Remediation of <Superscript>137</Superscript>Cs radionuclide in nuclear waste effluents by polymer composite: adsorption kinetics,isotherms and gamma irradiation studies

Polypyrrole is incorporated with activated carbon in large size dopant solution and investigated for ¹³⁷Cs removal studies. Adsorption experiments showed optimum conditions within 240 min contact time, pH 6, 0.2 g adsorbent and?≤?100 mg/l adsorbate dose, respectively, while the kinetic data followed pseudo-first-order model. Isotherm data were reproducible by the Langmuir isotherm yielding 23 mg/g maximum sorption capacity. Regeneration of adsorbent was attempted and indicated promising results within three cycles. The surface behavior has also been examined and revealed a well-ordered structure under gamma irradiation. This is a cheap adsorbent to consider and has also proven to possess higher sorption capacity than most highly-cost inorganic materials in use.     

Simultaneous multiresidue determination of 48 pesticides in Yeongsan and Sumjin River water using GC-NPD and confirmation via GC-MS

In a continuation of our earlier work, a multiresidual analytical method using 48 frequently used neutral pesticides in a water matrix was developed and validated in this study. The samples were extracted with dichloromethane and the pesticides were analyzed via GC-NPD followed by confirmation with GC-MS. Good linearity was detected over a concentration range of 0.01-1.0 microg/mL with correlation coefficients (r(2) ) in excess of 0.982. The recoveries were measured between 70.7 and 111.4% for the majority of the targeted pesticides with relative standard deviations (RSDs) of less than 20%. The LODs and LOQs were in ranges of 0.1-2 and 0.33-6.6 microg/L, respectively. A total of 66 water samples were collected from different locations in Yeongsan and the Sumjin River, Republic of Korea, and were analyzed in accordance with the developed method. None of the water samples were determined to contain any of the targeted pesticides. The method has been shown to be simpler, faster, and more cost-effective than the method established by the Environmental Protection Agency (EPA).     

One-step SFE-plus-C(18) selective extraction of low-polarity compounds,with lipid removal,from smoked fish and bovine milk

Co-extraction of lipid materials is the major source of interference in determinations of low-polarity compounds in many biological matrixes. "SFE-plus-C(18)", a recently developed supercritical fluid extraction method employing C(18) adsorbent in the extraction chamber, can enable selective extraction of low-polarity compounds in lipid-rich biological matrixes without a cleanup step. This study reports the application of the SFE-plus-C(18) method to the quantification of: 1. polycyclic aromatic hydrocarbons (PAH) in commercially purchased smoked fish; and 2. anti-cancer agents cyclophosphamide (CP) and suberoylanilide hydroxamic acid (SAHA) spiked into homogenized whole bovine milk.Over the course of SFE-plus-C(18)extraction, indigenous lipids are preferentially retained on the C(18) adsorbent. Compared with the conventional method, only 8-15% of the lipids in the smoked fish sample, and only 6-18% of the lipids in the milk sample, were co-extracted by SFE-plus-C(18). This reduction in the quantity of background lipids significantly improved chromatographic separations, retarded deterioration of the column, and dramatically improved the ability to quantify PAH present at trace levels in smoked fish by GC-MS. Using the SFE-plus-C(18) method, ten targeted PAH were detected in the range 9.5-13.5 ng g(-1) in the smoked fish sample. Compared with these levels, PAH extractions by use of conventional SFE gave values that were lower by 38-86%. Recoveries of CP and SAHA spiked into milk were close to 100% in both SFE-plus-C(18)and conventional SFE, where the lipid background during the chromatographic elution of CP and SAHA was not so severe.     

Structural Bases for Hesperetin Derivatives: Inhibition of Protein Tyrosine Phosphatase 1B,Kinetics Mechanism and Molecular Docking Study

In the present study, we investigated the structure-activity relationship of naturally occurring hesperetin derivatives, as well as the effects of their glycosylation on the inhibition of diabetes-related enzyme systems, protein tyrosine phosphatase 1B (PTP1B) and α-glycosidase. Among the tested hesperetin derivatives, hesperetin 5-O-glucoside, a single-glucose-containing flavanone glycoside, significantly inhibited PTP1B with an IC₅₀ value of 37.14 ± 0.07 µM. Hesperetin, which lacks a sugar molecule, was the weakest inhibitor compared to the reference compound, ursolic acid (IC₅₀ = 9.65 ± 0.01 µM). The most active flavanone hesperetin 5-O-glucoside suggested that the position of a sugar moiety at the C-5-position influences the PTP1B inhibition. It was observed that the ability to inhibit PTP1B is dependent on the nature, position, and number of sugar moieties in the flavonoid structure, as well as conjugation. In the kinetic study of PTP1B enzyme inhibition, hesperetin 5-O-glucoside led to mixed-type inhibition. Molecular docking studies revealed that hesperetin 5-O-glucoside had a higher binding affinity with key amino residues, suggesting that this molecule best fits the PTP1B allosteric site cavity. The data reported here support hesperetin 5-O-glucoside as a hit for the design of more potent and selective inhibitors against PTP1B in the search for a new anti-diabetic treatment.     

Fatty amides synthesized from vegetable oil as extractant of molybdenum(VI)

In this study, fatty amides (FAs) synthesized from palm olein were used to extract and separate Mo(VI) from acidic media. Effects of various parameters upon the separation of Mo(VI) from Co(II), Ni(II), Al(III) and Mn(II), including extractant concentration, metal ion concentration, contact time, diluent, and acidity, were investigated. It was found that Mo(VI) was successfully separated from the above commonly associated metal ions by stripping from the loaded organic phase. Different acidic and alkaline solutions were used. Ammonium hydroxide solution was an optimal. Extraction of Mo(VI) into the organic phase involved the formation of 1:3 complexes. This work presents the development of a low-cost and environmentally friendly extractant to recycle and recover molybdenum.     

Effect of ethylene-co-vinyl acetate-glycidylmethacrylate and cellulose microfibers on the thermal,rheological and biodegradation properties of poly(lactic acid) based systems

The properties and biodegradation behavior of blends of poly(lactic acid) (PLA) and ethylene-vinyl acetate-glycidylmethacrylate copolymer (EVA-GMA), and their composites with cellulose microfibers (CF) were investigated. The blends and composites were obtained by melt mixing and the morphology, phase behavior, thermal and rheological properties of PLA/EVA-GMA blends and PLA/EVA-GMA/CF composite films were investigated as a function of the composition. The disintegrability in composting conditions was examined by means of morphological, thermal and chemical analyses to gain insights into the post-use degradation processes. The results indicated a good compatibility of the two polymers in the blends with copolymer content up to 30 wt.%, while at higher EVA-GMA content a phase separation was observed. In the composites, the presence of EVA-GMA contributes to improve the interfacial adhesion between cellulose fibers and PLA, due to interactions of the epoxy groups of GMA with hydroxyls of CF. The addition of cellulose microfibers in PLA/EVA-GMA system modifies the rheological behavior, since complex viscosity increased in presence of fibers and decreased with an increase in frequency. Disintegration tests showed that the addition of EVA-GMA influence the PLA disintegration process, and after 21 days in composting conditions, blends and composites showed faster degradation rate in comparison with neat PLA due to the different morphologies induced by the presence of EVA-GMA and CF phases able to allow a faster water diffusion and an efficient PLA degradation process.     

Molecularly imprinted polyaniline-polyvinyl sulphonic acid composite based sensor for para-nitrophenol detection

We report results of the studies relating to the fabrication and characterization of a conducting polymer based molecularly imprinted para-nitrophenol (PNP) sensor. A water pollutant, para-nitrophenol is electrochemically imprinted with polyvinyl sulphonic acid (PVSA) doped polyaniline onto indium tin oxide (ITO) glass substrate. This PNP imprinted electrode (PNPI-PANI-PVSA/ITO) prepared via chronopotentiometric polymerization and over-oxidation is characterized by Fourier transform infra-red spectroscopy (FT-IR), UV–visible (UV–vis) spectroscopy, contact angle (CA), scanning electron microscopy (SEM), cyclic voltammetry (CV) and differential pulse voltammetry (DPV) studies. The response studies of PNPI-PANI-PVSA/ITO electrode carried out using DPV reveal a lower detection limit of 1 × 10⁻³ mM, improved sensitivity as 1.5 × 10⁻³ A mM⁻¹ and stability of 45 days. The PNPI-PANI-PVSA/ITO electrode shows good precision with relative standard deviation of 2.1% and good reproducibility with standard deviation of 3.78%.     

Water Structure Modification by Sugars and Its Consequence on Micellization Behavior of Cetyltrimethylammonium Bromide in Aqueous Solution

Water structure modification by sugars with a wide difference in stereoregular structures ranging from monosaccharide to trisaccharide and its consequence on the micellization behavior of cetyltrimethylammonium bromide (CTAB) in aqueous medium have been investigated. The characteristic variation in water absorption peaks in the presence of d(?)fructose has been studied by near-infrared spectroscopy. The analyses show that the hydrogen bonding capability of d(+)glucose, d(?)fructose, sucrose, trehalose and raffinose is mainly responsible for the variation in water-additive interactions. The critical micelle concentration determined by specific conductivity measurement and aggregation number determined by steady state fluorescence quenching method show significant variations in presence of additives for CTAB in aqueous solution. The sugars interact with the water structure to varying extents owing to differences in hydrogen bonding capability depending on the stereoregularity of the structure. This induces differences in the microenvironment for competition between the hydrophobic interaction and degree of hydration of the hydrophilic group of the surfactant to ultimately influence the micellization behavior in aqueous solution.     

Module-based assembly of copper(II) chloranilate compounds: syntheses, crystal structures, and magnetic properties of [[Cu(2)(CA)(terpy)(2)][Cu(CA)(2)]](n)() and [[Cu(2)(CA)(terpy)(2)(dmso)(2)][Cu(CA)(2)(dmso)(2)](EtOH)](n)(H(2)CA = chloranilic acid, terpy = 2,2':6',2' '-terpyridine, dmso = dimethyl sulfoxide)

Two new copper(II) compounds of chloranilate and 2,2':6',2' '-terpyridine have been synthesized, and the structures have been solved by the single-crystal X-ray diffraction method. The crystal structure of [[Cu(2)(CA)(terpy)(2)][Cu(CA)(2)]](n)(1), where H(2)CA = chloranilic acid and terpy = 2,2':6',2' '-terpyridine, consists of two modules, the dimer unit [Cu(2)(CA)(terpy)(2)](2+) and the anionic mononuclear unit [Cu(CA)(2)](2)(-), forming an alternated chain. The chain is stabilized by semicoordinating and additional but efficient secondary bonding interactions. The crystal structure of [[Cu(2)(CA)(terpy)(2)(dmso)(2)][Cu(CA)(2)(dmso)(2)](EtOH)](n)(2), where dmso = dimethyl sulfoxide, consists of solvent molecules and two discrete modules, the dimer unit [Cu(2)(CA)(terpy)(2)(dmso)(2)](2+) and the anionic mononuclear unit [Cu(CA)(2)(dmso)(2)](2)(-). The dimer units form a layer by secondary bonding interactions, and the monomer units and ethanol molecules are introduced between the layers. The magnetic properties of 1 and 2 have been investigated in the temperature range 2.0-300 K. A weak ferromagnetic interaction was observed in 1, J(a) = 2.36 cm(-)(1) and zJ(b) = -0.68 cm(-)(1) while no exchange coupling was observed in 2.     

Biologically active metabolites from fungi, 19: new isocoumarins and highly substituted benzoic acids from the endophytic fungus, Scytalidium sp

Six known metabolites, two new isocoumarins 4 and 8, and one new highly substituted benzoic acid derivative 9 were isolated from the ethyl acetate culture extract of a fungal endophyte, Scytalidium sp. In addition, another new benzoic acid 10 with an unusual 1,2-dicarbonyl side chain was indirectly identified from its methylated derivatives 10a-10d.