ADIC iPlatform智能磁带库体系结构

本文介绍了ADIC iPlatform智能磁带库体系结构。     

Flash器件中氧化硅/氮化硅/氧化硅的特性

对普遍采用的氧化硅/氮化硅/氧化硅( ONO)三层复合结构介质层的制备工艺及特性进行了研究分析,研究了ONO的漏电特性以及顶氧( top oxide)和底氧( bottom oxide)的厚度对ONO层漏电的影响.结果表明,采用较薄的底氧和较厚的顶氧,既能保证较高的临界电场强度,又能获得较薄的等效氧化层厚度,提高耦合率,降低编程电压.     

Personal telecommunication radiation safety and the precautionary principle

The approach to risk management for RF and microwave radiation has been to establish guidelines for maximum permissible levels of exposure. These guidelines are based on evaluations of the relevant scientific literature and, with safety margins to account for uncertainties and gaps in scientific knowledge, offer a significant level of protection against established hazards of RF and microwave radiation for short-term exposures. One can argue, on this basis, that the precautionary principle - specifically, safety factors -have been used to guide the making and promulgation of existing permissible-exposure standards for RF and microwave radiation. Therefore, discussions on the appropriateness of the precautionary principle for RF radiation may be "much ado about nothing". Clearly, this approach to "pre caution" neither has stifled technological development, nor has it helped to enforce the acceptance of zero risk, but it provided a basis for action when science was unable to give a clear answer.     

Graph-theoretic construction of low-density parity-check codes

This article presents a graph-theoretic method for constructing low-density parity-check (LDPC) codes from connected graphs without the requirement of large girth. This method is based on finding a set of paths in a connected graph, which satisfies the constraint that any two paths in the set are either disjoint or cross each other at one and only one vertex. Two trellis-based algorithms for finding these paths are devised. Good LDPC codes of practical lengths are constructed and they perform well with iterative decoding.     

GaN-MOCVD设备反应室流场的CFD数值仿真

采用计算流体力学方法对生长半导体材料GaN的重要设备MOCVD(金属有机物化学气相沉积)反应室中的流场结构进行了三维数值仿真.数值模拟采用基于非交错网格系统的SIMPLE算法,用有限体积方法对控制方程进行离散,并采用改进的压力-速度耦合方法进行求解.数值仿真给出了具有复杂几何结构和运动方式的GaN-MOCVD反应室中的流场结构,研究了改变几何尺寸和运行参数对MOCVD反应室流场结构的影响,对正在试制开发中的MOCVD设备的几何结构的改进和运行参数的优化提出了指导性建议.     

计费帐务系统发展趋势分析

计费帐务系统作为业务运营支撑系统的重要组成部分。其发展方向日益受到运营商的关注。通过对计量帐务系统的研究，首先介绍了传统计费模式的现状以及存在的问题，然后结合各大公司产品对计责帐务系统的关键技术进行了分析，最后提出未来计费帐务系统的特征及对其发展趋势的展望。     

Temperature effects on surface activity and application in oxidation of toluene derivatives of CTAB-SDS with KMnO4

The γ_cmc values of CTAB-SDS decrease from 63.67 mN/m at 10‡C to 36.38 mN/m at 90‡C, slightly lower than those of either CTAB or SDS. Correspondingly, the CMC of CTAB-SDS decreases almost by half. The increase of surface activity of CTAB-SDS can be attributed to the relatively weak electrostatic interaction at high temperature, which is supported by the increase of solubility of CTAB-SDS with rise in temperature. Catalytic effect on oxidation of toluene derivatives with potassium permanganate follows the order CTAB-SDS > SDS > CTAB. This is not caused by the dissociative effect of CTAB-SDS with low surface activity at low temperature, as seen from the fact that almost all oxidative products can be retrieved for different toluene derivatives and surfactants by mimicking the conditions of reaction. In the emulsifications of toluene derivatives at 90‡C, the time that turbid water layers of surfactant solutions take to become clear is the same as that of the catalytic effect on oxidation of toluene derivatives. Thus, it can be inferred that surfactants can improve the oxidation yields of toluene derivatives by increasing the contact between two reacting phases.     

An Efficient Selective Oxidation of Alcohols with Potassium Permanganate Adsorbed on Aluminum Silicate under Solvent-free Conditions and Shaking

A new procedure for the selective oxidation of alcohols to the corresponding aldehydes and ketones with potassium permanganate supported on aluminum silicate at room temperature under solvent-free conditions and shaking is reported.     

Profile-Driven Component Placement for Cluster-Based Online Services

The growth of the Internet and of various intranets has spawned a wealth of online services, most of which are implemented on local-area clusters using remote invocation (for example, remote procedure call/remote method invocation) among manually placed application components. Component placement can be a significant challenge for large-scale services, particularly when application resource needs are workload dependent. Automatic component placement has the potential to maximize overall system throughput. The key idea is to construct (offline) a mapping between input workload and individual-component resource consumption. Such mappings, called component profiles, then support high-performance placement. Preliminary results on an online auction benchmark based on J2EE (Java 2 Platform, Enterprise Edition) suggest that profile-driven tools can identify placements that achieve near-optimal overall throughput.     

提高托盘利用效率的重要手段——电子信息化管理

托盘能否有效运用对物流的畅通与否关系重大,这已经引起了国内外专家和学者们的重视,并就此制定了托盘电子信息化管理系统,旨在更合理地使用托盘,推进托盘一体化和共用系统的建立。而RFID技术在托盘的电子信息化管理的应用更将大大提高物流的效率与准确性,托盘电子信息化管理将成为今后托盘管理的趋势。