Uncertainty estimation of anions and cations measured by ion chromatography in fine urban ambient particles (PM2.5)

The present work presents a measurement uncertainty evaluation according to Guide to the Expression of Uncertainty in Measurement (GUM) of the concentration of the cations K⁺ and Li⁺ and anions NO₃⁻² and SO₄⁻² in fine airborne particulate matter, refers to particles less than 2.5 μm in diameter (PM_2.5), as measured by ion chromatography (US-EPA 300 method). The GUM method is not typically used to report uncertainty. In general, the analytical results only report the measurement’s standard deviation under repetition as an uncertainty; thus, not all sources of uncertainty are considered. In this work, the major sources of uncertainty regarding the measurements were identified as contributions to linear least square regression lines, repeatability, precision, and trueness. The expanded uncertainty was approximately 20% for anions and cations. The largest contribution to uncertainty was found to be repeatability.     

Dynamic-mechanical properties and melting points of some aliphatic and partially aromatic polyamides

Some aliphatic and partially aromatic polyamides have been prepared from hexamethylene diamine and the following dicarboxylic acids: deca-, octa-, hexa-methylenedicarboxylic, p-carboxymethylphenoxyacetic, p-carboxyethylphenoxyacetic, p-phenylenedipropionic, p-phenylenediacetic, p-carboxymethoxyphenoxyacetic, β(p-carboxymethyl)phenylpropionic.The dynamic-mechanical properties at 110 Hz have been measured between ?140° and about 200. Three relaxation processes α β and γ have been found: only the main transition α appreciably depends on chemical structure.The influences of the length of repeating unit and of in-chain substitution on melting points, crystallinity and the dynamic-mechanical α transition have been investigated. The results have been discussed in terms of chain flexibility, chain packing and intermolecular forces.     

Atomic Force Microscopy Study of TiO2 Films Obtained by the Sol-Gel Method

Atomic Force Microscopy (AFM) was used to study the influence of thermal treatments on the structural and textural properties of the sol-gel TiO2 films obtained from Ti(OC3H7i)4. X-ray diffraction (XRD), ellipsometric and porosity measurements have also been made.The TiO2 sol-gel films were homogeneous, transparent and amorphous. Heat treatments in the 400–600°C range indicate that the films have a strong tendency to crystallization. The high initial homogeneity of the TiO2 films was preserved during the crystallization process. AFM shows that the thermally treated films exhibit uniform, monodispersed crystals.     

Functionalized fullerenes in self-assembled monolayers

Anisotropy of intermolecular and molecule-substrate interactions holds the key to controlling the arrangement of fullerenes into 2D self-assembled monolayers (SAMs). The chemical reactivity of fullerenes allows functionalization of the carbon cages with sulfur-containing groups, thiols and thioethers, which facilitates the reliable adsorption of these molecules on gold substrates. A series of structurally related molecules, eight of which are new fullerene compounds, allows systematic investigation of the structural and functional parameters defining the geometry of fullerene SAMs. Scanning tunnelling microscopy (STM) measurements reveal that the chemical nature of the anchoring group appears to be crucial for the long-range order in fullerenes: the assembly of thiol-functionalized fullerenes is governed by strong molecule-surface interactions, which prohibit formation of ordered molecular arrays, while thioether-functionalized fullerenes, which have a weaker interaction with the surface than the thiols, form a variety of ordered 2D molecular arrays owing to noncovalent intermolecular interactions. A linear row of fullerene molecules is a recurring structural feature of the ordered SAMs, but the relative alignment and the spacing between the fullerene rows is strongly dependent on the size and shape of the spacer group linking the fullerene cage and the anchoring group. Careful control of the chemical functionality on the carbon cages enables positioning of fullerenes into at least four different packing arrangements, none of which have been observed before. Our new strategy for the controlled arrangement of fullerenes on surfaces at the molecular level will advance the development of practical applications for these nanomaterials.     

Drug resistance modulation in Staphylococcus aureus, a new biological activity for mesoionic hydrochloride compounds

Two salts of the mesoionic compounds 1,4-diphenyl-5-(5-nitro-2-furanyl)-1,3,4-thiadiazolium-2-thiol chloride (MC-1) and 4-phenyl-5-(5-nitro-2-furanyl)-1,3,4-thiadiazolium-2-phenylamine chloride (MC-2) were synthesized utilizing 1,4-diphenyl-thiosemicarbazide and 5-nitro-2-furoyl chloride as starting materials. Their structures were characterized by IR, 1H-NMR, 13C-NMR and elemental analysis. These compounds were analyzed for their influence on the effectiveness of norfloxacin, tetracycline, and erythromycin (standard antibiotics) against resistant strains of Staphylococcus aureus. MC-1 and MC-2, at sub-inhibitory concentrations of 16 μg/mL, favourably modulated the antibiotic activity of tetracycline by 16- and 32-fold, respectively (MIC), and that of erythromycin by 4-fold.     

A comparison between different techniques for the isolation of rosemary essential oil

Traditional hydrodistillation (HD), supercritical fluid extraction (SFE), organic solvent extraction (SE), and water microwave assisted hydrodistillation (MAHD) techniques were compared and evaluated for their effectiveness in the isolation of rosemary essential oil. The microwave assisted hydrodistillation technique was optimized in terms of both delivered power and time duration. The extracts/distillates were analyzed by GC and GC-MS. Microwave distillation, which exploits the physical action of microwaves on plants, showed a series of advantages over the other approaches: low cost, use of water in sample pre-treatment step, greatly reduced isolation time, and attainment of high quality essential oil distillate. Moreover, the absence of environmental impact of this innovative technique was also emphasized.     

Principi variazionali nella teoria lineare delle miscele di due solidi elastici

Riassunto In questa nota gli Autori stabiliscono dei principi variazionali che caratterizzano in maniera completa il più generale problema ai limiti sia della statica sia della dinamica di una miscela isotropa di due solidi elastici lineari. Questi principi sono del tutto generali poichè non si richiede agli stati o processi ammissibili di soddisfare ad alcuna delle equazioni di campo e delle condizioni iniziali o al contorno. Tale risultato viene ottenuto esprimendo i problemi considerati in forma operazionale.

---

Summary In this paper the Authors establish variational principles which characterize the most general boundary-value problem for statics and dynamics of an isotropic mixture of two linear elastic solids. These principles are completely general because the admissible states or processes are not required to meet any of the field equations, boundary or initial conditions and they are obtained by expressing the problems in operator form.

---

---

Il lavoro è stato eseguito nell’ambito del Gruppo Nazionale per la Fisica Matematica del C.N.R.     

Optimized determination of calcium in grape juice,wines, and other alcoholic beverages by atomic absorption spectrometry

This paper describes a study of the different methods of sample preparation for the determination of calcium in grape juice, wines, and other alcoholic beverages by flame atomic absorption spectrometry; results are also reported for the practical application of these methods to the analysis of commercial samples produced in Spain. The methods tested included dealcoholization, dry mineralization, and wet mineralization with heating by using different acids and/or mixtures of acids. The sensitivity, detection limit, accuracy, precision, and selectiviy of each method were established. Such research is necessary because of the better analytical indexes obtained after acid digestion of the sample, as recommended by the European Union, which advocates the direct method. In addition, although high-temperature mineralization with an HNO3-HCIO4 mixture gave the best analytical results, mineralization with nitric acid at 80 degrees C for 15 min gave the most satisfactory results in all cases, including those for wines with high levels of sugar and beverages with high alcoholic content. The results for table wines subjected to the latter treatment had an accuracy of 98.70-99.90%, a relative standard deviation of 2.46%, a detection limit of 19.0 microg/L, and a determination limit of 31.7 microg/L. The method was found to be sufficiently sensitive and selective. It was applied to the determination of Ca in grape juice, different types of wines, and beverages with high alcoholic content, all of which are produced and widely consumed in Spain. The values obtained for Ca were 90.00 +/- 20.40 mg/L in the grape juices, 82.30 +/- 23.80 mg/L in the white wines, 85.00 +/- 30.25 mg/L in the sweet wines, 84.92 +/- 23.11 mg/L in the red wines, 85.75 +/- 27.65 mg/L in the rosé wines, 9.51 +/- 6.65 mg/L in the brandies, 11.53 +/- 6.55 mg/L in the gin, 7.3 +/- 6.32 mg/L in the pacharán, and 8.41 +/- 4.85 mg/L in the anisettes. The method is therefore useful for routine analysis in the quality control of these beverages.     

Thermal Ethane Activation by Bare [V2O5]+ and [Nb2O5]+ Cluster Cations: on the Origin of Their Different Reactivities

The gas‐phase reactivity of [V₂O₅]⁺ and [Nb₂O₅]⁺ towards ethane has been investigated by means of mass spectrometry and density functional theory (DFT) calculations. The two metal oxides give rise to the formation of quite different reaction products; for example, the direct room‐temperature conversions C₂H₆→C₂H₅OH or C₂H₆→CH₃CHO are brought about solely by [V₂O₅]⁺. In distinct contrast, for the couple [Nb₂O₅]⁺/C₂H₆, one observes only single and double hydrogen‐atom abstraction from the hydrocarbon. DFT calculations reveal that different modes of attack in the initial phase of C?H bond activation together with quite different bond‐dissociation energies of the M?O bonds cause the rather varying reactivities of [V₂O₅]⁺ and [Nb₂O₅]⁺ towards ethane. The gas‐phase generation of acetaldehyde from ethane by bare [V₂O₅]⁺ may provide mechanistic insight in the related vanadium‐catalyzed large‐scale process.     

Computational analysis of amine-borane adducts as potential hydrogen storage materials with reversible hydrogen uptake

Amine-borane adducts are promising compounds for use in hydrogen storage applications, and the efficient catalytic release of hydrogen from these systems has been recently demonstrated. However, if hydrogen storage is to be of practical use, it is necessary that, once hydrogen has been removed from the material, it can be put back into the system to recharge the appliance. In order to develop such systems, we computationally screened a range of amine-borane adducts for their thermodynamic dehydrogenation properties. Structural trends, which lay the foundation for the possible design of amine-borane systems that exhibit reversible dihydrogen uptake, are established. We found that it is mainly the strengths of the dative bonds in both starting materials and products that govern the thermodynamic parameters of the dehydrogenation reactions. Thus, in general, electron-donating groups on nitrogen and electron-withdrawing groups on boron lead to more favorable systems. It is also possible to design promising systems whose thermodynamic parameters are a consequence of different steric strain in starting materials and products.