A CMOS multichannel 10-Gb/s transceiver

We describe a CMOS multichannel transceiver that transmits and receives 10 Gb/s per channel over balanced copper media. The transceiver consists of two identical 10-Gb/s modules. Each module operates off a single 1.2-V supply and has a single 5-GHz phase-locked loop to supply a reference clock to two transmitter (Tx) channels and two receiver (Rx) channels. To track the input-signal phase, the Rx channel has a clock recovery unit (CRU), which uses a phase-interpolator-based timing generator and digital loop filter. The CRU can adjust the recovered clock phase with a resolution of 1.56 ps. Two sets of two-channel transceiver units were fabricated in 0.11-/spl mu/m CMOS on a single test chip. The transceiver unit size was 1.6 mm /spl times/ 2.6 mm. The Rx sensitivity was 120-mVp-p differential with a 70-ps phase margin for a common-mode voltage ranging from 0.6 to 1.0 V. The evaluated jitter tolerance curve met the OC-192 specification.     

InGaN microring light-emitting diodes

The fabrication and performance of an InGaN light-emitting diode (LED) array based on a microring device geometry is reported. This design has been adopted in order to increase the surface area for light extraction and to minimize losses due to internal reflections and reabsorption. Electrical characteristics of these devices are similar to those of a conventional large-area LED, while the directed light extraction proves to be superior. In fact, these devices are found to be more efficient when operated at higher currents. This may be attributed to improved heat sinking due to the large surface area to volume ratio. The potential applications of these devices are also discussed.     

Information outage probability of distributed STBCs over Nakagami fading channels

Space-time block codes (STBCs) allow utilising the diversity provided by multiple-input-multiple-output (MIMO) communication channels, thereby decreasing the outage probability for a given communication rate. The contribution of this letter is the derivation of a closed-form expression of the outage probability of distributed STBCs deployed over Nakagami flat fading channels with different channel gains and fading parameters.     

Analysis of feedback for higher order polarization-mode dispersion mitigation of NRZ 40-Gb/s optical transmission

First-order polarization-mode dispersion (PMD) compensation by means of a polarization controller and a differential delay line is not sufficient to guarantee error-free transmission for 40-Gb/s channels when higher order effects severely increase signal distortion. Higher order mitigation is possible by cascading more than one first-order block. However, only two-stage or three-stage devices remain simple enough to be actually controlled. The performance of such higher order PMD compensators is evaluated by means of numerical simulations. Two different feedback signals have been used, demonstrating that first-order and higher order PMD distortion of nonreturn-to-zero (NRZ) pulses at 40 Gb/s can be strongly mitigated for instantaneous values of the differential group delay (DGD) up to the bit slot, when the compensator is properly controlled.     

A novel image rejection architecture for quadrature radio receivers

In radio communications, a bandpass-to-lowpass transformation is needed to demodulate the received signal down to baseband. One crucial question in this context is how to effectively attenuate the image band signal. For this purpose, inphase/quadrature (I/Q) signal processing is widely utilized in today's radio receivers. In this paper, a novel structure for obtaining an image-free baseband observation of the received bandpass signal is presented. The starting point is to approximate the needed 90/spl deg/ phase difference between the I and Q branch signals using a simple time delay of one quarter of the carrier cycle. For narrowband signals, this approach can be used directly to attenuate the inherent "self-image". By using an interference canceller-type of compensation technique, this concept is here generalized to cover also wideband multichannel signals. Furthermore, a closed-form expression to explicitly characterize the obtainable image attenuation is derived. Efficient implementation structures for digital radios utilizing periodically nonuniform subsampling are presented, and the validity of the proposed approach is further illustrated through simulation and design examples.     

Search for high-performance probe-fed stacked patches using optimization

High-performance circular probe-fed stacked patch antenna designs are explored through the use of numerical optimization. New trends are sought to aid understanding and to suggest novel solutions. We describe the optimization technique, present a new design trend relating efficiency and bandwidth to the choice of substrate dielectric, and propose and demonstrate a novel, optimized antenna achieving 33% bandwidth whilst maintaining greater than 80% surface wave efficiency.     

Miniaturized coplanar waveguide stop band filters based on multiple tuned split ring resonators

A novel compact stop band filter consisting of a 50 /spl Omega/ coplanar waveguide (CPW) with split ring resonators (SRRs) etched in the back side of the substrate is presented. By aligning SRRs with the slots, a high inductive coupling between line and rings is achieved, with the result of a sharp and narrow rejection band in the vicinity of the resonant frequency of the rings. In order to widen the stop band of the filter, several ring pairs tuned at equally spaced frequencies within the desired gap are cascaded. The frequency response measured in the fabricated prototype device exhibits pronounced slopes at either side of the stop band and near 0 dBs insertion loss outside that band. Since SRR dimensions are much smaller than signal wavelength, the proposed filters are extremely compact and can be used to reject frequency parasitics in CPW structures by simply patterning properly tuned SRRs in the back side metal. Additional advantages are easy fabrication and compatibility with MMIC or PCB technology.     

Object segmentation and labeling by learning from examples

We propose a system that employs low-level image segmentation followed by color and two-dimensional (2-D) shape matching to automatically group those low-level segments into objects based on their similarity to a set of example object templates presented by the user. A hierarchical content tree data structure is used for each database image to store matching combinations of low-level regions as objects. The system automatically initializes the content tree with only "elementary nodes" representing homogeneous low-level regions. The "learning" phase refers to labeling of combinations of low-level regions that have resulted in successful color and/or 2-D shape matches with the example template(s). These combinations are labeled as "object nodes" in the hierarchical content tree. Once learning is performed, the speed of second-time retrieval of learned objects in the database increases significantly. The learning step can be performed off-line provided that example objects are given in the form of user interest profiles. Experimental results are presented to demonstrate the effectiveness of the proposed system with hierarchical content tree representation and learning by color and 2-D shape matching on collections of car and face images.     

Modeling of a constant Voltage transformer

This paper presents a comprehensive nonlinear model of the controlled constant voltage transformer also known as the ferroresonant transformer. Saturation is a normal mode of operation for this device. This paper derives an equivalent electrical circuit that relates to the physical structure of a typical design. The level of detail includes winding resistances, continuously nonlinear magnetizing inductances, tapped windings, and leakage inductances. The paper describes methods to extract the winding resistances, leakage inductances, and hysteresis loops of the transformer and how to fit the latter into single-valued nonlinear functions. The paper compares computer simulation results of the model with those obtained analytically and experimentally. The results show that the derived circuit will be very useful for designers of the ferroresonant transformer, which is used in uninterruptible power supplies.     

Some Insights into MIMO Mutual Information: The High SNR Case

We consider mutual information of multiple-input multiple-output (MIMO) wireless channels with complex isotropic Gaussian input in the case where the receiver has perfect channel, knowledge. For arbitrary fading statistics, a mutual information lower bound is decomposed in a sum of three terms involving: a) average SNR; b) channel fading; and c) a term characterizing the "effective rank", or eigenvalue dispersion, of the channel matrix. The decomposition suggests that spatial multiplexing efficiency of a MIMO channel can be characterized by the so-called ellipticity statistic. Distribution functions, means and variances of the random terms in the decomposition for the case of Rayleigh fading are also derived