Structural effects of multiple-bonds on aggregating tendencies of long-chain esters

The kinetics of the hydrolysis of p-nitrophenyl esters of three types of single-chain carboxylic acids, namely, saturated, olefinic and acetylenic, was investigated in two aquiorgano binary solvent systems, DMSO-H₂O and dioxane (DX)-H₂O. The ester probes used are: octanoic (C8), dodecanoic (C12) , stearic (C18) , oleic (C18-ol) , elaidic (C18-el ) and stearolic (C18-st). The order of measured CAgC values is: C18-ol>C18-el>C18>C18-st, whereas the order of decreasing magnitude of the observed hydrolytic rate constants of the monomeric species (k_m) is: C18>C18-el>C18-ol> C18-st. These rather unanticipated results are discussed.     

硫酰胺的快速分析（Ⅱ） 

硫酰胺生产过程中副产的大量氯化铵要干扰硫酰胺的测定，采用四苯硼钠将全部氯化铵呈沉淀析出，再用次溴酸钠把滤液中的硫酰胺分解成氮气，测其体积，计算出硫酰胺的含量。对样品进行测定的结果表明，该法重现性好、准确度高、分析周期在３５ｍｉｎ内，相对误差在±１％以内。     

一种便于观测的信号抽样及复原方法

利用倍频器，将重复频率与连续信号ｔ（ｔ）的频率相同的方波进行若干次倍频后，对连续信号进行抽样，从而获得离散的抽样信号ｆｓ（ｔ），再利用有源低通滤波器使其复原成连续信号ｆ（ｔ）。避免了一般抽样器不便于观测的缺点。     

Theoretical study on gain and tuning characteristics of infrared-microwave pumped NH3 FIR laser

Based on the semi-classical density matrix equation theory, the gain and tuning characteristics of infrared-microwave pumped NH₃ FIR laser were studied. It was shown that quasi-continuously tuning could be obtained by the tuning of microwave frequency and the efficiency of the laser could be enhanced by electric dipole transition enhancement effect, but compromise should be made between FIR laser output and frequency tuning range.     

BIFURCATION DIAGRAMS OF SYSTEM =-y δx lx~2 ny~2,=x ax~2

Ｗｅｃｏｎｓｉｄｅｒｔｈｅｑｕａｄｒａｔｉｃｓｙｓｔｅｍｏｆｔｙｐｅ（Ｉ）ｍ＝０ａｃｏｒｄｉｎｇｔｏｔｈｅｃｌａｓｉｆｉｃａｔｉｏｎｏｆ［１］．Ｗｉｔｈｏｕｔｌｏｓｏｆｇｅｎｅｒａｌｉｔｙ，ｗｅｍａｙａｓｕｍｅｔｈａｔｔｈｅｓｙｓｔｅｍｉｓｔａｋｅｎ...     

InGaAsP/InP有源双稳放大器的实验研究

本文报导了室温下F—P型InGaAsP/InP双异质结半导体激光放大器的双稳态效应,放大器的增益为20dB。     

B—ISDN宽带UNI信令点到多点配置的实现

本文根据ＩＴＵ－Ｔ最新的Ｑ．２９７１协议，以及笔者所从事的实际课题，提出一整套Ｂ－ＩＳＤＮ第三层ＵＮＩ信令的软件实现策略，其特点是能同时满足用户对点到点以及点到多点广播这两种通信方式的要求，而且可以动态配置。     

Selective area epitaxy of CdTe

We have performed selective area epitaxy (SAE) of CdTe layers grown by molecular beam epitaxy using a shadow mask technique. This technique was chosen over other SAE techniques due to its simplicity and its compatibility with multiple SAE patterning steps. Features as small as 50 microns × 50 microns were obtained with sharp, abrupt side walls and flat mesa tops. Separations between mesas as small as 20 microns were also obtained. Shadowing effects due to the finite thickness of the mask were reduced by placing the CdTe source in a near normal incidence position. Intimate contact between the mask and the substrate was essential in order to achieve good pattern definition.     

In situ observation of NaBi(WO4)2 dendrite growth and the study on microstructure of solidification

The dendrite growth process of transparent NaBi(WO₄)₂ with small prandtl and high melting point was studied by using the in-situ observation system. According to the dynamic images and detailed information, there are two kinds of restriction effect on the dendrite growth, the competition between arms and branches and the convection in the melt. The dendrite growth rate was time dependent, and the rate of arm growth reached the maximum 5.8 mm/s in the diffusive-advective region and rapidly decreased in the diffusive-convective region. The growth rate of branch had the same change trends as the arm’s. Based on the EPMA-EDS data of solidification structure of quenched NaBi(WO₄)₂ melt, it was found that there were component differences from stoichiometric concentration in the melt near the interface during the growth process. Supported by the National Natural Science Foundation of China (Grant No. 50331040) and the Innovation Funds from Shanghai Institute of Ceramics, Chinese Academy of Sciences (Grant No. SCX0623)     

Simplified analytic solutions and a novel fast algorithm for Yb-doped double-clad fiber lasers

In this paper, continuous wave Yb³⁺-doped double-clad fiber lasers (DCFLs) with linear-cavity are investigated theoretically and numerically using the rate equations. Under the steady state conditions, the simplified analytic solutions of Yb³⁺-doped DCFLs under considering the scattering loss are deduced in the strongly pump condition. Compared with the known analytic solutions in published literatures, our analytic solutions are more accurate, especially, at higher reflectivity of output mirror. In addition, a fast and stable algorithm based on the Newton-Raphson method is proposed to simulate numerically Yb³⁺-doped DCFLs. The results by simplified analytic solutions are in good agreement with those by the numerical simulation. Moreover, we have performed the optimization of an Yb³⁺-doped DCFL using the simplified analytic solutions and the numerical simulations, respectively.