent concentration‐dependent ring‐chain polymerization in apolar solvents. Hydrogen‐bonding interactions play an important role during the formation of the supramolecular polymers. Hydrogen‐bonded supramolecular polymers were transformed to nanoparticles in water through the miniemulsion method. These nanoparticles showed strong π–π excimeric emission. Metal‐metal‐to‐ligand charge transfer (MMLCT) from Pt–Pt interactions was not significant in the emission spectrum. The phosphorescence of the nanoparticle persisted even under aerobic conditions. The triplet state of these phosphorescent nanomaterials were long‐lived and possessed moderate emission quantum yields. Furthermore, the low toxicity of these materials promises a place for them in in vitro and in vivo bioimaging.