实验研究二维圆柱后尾流中涡脱落的有序和混沌现象

本文给出了在Re=50—400范围内二维圆柱后涡脱落的有序和混沌现象的一些初步实验结果。涡脱落由有序到混沌的转捩发生在Re=184.6—193.5之间,但是它不是通过准周期途径。在涡脱落频率与Re数的关系曲线上有两个间断。在Re=70处的间断可能对应于倾斜涡脱落模式的变化,在Re≈193.5处的第二间断对应于由有序到混沌状态的转捩。     

Determination of trace levels of diosmin in a pharmaceutical preparation by adsorptive stripping voltammetry at a glassy carbon electrode.

A systematic study on the electrochemical behavior of diosmin in Britton-Robinson buffer (pH 2.0-10.0) at a glassy carbon electrode (GCE) was made. The oxidation process of the drug was found to be quasi-reversible with an adsorption-controlled step. The adsorption stripping response was evaluated with respect to various experimental conditions, such as the pH of the supporting electrolyte, the accumulation potential and the accumulation time. The observed anodic peak current at +0.73 V vs. Ag/AgCl reference electrode increased linearly over two orders of magnitude from 5.0x10(-8) M to 9.0x10(-6) M. A limit of detection down to 3.5x10(-8) M of diosmin at the GCE was achieved with a mean recovery of 97+/-2.1%. Based on the electrochemical data, an open-circuit accumulation step in a stirred sample solution of BR at pH 3.0 was developed. The proposed method was successfully applied to the determination of the drug in pharmaceutical formulations. The results compared favorably with the data obtained via spectrophotometric and HPLC methods.     

Lateral interactions in the thermal desorption of H2 from clean Cu/Ni(110) alloy surfaces

The adsorption of hydrogen on a clean Cu10%/Ni90% (110) alloy single crystal was studied using flash desorption spectroscopy (FDS), Auger electron spectroscopy (AES), and work function measurements. Surface compositions were varied from 100% Ni to 35% Ni. The hydrogen chemisorption on a-surface of 100% nickel revealed strong attractive interactions between the hydrogen atoms in accordance with previous work on Ni(100). Three desorption states (β₁, β₂ and α) appeared in the desorption spectra. The highest temperature (α) state was occupied only after the initial population of the β₂-state. As the amount of copper was increased in the nickel substrate, desorption from the higher energy binding α-state was reduced, indicating a decrease in the attractive interactions among hydrogen atoms. The hydrogen coverage at saturation was not affected by the addition of copper to the nickel substrate until the copper concentration was greater than 25% at which a sharp reduction in saturation coverage occurred. This phenomenon was apparently due to the adsorption of hydrogen on Ni atoms followed by occupation of NiNi and CuNi bridged adsorption sites, while occupation of CuCu sites was restricted due to an energy barrier to migration.     

Three ways to implement interfacial techniques: application tomeasurements of chromatic dispersion, birefringence, and nonlinearsusceptibilities

Depending on the spectal width of the source illuminating an interferometer, measurement procedures can utilize either the whole interferogram, or only the fringe envelope, or only the fringe quick oscillations. With an ultraband spectrum source, a simplified adaptation of the methods of Fourier transform spectroscopy yields the variations of the test-fiber propagation constant over the whole wavelength-interval of the source. Chromatic dispersion can then be computed from a single interferogram. With narrower spectrum sources, only the fringe envelopes are utilized and yield measurements of mode delay, with application to chromatic and polarization mode dispersion. In this case, however, interferograms at several wavelengths are necessary. With even narrower spectrum sources, the fringe quick oscillations provide measurements of phase shifts, related to changes in the mode propagation constant, when outside perturbations are applied to the test fiber. A direct method for measuring the third-order nonlinear susceptibilities is discussed. In this case the outside perturbation is an intense pump laser field     

General formalism for the study of nonlinear pulse propagation in optical fibres

A general formalism for the study of nonlinear pulse propagation in optical fibres is presented. It is then applied to study the time evolution of a Gaussian laser pulse in a fibre with cubic and fifth-order nonlinearity in the index of refraction. The results are presented and discussed.     

Electrooptical anharmonicity parameters of the strong hydrogen bond

Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 54, No. 4, pp. 581–587, April, 1991.     

A dynamical test of phase transition order: New things in old places or old wine in new bottles

We first discuss nonlinear aspects of phase transition theory applied to a particular liquid crystal phase transition. A simple derivation is given to show how two coupled Goldstone modes (one appearing as gauge fluctuations of the ordered phase) can force a phase transition, against all expectations, to take place discontinuously (theory of Halperin, Lubensky, and Ma)-but the discontinuity may be immeasurably small. Then, we describe a new dynamical test of phase transition order, developed by Cladiset al., that turns out to be more sensitive than x-ray diffraction and adiabatic calorimetry. Quantitative data found by this new method are in excellent agreement with the measurements of adiabatic calorimetry and x-ray diffraction as well as expectations implicit in the predictions of HLM.This is the text of an after-banquet talk given at the CNLS Workshop on the Dynamics of Concentrated Systems.     

Some empirical relations for electron mobility in II–VI compound semiconductors

Electron mobility has been calculated in a number of binary II–VI compound semiconductors using a displaced Maxwellian distribution function and taking the various scattering mechanisms into consideration at different lattice temperatures and for various amounts of ionized impurity concentrations. It is observed that the low field mobility values can be expressed by a cubic power relationship with lattice temperature and with ionized impurity concentration using a least mean square fit technique with an accuracy better than 5 per cent. Similarly, the field dependence of mobility can also be expressed as a power series of the applied electric field. It is suggested that these equations can be profitably used for a quick estimation of mobility values as a check on experiments and also as sufficiently accurate formulae for simulation and modelling purposes.