Radiation and scattering from ferrite-tuned cavity-backed slotantennas: theory and experiment

A three-dimensional finite-element method hybridized with the spectral/spatial domain method of moments is presented for the analysis of ferrite-tuned cavity-backed slot antennas. The cavity, which is partially filled with magnetized ferrite layers, is flush mounted on an infinite ground plane with possible dielectric or magnetic overlay. The antenna operates primarily in the ultrahigh-frequency band. The finite-element method is used to solve for the electric-field distribution inside the cavity, whereas the spectral-domain approach is used to solve for the exterior region. An asymptotic extraction of the exponential behavior of the Green's function followed by a spatial evaluation of the resulting integral is used to improve computational speed. Radar cross section, input impedance, return loss, gain, and efficiency of ferrite-tuned cavity-backed slots (CBS) are calculated for various biasing conditions. Numerical results are compared with experimental data     

Ultralow-voltage boron-doped diamond field emitter vacuum diode

A boron-doped diamond field emitter diode with ultralow turn-on voltage and high emission current is reported. The diamond field emitter diode structure with a built-in cap was fabricated using molds and electrostatic bonding techniques. The emission current versus anode voltage of the capped diamond emitter diode with boron doping, sp² content, and vacuum thermal electric (VTE) treatment shows a very low turn-on voltage of 2 V. A high emission current of 1 μA at an anode voltage of less than 10 V can be obtained from a single diamond tip. The turn-on voltage is significantly lower than comparable silicon field emitters     

Small-signal modeling and control of the quasi-square-wave boostconverter

Sampled-data techniques are used to examine the dynamic characteristics and closed-loop performance of the quasi-square-wave boost converter. Direct duty-ratio control and current-mode control are considered. With direct duty-ratio control, the system poles remain well damped under all load conditions, and there is no zero in the control-to-output transfer function. Good closed-loop performance is therefore achieved. Under current-mode control, the requirement for a stabilizing ramp is seen to depend on load conditions, and the achievable voltage control-loop bandwidth is smaller than that using direct duty-ratio control; however, there is a significant reduction in the magnitude of the DC source to output-voltage frequency response     

Thickness and temperature dependence of subsidiary absorption thresholds in yttrium-iron-garnet thin films

The microwave subsidiary absorption threshold in tangentially magnetized yttrium-iron-garnet (YIG) films was measured as a function of the static magnetic field, film thickness and decrease in the 0.3–3 μm range is observed. The effect is explained quantitatively by using modified Damon-Eshbach dispersion relations which take into account exchange interactions.

The effect of temperature on h_crit, the smallest threshold field amplitude, in the 250<T< 450 K temperature range can be expressed by an empirical relationship h_crit M_s(T)^-1.6 where M_s is the saturation magnetization. This h_crit vs M_s relationship is similar to that obtained for the magnetization dependence of parallel pump thresholds in Li-Ti ferrite compounds.     

Performance of the PAC optical packet network

For multiuser packet communications with unpredictable user demands (e.g., in a local or metropolitan area network), coordination and control of access to the frequency-division multiplexing (FDM) channels are difficult. B. Glance (J. Lightwave Technol., vol.10, pp.1323-1328, Sep 1992) proposed using a simple protection-against-collision (PAC) circuit to solve this media access problem and achieve full optical connectivity. The PAC system has the potential to interconnect hundreds of ports, each transmitting at several gigabits per second. Performance aspects of the PAC optical packet network are discussed here. The delay-throughout performance of this network is analyzed for uniform traffic patterns. The results show that in geographically distributed applications the maximum achievable throughput (normalized to the transmission rate) is typically between 0.4 and 0.5 per channel. In a centralized switch the (normalized) maximum achievable throughput can approach 0.8 per channel     

Computation of confined coflow jets with three turbulence models

A numerical study of confined jets in a cylindrical duct is carried out to examine the performance of two recently proposed turbulence models: an RNG-based K-? model and a realizable Reynolds stress algebraic equation model. The former is of the same form as the standard K-? model but has different model coefficients. The latter uses an explicit quadratic stress-strain relationship to model the turbulent stresses and is capable of ensuring the positivity of each turbulent normal stress. The flow considered involves recirculation with unfixed separation and reatachment points and severe adverse pressure gradients, thereby providing a valuable test of the predictive capability of the models for complex flows. Calculations are performed with a finite volume procedure. Numerical credibility of the solutions is ensured by using second-order-accurate differencing schemes and sufficiently fine grids. Calculations with the standard K-? model are also made for comparison. Detailed comparisons with experiments show that the realizable Reynolds stress algebraic equation model consistently works better than does the standard K-? model in capturing the essential flow features, while the RNG-based K-? model does not seem to give improvements over the standard K-? model under the flow conditions considered.     

An adaptive plasma glucose controller based on a nonlinearinsulin/glucose model

The design of plasma glucose controllers traditionally relies on linear approaches. The implementation of an appropriate nonlinear model of the insulin/glucose regulatory system into an adaptive controller should predict the insulin-dependent glucose removal more reliably and hence provide better control over a wide spectrum of insulin signals. A discretized form of the model leads to a two-step procedure. First, the measured plasma glucose levels associated with the erogeneous glucose infusion rates are used in the estimation of the past removal rates which, in turn, can be expressed as a weighted sum of past insulin inputs and previous values of the removal rate. Parameters of the sum are adjusted on-line by a recursive method of estimation which features a prefiltering of data to account for a corrupting coloured process noise. The same equation is in turn used to predict the time course of the insulin-dependent fractional rate of glucose removal. The performance of the controller. Tested in vivo in three pigs, is presented for various intravenous or subcutaneous rapid injections and staircase infusions of insulin. Plasma glucose is maintained at an average level of 99.9±8.7% of the target value (% set point±coefficient of variation). The controller reacts promptly to large and rapid variations in insulin action. Although control improves with the number of glucose measurements, the prediction of glucose removal allows for some flexibility in the monitoring of the plasma glucose. Sampling frequency varied from a 2 min interval during transient periods to 7 min as steady states were reached     

Wideband chirp measurement technique for high bit rate sources

A Mach Zehnder (MZ) interferometer has been used as an optical discriminator to measure the time-resolved frequency chirp of an optical source     

Mathematical analysis of dynamic channel selection in indoor mobilewireless communication systems

Dynamic channel selection (DCS) is an algorithm for flexible resource sharing in mobile radio systems. The digital enhanced cordless telecommunications (DECT) standard implements a version of DCS based on time as well as frequency multiplexing. In this paper, mathematical models are developed to evaluate the probabilities of channel availability, desired carrier power, and the carrier-to-interference ratio (CIR) for a constant traffic load. These results can be used to compute the call setup blocking probability. The models reported in this study are based on a decentralized DCS according to the DECT standard specifications. The results show that blocking due to availability of a channel (resource blocking), not interference blocking, generally is the most important factor in overall call blocking. Furthermore, it is seen that resource blocking is sensitive to the implementation of portable sets. Also, with homogeneous static traffic, this type of DCS ran be as good as fixed channel allocation (FCA) with respect to resource blocking